- 您現在的位置：買賣IC網 > PDF目錄98003 > LTC3525LESC6-3#PBF (LINEAR TECHNOLOGY CORP) 0.45 A SWITCHING REGULATOR, PDSO6 PDF資料下載
參數資料
| 型號： | LTC3525LESC6-3#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.45 A SWITCHING REGULATOR, PDSO6 |
| 封裝： | LEAD FREE, PLASTIC, EIAJ, MO-203AB, SC-70, 6 PIN |
| 文件頁數： | 11/12頁 |
| 文件大小： | 487K |
| 代理商： | LTC3525LESC6-3#PBF |
LTC3525L-3
8
3525lfa
The maximum average load current that can be supported
is given by:
IO MAX
(
) =
0.3 VIN η
VO
Amps
where
η is the efficiency (see Typical Performance Char-
acteristics).
The “burst” frequency (how often the LTC3525L-3 deliv-
ers a burst of current pulses to the load) is determined
by the internal hysteresis (output voltage ripple), the load
current and the amount of output capacitance. All Burst
Mode operation or hysteretic converters will enter the
audible frequency range when the load is light enough.
However, due to the low peak inductor current at light load,
circuits using the LTC3525L-3 do not typically generate
audible noise.
Component Selection
Inductor values between 4.7H and 15H are recom-
mended. In most applications 10H will yield the best
compromise between size and efficiency. The inductor
should be a low-loss ferrite design and must be rated
for peak currents of at least 400mA without saturating.
InductorswithlowerDCresistancewillimproveefficiency.
Note that the inductor value does not have a significant
effect on ripple current, so while lower values will increase
the operating frequency, they do not reduce output volt-
age ripple.
Some recommended inductor examples are Murata
LQH32C, Coilcraft LPO4812, LPO3310, DO3314, DS1608
and MSS4020, Sumida CDRH2D14 and Taiyo Yuden
NR3015T.
A ceramic input bypass capacitor should be located as
close as possible to the VIN and GND pins of the IC. A
minimum value of 1F is recommended. If the battery is
more than a few inches away, a bulk tantalum decoupling
cap of at least 10F is recommended on VIN.
Theoutputcapacitorshouldalsobeaceramic,locatedclose
to the VOUT and GND pins. A minimum value of 10F is
recommended.Increasingthevalueoftheoutputcapacitor
to 22F will result in lower output ripple. Higher capacitor
values will only offer a small reduction in output ripple,
while reducing light load efficiency by causing the peak
inductor current to increase above its minimum value of
150mA. The input and output capacitors should be X5R
or X7R types, not Y5V.
OPERATION
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3526LEDC | SWITCHING CONTROLLER, 1250 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3531ES6-3.3#PBF | 0.46 A SWITCHING REGULATOR, PDSO6 |
| LTC3538EDCB#TRM | 0.8 A SWITCHING REGULATOR, 1200 kHz SWITCHING FREQ-MAX, PDSO8 |
| LTC3542IS6#PBF | SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3559EUD | 1.05 A BATTERY CHARGE CONTROLLER, 2590 kHz SWITCHING FREQ-MAX, PQCC16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC3526 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:500mA 1MHz Synchronous Step-Up DC/DC Converters in 2mm × 2mm DFN |
| LTC3526-2 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:500mA 2MHz Synchronous Step-Up DC/DC Converters in 2mm × 2mm DFN |
| LTC3526B | 制造商:LINER 制造商全稱:Linear Technology 功能描述:500mA 1MHz Synchronous Step-Up DC/DC Converters in 2mm × 2mm DFN |
| LTC3526B-2 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:500mA 2MHz Synchronous Step-Up DC/DC Converters in 2mm × 2mm DFN |
| LTC3526BEDC | 制造商:LINER 制造商全稱:Linear Technology 功能描述:500mA 1MHz Synchronous Step-Up DC/DC Converters in 2mm X 2mm DFN |
發布緊急采購，3分鐘左右您將得到回復。