- 您現在的位置：買賣IC網 > PDF目錄10281 > LTC2286IUP#PBF (Linear Technology)IC ADC DUAL 10BIT 25MSPS 64QFN PDF資料下載
參數資料
| 型號： | LTC2286IUP#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 13/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC DUAL 10BIT 25MSPS 64QFN |
| 標準包裝： | 40 |
| 位數： | 10 |
| 采樣率（每秒）： | 25M |
| 數據接口： | 并聯 |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 180mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 64-QFN（9x9） |
| 包裝： | 管件 |
| 輸入數目和類型： | 2 個單端，雙極; 2 個差分, 雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC2288/LTC2287/LTC2286
20
228876fa
CLK
50
0.1
F
0.1
F
4.7
F
1k
FERRITE
BEAD
CLEAN
SUPPLY
SINUSOIDAL
CLOCK
INPUT
228876 F11
NC7SVU04
LTC2288
LTC2287
LTC2286
CLK
5pF-30pF
ETC1-1T
0.1
F
VCM
FERRITE
BEAD
DIFFERENTIAL
CLOCK
INPUT
228876 F13
LTC2288
LTC2287
LTC2286
CLK
100
0.1
F
4.7
F
FERRITE
BEAD
CLEAN
SUPPLY
IF LVDS USE FIN1002 OR FIN1018.
FOR PECL, USE AZ1000ELT21 OR SIMILAR
228876 F12
LTC2288
LTC2287
LTC2286
APPLICATIO S I FOR ATIO
WU
UU
The noise performance of the LTC2288/LTC2287/LTC2286
can depend on the clock signal quality as much as on the
analog input. Any noise present on the clock signal will
result in additional aperture jitter that will be RMS summed
with the inherent ADC aperture jitter.
In applications where jitter is critical, such as when digitiz-
ing high input frequencies, use as large an amplitude as
possible. Also, if the ADC is clocked with a sinusoidal
signal, filter the CLK signal to reduce wideband noise and
distortion products generated by the source.
It is recommended that CLKA and CLKB are shorted
together and driven by the same clock source. If a small
time delay is desired between when the two channels
sample the analog inputs, CLKA and CLKB can be driven
by two different signals. If this delay exceeds 1ns, the
performance of the part may degrade. CLKA and CLKB
should not be driven by asynchronous signals.
Figures 12 and 13 show alternatives for converting a
differential clock to the single-ended CLK input. The use of
a transformer provides no incremental contribution to
phase noise. The LVDS or PECL to CMOS translators
provide little degradation below 70MHz, but at 140MHz
will degrade the SNR compared to the transformer solu-
tion. The nature of the received signals also has a large
bearing on how much SNR degradation will be experi-
enced. For high crest factor signals such as WCDMA or
OFDM, where the nominal power level must be at least 6dB
to 8dB below full scale, the use of these translators will
have a lesser impact.
The transformer shown in the example may be terminated
with the appropriate termination for the signaling in use.
Figure 11. Sinusoidal Single-Ended CLK Drive
Figure 12. CLK Drive Using an LVDS or PECL to CMOS Converter
Figure 13. LVDS or PECL CLK Drive Using a Transformer
The use of a transformer with a 1:4 impedance ratio may
be desirable in cases where lower voltage differential
signals are considered. The center tap may be bypassed to
ground through a capacitor close to the ADC if the differ-
ential signals originate on a different plane. The use of a
capacitor at the input may result in peaking, and depend-
ing on transmission line length may require a 10
to 20
ohm series resistor to act as both a low pass filter for high
frequency noise that may be induced into the clock line by
neighboring digital signals, as well as a damping mecha-
nism for reflections.
Maximum and Minimum Conversion Rates
The maximum conversion rate for the LTC2288/LTC2287/
LTC2286 is 65Msps (LTC2288), 40Msps (LTC2287), and
25Msps(LTC2286).FortheADCtooperateproperly,theCLK
signal should have a 50% (
±5%) duty cycle. Each half cycle
must have at least 7.3ns (LTC2288), 11.8ns (LTC2287), and
18.9ns (LTC2286) for the ADC internal circuitry to have
enough settling time for proper operation.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-2V3-MX-S | CONVERTER MOD DC/DC 24V 75W |
| CS3101A-14S-78P | CONN RCPT 2POS IN LINE W/PINS |
| VI-2VP-MX-S | CONVERTER MOD DC/DC 13.8V 75W |
| AD7794BRUZ-REEL | IC ADC 24BIT 6CH LP 24-TSSOP |
| VI-2V2-MX-S | CONVERTER MOD DC/DC 15V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2286UP | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual 10-Bit, 65/40/25Msps Low Noise 3V ADCs |
| LTC2287 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual 10-Bit, 65/40/25Msps Low Noise 3V ADCs |
| LTC2287CUP | 制造商:Linear Technology 功能描述:ADC Dual Pipelined 40Msps 10-bit Parallel 64-Pin QFN EP |
| LTC2287CUP#PBF | 功能描述:IC ADC DUAL 10BIT 40MSPS 64QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2287CUP#TR | 制造商:Linear Technology 功能描述:ADC Dual Pipelined 40Msps 10-bit Parallel 64-Pin QFN EP T/R |
發布緊急采購，3分鐘左右您將得到回復。