- 您現在的位置：買賣IC網 > PDF目錄10364 > LTC2360IS6#TRPBF (Linear Technology)IC ADC 12BIT 100KSPS TSOT23-6 PDF資料下載
參數資料
| 型號： | LTC2360IS6#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 6/20頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT 100KSPS TSOT23-6 |
| 標準包裝： | 2,500 |
| 位數： | 12 |
| 采樣率（每秒）： | 100k |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 3.6mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-6 細型，TSOT-23-6 |
| 供應商設備封裝： | TSOT-23-6 |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個單端，單極 |
| 配用： | DC1190A-E-ND - BOARD SAR ADC LTC2360 |
LTC2360/LTC2361/LTC2362
14
236012fa
APPLICATIONS INFORMATION
OVERVIEW
The LTC2360/LTC2361/LTC2362 use a successive ap-
proximation algorithm and internal sample-and-hold circuit
to convert an analog signal to a 12-bit serial output. All
devices operate from a single 2.35V to 3.6V supply. The
conversion time of the devices is controlled by an internal
oscillator, which allows the LTC2360/LTC2361/LTC2362
to sample at a rate of 100ksps, 250ksps and 500ksps
respectively.
The LTC2360/LTC2361/LTC2362 contain a 12-bit, switched-
capacitor ADC, a sample-and-hold, a serial interface (see
Block Diagram) and are available in tiny 6- or 8-lead
TSOT-23 packages.
The S6 package of the LTC2360/LTC2361/LTC2362 uses
VDD as the reference and has an analog input range of 0V
to VDD. The ADC samples the analog input with respect to
GND and outputs the result through the serial interface.
The TS8 package provides two additional pins: a reference
pin, VREF, and an output supply pin, OVDD. The ADC can
operate with reduced spans down to 1.4V and achieve
342μV resolution. OVDD controls the output swing of the
digital output pin, SDO, and allows the device to com-
municate with 1.8V, 2.5V or 3V digital systems.
SERIAL INTERFACE
The LTC2360/LTC2361/LTC2362 communicate with micro-
controllers, DSPs and other external circuitry via a 3-wire
interface. Figure 10 shows the operating sequence of the
serial interface.
Data Transfer
A rising CONV edge starts a conversion and disables SDO.
After the conversion, the ADC automatically goes into sleep
mode, drawing only leakage current.
CONV going low enables SDO and clocks out the MSB bit,
B11. SCK then synchronizes the data transfer with each
bit being transmitted on the falling SCK edge and can be
captured on the rising SCK edge. After completing the
data transfer, if further SCK clocks are applied with CONV
low, SDO will output zeros indenitely (see Figure 10). For
example, 16-clocks at SCK will produce the 12-bit data
and four trailing zeros on SDO.
SLEEP MODE
The LTC2360/LTC2361/LTC2362 enter sleep mode to save
power after each conversion if CONV remains high. In sleep
mode, all bias currents are shut down and only leakage
currents remain (about 0.1μA). The sample-and-hold is
in hold mode while the ADC is in sleep mode. The ADC
returns to sample mode after the falling edge of CONV
during power-up (see Figure 10).
Exiting Sleep Mode and Power-Up Time
By taking CONV low, the ADC powers up and acquires an
input signal completely after the aquisition time (tACQ).
After tACQ, the ADC can perform a conversion as described
in the Serial Interface section (see Figure 10).
1
RECOMMENDED HIGH OR LOW
Hi-Z STATE
234
t6
t5
t4
t7
t8
236012 F10
t3
910
11
12
B11
(MSB)
*AFTER COMPLETING THE DATA TRANSFER, IF FURTHER SCK CLOCKS ARE
APPLIED WITH CONV LOW, THE ADC WILL OUTPUT ZEROS INDEFINITELY
BY TAKING CONV LOW, THE DEVICE POWERS UP
AND ACQUIRES AN INPUT ACCURATELY AFTER tACQ
SLEEP MODE
tCONV
CONV
SCK
SDO
t1
tACQ
tTHROUGHPUT
t2
B10
B9
B3
B2
B1
B0*
Figure 10. LTC2360/LTC2361/LTC2362 Serial Interface Timing Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| VE-BNJ-MW-S | CONVERTER MOD DC/DC 36V 100W |
| VE-BNW-MW-S | CONVERTER MOD DC/DC 5.5V 100W |
| LTC2452CDDB#TRPBF | IC ADC 16BIT DELTA SIG 8-DFN |
| VE-BNV-MW-S | CONVERTER MOD DC/DC 5.8V 100W |
| VE-BNT-MW-S | CONVERTER MOD DC/DC 6.5V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2360ITS8#TRMPBF | 功能描述:IC ADC 12BIT 100KSPS TSOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2360ITS8#TRPBF | 功能描述:IC ADC 12BIT 100KSPS TSOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2361CS6#TRMPBF | 功能描述:IC ADC 12BIT 250KSPS TSOT23-6 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 位數:10 采樣率（每秒）:357k 數據接口:DSP，MICROWIRE?，QSPI?，串行，SPI? 轉換器數目:1 功率耗散（最大）:830µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:剪切帶 (CT) 輸入數目和類型:2 個單端，單極；2 個單端，雙極；1 個差分，單極；1 個差分，雙極 產品目錄頁面:1396 (CN2011-ZH PDF) 其它名稱:MAX1395ETB+TCT |
| LTC2361CS6#TRPBF | 功能描述:IC ADC 12BIT 250KSPS TSOT23-6 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2361CTS8#PBF | 制造商:Linear Technology 功能描述:ADC Single SAR 250ksps 12-bit Serial 8-Pin TSOT-23 |
發布緊急采購，3分鐘左右您將得到回復。