- 您現在的位置：買賣IC網 > PDF目錄30770 > LTC3614EUDD#PBF (LINEAR TECHNOLOGY CORP) 10.5 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC24 PDF資料下載
參數資料
| 型號： | LTC3614EUDD#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 10.5 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PQCC24 |
| 封裝： | 3 X 5 MM, LEAD FREE, PLASTIC, QFN-24 |
| 文件頁數： | 25/30頁 |
| 文件大小： | 438K |
| 代理商： | LTC3614EUDD#PBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁
LTC3614
4
3614fa
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: The LTC3614 is tested under pulsed load conditions such that
TJ ≈ TA. The LTC3614E is guaranteed to meet specications from
0°C to 85°C junction temperature. Specications over the –40°C to
125°C operating junction temperature range are assured by design,
characterization and correlation with statistical process controls. The
LTC3614I is guaranteed to meet specications over the full –40°C to 125°C
operating junction temperature. The junction temperature (TJ) is calculated
from the ambient temperature (TA) and power dissipation (PD) according
to the formula: TJ = TA + (PD θJA°C/W), where θJA is the package thermal
impedance. The maximum ambient temperature is determined by specic
operating conditions in conjunction with board layout, the rated package
thermal resistance and other environmental factors.
Note 3: This parameter is tested in a feedback loop which servos VFB to
the midpoint for the error amplier (VITH = 0.75V).
ELECTRICAL CHARACTERISTICS The l denotes the specications which apply over the full operating junction
temperature range, otherwise specications are at TA = 25°C. VIN = 3.3V, RT/SYNC = SVIN unless otherwise specied (Notes 1, 2, 11).
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
PGOOD
Power Good Voltage Windows
TRACK/SS = SVIN, Entering Window
VFB Ramping Up
VFB Ramping Down
–3
3
–6
6
%
TRACK/SS = SVIN, Leaving Window
VFB Ramping Up
VFB Ramping Down
9
–9
11
–11
%
tPGOOD
Power Good Blanking Time
Entering and Leaving Window
70
105
140
μs
RPGOOD
Power Good Pull-Down On-Resistance
8
17
33
Ω
VRUN
RUN voltage
Input High
Input Low
l
1
0.4
V
Note 4: External compensation on ITH pin.
Note 5: Tying the ITH pin to SVIN enables the internal compensation and
AVP mode.
Note 6: Dynamic supply current is higher due to the internal gate charge
being delivered at the switching frequency.
Note 7: See description of the TRACK/SS pin in the Pin Functions section.
Note 8: In sourcing mode the average output current is owing out of the
SW pin. In sinking mode the average output current is owing into the SW
Pin.
Note 9: See description of the MODE pin in the Pin Functions section.
Note 10: Guaranteed by correlation and design to wafer level
measurements for QFN packages.
Note 11: This IC includes overtemperature protection that is intended
to protect the device during momentary overload conditions. Junction
temperature will exceed 125°C when overtemperature protection is active.
Continuous operation above the specied maximum operating junction
temperature may impair device reliability.
TYPICAL PERFORMANCE CHARACTERISTICS V
IN = 3.3V, RT/SYNC = SVIN unless otherwise noted.
Efciency vs Load Current
Burst Mode Operation (VMODE = 0V)
Efciency vs Load Current
Burst Mode Operation (VMODE = 0V)
Efciency vs Load Current
OUTPUT CURRENT (mA)
30
EFFICIENCY
(%)
90
100
20
10
80
50
70
60
40
1
100
1000
10000
3614 G01
0
10
VIN = 2.5V
VIN = 3.3V
VIN = 5V
VOUT = 1.8V
OUTPUT CURRENT (mA)
30
EFFICIENCY
(%)
90
100
20
10
80
50
70
60
40
1
100
1000
10000
3614 G02
0
10
VIN = 2.5V
VIN = 3.3V
VIN = 5V
VOUT = 1.2V
OUTPUT CURRENT (mA)
30
EFFICIENCY
(%)
90
100
20
10
80
50
70
60
40
1
100
1000
10000
3614 G03
0
10
Burst Mode OPERATION
PULSE-SKIPPING
FORCED CONTINUOUS
VOUT = 1.8V
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3615EFE-1#TRPBF | SWITCHING REGULATOR, PDSO24 |
| LTC3615IUF-1#PBF | SWITCHING REGULATOR, PQCC24 |
| LTC3615EUF#PBF | SWITCHING REGULATOR, PQCC24 |
| LTC3615EFE#PBF | SWITCHING REGULATOR, PDSO24 |
| LTC3615IFE-1#PBF | SWITCHING REGULATOR, PDSO24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3614IUDD#PBF | 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LTC3614IUDD#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LTC3614MPUDD#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN |
| LTC3614MPUDD#TRPBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 4A 24QFN |
| LTC3615EFE#PBF | 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
發布緊急采購，3分鐘左右您將得到回復。