參數資料
型號： LTC2411-1IMS#TRPBF
廠商： Linear Technology
文件頁數： 24/40頁
文件大?。?/td> 0K
描述： IC A/DCONV DIFF INPUT&REF 10MSOP
標準包裝： 2,500
位數： 24
采樣率（每秒）： 6.8
數據接口： MICROWIRE?，串行，SPI?
轉換器數目： 2
功率耗散（最大）： 1mW
電壓電源： 單電源
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 10-TFSOP，10-MSOP（0.118"，3.00mm 寬）
供應商設備封裝： 10-MSOP
包裝： 帶卷 (TR)
輸入數目和類型： 1 個差分，雙極
LTC2411/LTC2411-1
30
internal calibration and filtering. The noise of the driving
amplifier referred to the converter input and including all
these effects can be calculated as N = ni √freqi. The total
system noise (referred to the LTC2411/LTC2411-1 input)
can now be obtained by summing as square root of sum
of squares the three ADC input referred noise sources: the
LTC2411/LTC2411-1 internal noise (1.45
V), the noise of
the IN+ driving amplifier and the noise of the IN– driving
amplifier.
If the FO pin is driven by an external oscillator of frequency
fEOSC, Figure 29 can still be used for noise calculation if the
x-axis is scaled by fEOSC/153600. For large values of the
ratio fEOSC/153600, the Figure 29 plot accuracy begins to
decrease, but in the same time the LTC2411/LTC2411-1
noise floor rises and the noise contribution of the driving
amplifiers lose significance.
Normal Mode Rejection and Antialiasing
One of the advantages delta-sigma ADCs offer over con-
ventional ADCs is on-chip digital filtering. Combined with
a large oversampling ratio, the LTC2411/LTC2411-1 sig-
nificantly simplifies antialiasing filter requirements.
The sinc4 digital filter provides greater than 120dB normal
mode rejection at all frequencies except DC and integer
multiples of the modulator sampling frequency (fS). The
LTC2411/LTC2411-1’s autocalibration circuits further sim-
plify the antialiasing requirements by additional normal
mode signal filtering both in the analog and digital domain.
Independent of the operating mode, fS = 256 fN = 2048
fOUTMAX where fN is the notch frequency and fOUTMAX is
the maximum output data rate. In the internal oscillator
mode, for the LTC2411, FS = 12800Hz with a 50Hz notch
setting and fS = 15360Hz with a 60Hz notch setting. For the
LTC2411-1, fS = 13980Hz (FO = LOW). In the external
oscillator mode, fS = fEOSC/10.
The combined normal mode rejection performance is
shown in Figure 30 for the internal oscillator with 50Hz
notch setting (FO = HIGH) and in Figure 31 for the internal
oscillator with FO = LOW and for the external oscillator
mode. The regions of low rejection occurring at integer
multiples of fS have a very narrow bandwidth. Magnified
details of the normal mode rejection curves are shown in
APPLICATIO S I FOR ATIO
WU
UU
DIFFERENTIAL INPUT SIGNAL FREQUENCY (Hz)
0fS 2fS 3fS 4fS 5fS 6fS 7fS 8fS 9fS10fS11fS12fS
INPUT
NORMAL
MODE
REJECTION
(dB)
2411 F30
0
–10
–20
–30
–40
–50
–60
–70
–80
–90
–100
–110
–120
FO = HIGH
FO = LOW OR
FO = EXTERNAL OSCILLATOR,
fEOSC = 10 fS
DIFFERENTIAL INPUT SIGNAL FREQUENCY (Hz)
0fS
INPUT
NORMAL
MODE
REJECTION
(dB)
2411 F31
0
–10
–20
–30
–40
–50
–60
–70
–80
–90
–100
–110
–120
2fS 3fS 4fS 5fS 6fS 7fS 8fS 9fS 10fS
Figure 30. Input Normal Mode Rejection,
Internal Oscillator and 50Hz Notch (LTC2411)
Figure 31. Input Normal Mode Rejection, Internal
Oscillator and FO = LOW or External Oscillator
INPUT NOISE SOURCE SINGLE POLE
EQUIVALENT BANDWIDTH (Hz)
1
INPUT
REFERRED
NOISE
EQUIVALENT
BANDWIDTH
(Hz)
10
100
1000
10
100
1k
10k 100k
1M
2411 G29
0.1
1
FO = LOW
FO = HIGH
Figure 29. Input Referred Noise Equivalent Bandwidth
of an Input Connected White Noise Source
相關PDF資料
PDF描述
LTC2418IGN#TRPBF IC ADC 24BIT DIFF INPUT 28SSOP
LTC2431IMS#TRPBF IC ADC 20BIT DIFFINPUT/REF10MSOP
LTC2433-1IMS#TRPBF IC ADC DIFF 16BIT 3WIRE 10-MSOP
LTC2435CGN#TRPBF IC ADC DIFF I/REF 20BIT 16-SSOP
LTC2442IG#PBF IC ADC 24BIT 4CH 36-SSOP
相關代理商/技術參數
參數描述
LTC2411CMS 功能描述:IC A/D CONV 24BIT MICRPWR 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2411CMS#PBF 功能描述:IC A/D CONV 24BIT MICRPWR 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC2411CMS#TR 功能描述:IC A/D CONV 24BIT MICRPWR 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2411CMS#TRPBF 功能描述:IC A/D CONV 24BIT MICRPWR 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
LTC2411IMS 功能描述:IC A/D CONV 24BIT MICRPWR 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*