- 您現在的位置：買賣IC網 > PDF目錄39414 > LTC2226HLU (LINEAR TECHNOLOGY CORP) 1-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP32 PDF資料下載
參數資料
| 型號： | LTC2226HLU |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | ADC |
| 英文描述： | 1-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP32 |
| 封裝： | 5 X 5 MM, PLASTIC, MS-026, TQFP-32 |
| 文件頁數： | 3/16頁 |
| 文件大?。?/td> | 679K |
| 代理商： | LTC2226HLU |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
LTC2226H
2226hfa
Input Drive Impedance
As with all high performance, high speed ADCs, the dy-
namic performance of the LTC2226H can be influenced by
the input drive circuitry, particularly the second and third
harmonics.Sourceimpedanceandreactancecaninfluence
SFDR. At the falling edge of CLK, the sample-and-hold
circuit will connect the 4pF sampling capacitor to the input
pin and start the sampling period. The sampling period
ends when CLK rises, holding the sampled input on the
sampling capacitor. Ideally the input circuitry should be
fast enough to fully charge the sampling capacitor during
the sampling period 1/(2FENCODE); however, this is not
always possible and the incomplete settling may degrade
the SFDR. The sampling glitch has been designed to be
as linear as possible to minimize the effects of incomplete
settling.
For the best performance, it is recommended to have a
source impedance of 100
W or less for each input. The
source impedance should be matched for the differential
inputs. Poor matching will result in higher even order
harmonics, especially the second.
Input Drive Circuits
Figure 3 shows the LTC2226H being driven by an RF
transformerwithacentertappedsecondary.Thesecondary
center tap is DC biased with VCM, setting the ADC input
signal at its optimum DC level. Terminating on the trans-
former secondary is desirable, as this provides a common
mode path for charging glitches caused by the sample and
hold. Figure 3 shows a 1:1 turns ratio transformer. Other
turns ratios can be used if the source impedance seen
by the ADC does not exceed 100
W for each ADC input.
A disadvantage of using a transformer is the loss of low
frequency response. Most small RF transformers have
poor performance at frequencies below 1MHz.
Figure 4 demonstrates the use of a differential amplifier to
convert a single ended input signal into a differential input
signal. The advantage of this method is that it provides
low frequency input response; however, the limited gain
bandwidth of most op amps will limit the SFDR at high
input frequencies.
Figure5showsasingle-endedinputcircuit.Theimpedance
seen by the analog inputs should be matched. This circuit
is not recommended if low distortion is required.
The 25
W resistors and 12pF capacitor on the analog
inputs serve two purposes: isolating the drive circuitry
from the sample-and-hold charging glitches and limiting
the wideband noise at the converter input.
applicaTions inForMaTion
25
25
25
25
0.1
F
AIN+
AIN–
12pF
2.2
F
VCM
LTC2226H
ANALOG
INPUT
0.1
F
T1
1:1
T1 = MA/COM ETC1-1T
RESISTORS, CAPACITORS
ARE 0402 PACKAGE SIZE
2226 F03
Figure 3. Single-Ended to Differential Conversion
Using a Transformer
25
25
12pF
2.2
F
VCM
LTC2226H
2226 F04
–
+
CM
ANALOG
INPUT
HIGH SPEED
DIFFERENTIAL
AMPLIFIER
AIN+
AIN–
25
0.1
F
ANALOG
INPUT
VCM
AIN+
AIN–
1k
12pF
2226 F05
2.2
F
1k
25
0.1
F
LTC2226H
Figure 4. Differential Drive with an Amplifier
Figure 5. Single-Ended Drive
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2226HLU#TRPBF | 1-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP32 |
| LTC2226HLU#TR | 1-CH 12-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP32 |
| LTC2246HLU#PBF | 1-CH 14-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP32 |
| LTC2246HLU#TRPBF | 1-CH 14-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP32 |
| LTC2246HLU#TR | 1-CH 14-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2226HLU#PBF | 功能描述:IC ADC 12BIT 25MSPS 32-TQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| LTC2226HLU#TRPBF | 制造商:Linear Technology 功能描述:ADC Single Pipelined 25Msps 12-bit Parallel 48-Pin LQFP T/R |
| LTC2226HLX | 制造商:LINER 制造商全稱:Linear Technology 功能描述:12-Bit, 25Msps 125°C ADC in LQFP |
| LTC2226HLX#PBF | 功能描述:IC ADC 12BIT 25MSPS 48-LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC2226HLX-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:12-Bit, 25Msps 125°C ADC in LQFP |
發布緊急采購，3分鐘左右您將得到回復。