- 您現在的位置：買賣IC網 > PDF目錄10286 > LTC2411IMS#TRPBF (Linear Technology)IC A/D CONV 24BIT MICRPWR 10MSOP PDF資料下載
參數資料
| 型號： | LTC2411IMS#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 30/40頁 |
| 文件大小： | 0K |
| 描述： | IC A/D CONV 24BIT MICRPWR 10MSOP |
| 標準包裝： | 2,500 |
| 位數： | 24 |
| 采樣率（每秒）： | 7.5 |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 1mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-MSOP |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個差分，雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
LTC2411/LTC2411-1
36
bridge output can be eliminated completely; if the refer-
ence arm of the bridge is used as the reference to the ADC,
as shown in Figure 43. The LTC2411/LTC2411-1 can
accept inputs up to 1/2 VREF. Hence, the reference resistor
R1 must be at least 2
× the highest value of the variable
resistor.
In the case of 100
platinum RTD’s, this would suggest a
value of 800
for R1. Such a low value for R1 is not
advisable due to self-heating effects. A value of 25.5k is
shown for R1, reducing self-heating effects to acceptable
levels for most sensors.
The basic circuit shown in Figure 43 shows connections
for a full 4-wire connection to the sensor, which may be
located remotely. The differential input connections will
reject induced or coupled 60Hz interference, however, the
reference inputs do not have the same rejection. If 60Hz or
other noise is present on the RTD, a low pass filter is
recommended as shown in Figure 44. Note that you
cannot place a large capacitor directly at the junction of R1
and R2, as it will store charge from the sampling process.
A better approach is to produce a low pass filter decoupled
from the input lines with a high value resistor (R3).
The use of a third resistor in the half bridge, between the
variable and fixed elements gives essentially the same
result as the two resistor version, but has a few benefits.
If, for example, a 25k reference resistor is used to set the
excitation current with a 100
RTD, the negative
reference input is sampling the same external node as the
positive input, but may result in errors if used with a long
cable. For short cable applications, the errors may be
acceptably low. If instead the single 25k resistor is
replaced with a 10k 5% and a 10k 0.1% reference
resistor, the noise level introduced at the reference, at
least at higher frequencies, will be reduced. A filter can be
introduced into the network, in the form of one or more
capacitors, or ferrite beads, as long as the sampling
pulses are not translated into an error. The reference
voltage is also reduced, but this is not undesirable, as it
will decrease the value of the LSB, although, not the input
referred noise level.
The circuit shown in Figure 44 shows a more rigorous
example of Figure 43, with increased noise suppression
and more protection for remote applications.
Figure 45 shows an example of gain in the excitation circuit
and remote feedback from the bridge. The LTC1043s
provide voltage multiplication, providing
±10V from a 5V
reference with only 1ppm error. The amplifiers are used at
unity-gain and, hence, introduce a very little error due to
APPLICATIO S I FOR ATIO
WU
UU
Figure 44. Remote Half Bridge Sensing with Noise Suppression on Reference
REF+
REF–
IN–
GND
VCC
5V
2
3
5
2411 F44
6
1
–
+
LTC1050
5V
PLATINUM
100
RTD
560
R3
10k
5%
R1
10k, 5%
R2
10k
0.1%
1
F
IN+
4
10k
4
3
2
1
LTC2411/
LTC2411-1
相關PDF資料 |
PDF描述 |
|---|---|
| MS27472E8F35PA | CONN RCPT 6POS WALL MNT W/PINS |
| MS27467T11F98PA | CONN PLUG 6POS STRAIGHT W/PINS |
| MS27473E10B35PB | CONN PLUG 13POS STRAIGHT W/PINS |
| VI-J3J-MX-S | CONVERTER MOD DC/DC 36V 75W |
| MS27472T20A16P | CONN RCPT 16POS WALL MT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2412CGN | 功能描述:IC ADC 2CH DIFF-IN 24BIT 16SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2412CGN#PBF | 功能描述:IC ADC 2CH DIFF-IN 24BIT 16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2412CGN#PBF | 制造商:Linear Technology 功能描述:IC, ADC, 24BIT, SSOP-16 |
| LTC2412CGN#TR | 功能描述:IC CONV A/D 24B 2CH DIFF 16-SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2412CGN#TRPBF | 功能描述:IC ADC 2CH DIFF-IN 24BIT 16SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
發布緊急采購，3分鐘左右您將得到回復。