- 您現在的位置：買賣IC網 > PDF目錄377768 > LTC2231IUP (LINEAR TECHNOLOGY CORP) Electrical Specifications Subject to Change PDF資料下載
參數資料
| 型號： | LTC2231IUP |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | ADC |
| 英文描述： | Electrical Specifications Subject to Change |
| 中文描述： | 1-CH 10-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC64 |
| 封裝： | 9 X 9 MM, PLASTIC, MO-220-WNJR, QFN-64 |
| 文件頁數： | 21/28頁 |
| 文件大?。?/td> | 695K |
| 代理商： | LTC2231IUP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC2230/LTC2231
21
22301p
duty cycle. If the clock is turned off for a long period of
time, the duty cycle stabilizer circuit will require a hundred
clock cycles for the PLL to lock onto the input clock. To use
the clock duty cycle stabilizer, the MODE pin should be
connected to 1/3V
DD
or 2/3V
DD
using external resistors.
The lower limit of the LTC2230/LTC2231 sample rate is
determined by droop of the sample-and-hold circuits. The
pipelined architecture of this ADC relies on storing analog
signals on small valued capacitors. Junction leakage will
discharge the capacitors. The specified minimum operat-
ing frequency for the LTC2230/LTC2231 is 1Msps.
connected to GND, 1/3V
DD
, 2/3V
DD
or V
DD
. An external
resistor divider can be used to set the 1/3V
DD
or 2/3V
DD
logic values. Table 1 shows the logic states for the
LVDS pin.
Table 1. LVDS Pin Function
LVDS
Digital Output Mode
GND
Full-Rate CMOS
1/3V
DD
Demultiplexed CMOS, Simultaneous Update
2/3V
DD
Demultiplexed CMOS, Interleaved Update
V
DD
LVDS
Digital Output Buffers (CMOS Modes)
Figure 13a shows an equivalent circuit for a single output
buffer in the CMOS output mode. Each buffer is powered
by OV
DD
and OGND, isolated from the ADC power and
ground. The additional N-channel transistor in the output
driver allows operation down to low voltages. The internal
resistor in series with the output makes the output appear
as 50
to external circuitry and may eliminate the need for
external damping resistors.
APPLICATIOU
W
U
U
DIGITAL OUTPUTS
Digital Output Modes
The LTC2230/LTC2231 can operate in several digital out-
put modes: LVDS, CMOS running at full speed, and CMOS
demultiplexed onto two buses, each of which runs at half
speed. In the demultiplexed CMOS modes the two buses
(referred to as bus A and bus B) can either be updated on
alternate clock cycles (interleaved mode) or simultaneously
(simultaneous mode). For details on the clock timing, refer
to the timing diagrams.
The LVDS pin selects which digital output mode the part
uses. This pin has a four-level logic input which should be
22301 F12a
ENC
–
1.6V
V
THRESHOLD
= 1.6V
ENC
+
0.1
μ
F
LTC2230/
LTC2231
22301 F12b
ENC
–
ENC
+
130
3.3V
3.3V
130
Q0
D0
Q0
MC100LVELT22
LTC2230/
LTC2231
83
83
Figure 12a. Single-Ended ENC Drive,
Not Recommended for Low Jitter
Figure 12b. ENC Drive Using a CMOS to PECL Translator
LTC2230/LTC2231
22301 F13a
OV
DD
V
DD
V
DD
0.1
μ
F
43
TYPICAL
DATA
OUTPUT
OGND
OV
DD
0.5V
TO V
DD
PREDRIVER
LOGIC
DATA
FROM
LATCH
OE
Figure 13a. Digital Output Buffer in CMOS Mode
As with all high speed/high resolution converters, the
digital output loading can affect the performance. The
digital outputs of the LTC2230/LTC2231 should drive a
minimal capacitive load to avoid possible interaction be-
tween the digital outputs and sensitive input circuitry. The
output should be buffered with a device such as an
ALVCH16373 CMOS latch. For full speed operation the
capacitive load should be kept under 10pF.
Lower OV
DD
voltages will also help reduce interference
from the digital outputs.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2232 | 16-Bit Universal Bus Driver With 3-State Outputs 48-TSSOP -40 to 85 |
| LTC2249IUH | 14-Bit, 80Msps Low Power 3V ADC |
| LTC1741 | 14-Bit, 80Msps Low Power 3V ADC |
| LTC1742 | 14-Bit, 80Msps Low Power 3V ADC |
| LTC1745 | 14-Bit, 80Msps Low Power 3V ADC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2231IUP#PBF | 功能描述:IC ADC 10BIT 135MSPS 64-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC2231IUP#TRPBF | 功能描述:IC ADC 10BIT 135MSPS 64-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| LTC2231UP | 制造商:LINER 制造商全稱:Linear Technology 功能描述:10-Bit,170Msps/135Msps ADCs |
| LTC2232 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:14-Bit, 80Msps Low Power 3V ADC |
| LTC2232CUK | 功能描述:IC ADC 10BIT 105MSPS SAMPL 48QFN RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。