- 您現在的位置：買賣IC網 > PDF目錄98003 > LTC3586EUFE-1#TRPBF (LINEAR TECHNOLOGY CORP) BATTERY CHARGE CONTROLLER, PQCC38 PDF資料下載
參數資料
| 型號： | LTC3586EUFE-1#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | BATTERY CHARGE CONTROLLER, PQCC38 |
| 封裝： | 4 X 6 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, QFN-38 |
| 文件頁數： | 6/36頁 |
| 文件大?。?/td> | 317K |
| 代理商： | LTC3586EUFE-1#TRPBF |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
LTC3586/LTC3586-1
14
3586fa
OPERATION
Introduction
The LTC3586/LTC3586-1 are highly integrated power
management ICs which include a high efciency switch
mode PowerPath controller, a battery charger, an ideal
diode, an always-on LDO, two 400mA buck switching
regulators, a 1A buck-boost switching regulator, and an
800mA boost switching regulator. All of the regulators can
be independently controlled via ENABLE pins.
Designed specically for USB applications, the PowerPath
controller incorporates a precision average input current
buck switching regulator to make maximum use of the
allowable USB power. Because power is conserved, the
LTC3586/LTC3586-1 allow the load current on VOUT to
exceed the current drawn by the USB port without exceed-
ing the USB load specications.
The PowerPath switching regulator and battery charger
communicate to ensure that the input current never violates
the USB specications.
The ideal diode from BAT to VOUT guarantees that ample
power is always available to VOUTevenifthereisinsufcient
or absent power at VBUS.
An always-on LDO provides a regulated 3.3V from avail-
able power at VOUT. Drawing very little quiescent current,
this LDO will be on at all times and can be used to supply
up to 20mA.
Along with constant frequency PWM mode, the buck and
the buck-boost switching regulators have a low power
burst mode setting for signicantly reduced quiescent
current under light load conditions.
High Efciency Switching PowerPath Controller
Whenever VBUS is available and the PowerPath switch-
ing regulator is enabled, power is delivered from VBUS to
VOUT via SW. VOUT drives the combination of the external
load (including switching regulators 1, 2, 3 and 4) and
the battery charger.
If the combined load does not exceed the PowerPath
switching regulator’s programmed input current limit, VOUT
will track 0.3V above the battery (Bat-Track). By keeping
the voltage across the battery charger low, efciency is
optimized because power lost to the linear battery char-
ger is minimized. Power available to the external load is
therefore optimized.
If the combined load at VOUT is large enough to cause the
switching PowerPath supply to reach the programmed
input current limit, the battery charger will reduce its
charge current by that amount necessary to enable the
external load to be satised. Even if the battery charge
current is set to exceed the allowable USB current, the USB
specication will not be violated. The PowerPath switch-
ing regulator will limit the average input current so that
the USB specication is never violated. Furthermore, load
current at VOUT will always be prioritized and only excess
available power will be used to charge the battery.
If the voltage at BAT is below 3.3V, or the battery is not
present, and the load requirement does not cause the
PowerPath switching regulator to exceed the USB
specication, VOUT will regulate at 3.6V, as shown in
Figure 1. This “instant-on” feature will allow a portable
product to run immediately when power is applied without
waiting for the battery to charge. If the load exceeds the
current limit at VBUS, VOUT will range between the no-load
voltage and slightly below the battery voltage, indicated
by the shaded region of Figure 1.
For very low-battery voltages, the battery charger acts like
a load and, due to limited input power, its current will tend
to pull VOUTbelowthe3.6V“instant-on”voltage.Toprevent
VOUT from falling below this level, an undervoltage circuit
automatically detects that VOUT is falling and reduces the
battery charge as needed. This reduction ensures that load
current and output voltages are always priortized while
allowing as much battery charge current as possible. See
Over-Programming the Battery Charger in Applications
Information Section.
The power delivered from VBUS to VOUT is controlled by a
2.25MHz constant-frequency buck switching regulator. To
meet the USB maximum load specication, the switching
regulator includes a control loop which ensures that the
average input current is below the level programmed at
CLPROG.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3672BEDC-1#PBF | 1.1 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3728LZEUH | 3 A DUAL SWITCHING CONTROLLER, 590 kHz SWITCHING FREQ-MAX, PQCC28 |
| LTC3773EUHF | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PQCC38 |
| LTC3773EG | SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO36 |
| LTC3801ES6#PBF | 1 A SWITCHING CONTROLLER, 650 kHz SWITCHING FREQ-MAX, PDSO6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3586EUFE-2#PBF | 功能描述:IC USB POWER MANAGER HE 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:Bat-Track™, PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3586EUFE-2#TRPBF | 功能描述:IC USB POWER MANAGER HE 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:Bat-Track™, PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3586EUFE-3#PBF | 功能描述:IC USB POWER MANAGER HE 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:Bat-Track™, PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3586EUFE-3#TRPBF | 功能描述:IC USB POWER MANAGER HE 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:Bat-Track™, PowerPath™ 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR |
| LTC3586EUFE-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Effi ciency USB Power Manager with Boost, Buck-Boost and Dual Bucks |
發布緊急采購，3分鐘左右您將得到回復。