參數資料
型號： LTC2170IUKG-14#TRPBF
廠商： Linear Technology
文件頁數： 17/34頁
文件大?。?/td> 0K
描述： IC ADC 14BIT SER/PAR 25M 52-QFN
標準包裝： 2,000
位數： 14
采樣率（每秒）： 25M
數據接口： Serial LVDS
轉換器數目： 4
功率耗散（最大）： 243mW
電壓電源： 模擬和數字
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 52-WFQFN 裸露焊盤
供應商設備封裝： 52-QFN（7x8）
包裝： 帶卷 (TR)
輸入數目和類型： 2 Differential; 2 Single-Ended
配用： DC1525A-L-ND - BOARD DEMO 40MSPS LTC2170-12
DC1371A-ND - BOARD USB DATA ACQUISITION HS
LTC2172-14/
LTC2171-14/LTC2170-14
24
21721014fb
applicaTions inForMaTion
By default the outputs are standard LVDS levels: a 3.5mA
output current and a 1.25V output common mode volt-
age. An external 100 differential termination resistor
is required for each LVDS output pair. The termination
resistors should be located as close as possible to the
LVDS receiver.
The outputs are powered by OVDD and OGND which are
isolated from the A/D core power and ground.
Programmable LVDS Output Current
Thedefaultoutputdrivercurrentis3.5mA.Thiscurrentcan
be adjusted by control register A2 in serial programming
mode.Availablecurrentlevelsare1.75mA,2.1mA,2.5mA,
3mA, 3.5mA, 4mA and 4.5mA. In parallel programming
mode the SCK pin can select either 3.5mA or 1.75mA.
Optional LVDS Driver Internal Termination
In most cases, using just an external 100 termination
resistor will give excellent LVDS signal integrity. In addi-
tion, an optional internal 100 termination resistor can
be enabled by serially programming mode control register
A2. The internal termination helps absorb any reflections
caused by imperfect termination at the receiver. When the
internal termination is enabled, the output driver current
is doubled to maintain the same output voltage swing. In
parallel programming mode the SDO pin enables internal
termination. Internal termination should only be used with
1.75mA, 2.1mA or 2.5mA LVDS output current modes.
Table 1. Maximum Sampling Frequency for All Serialization Modes. Note That These Limits Are for the LTC2172-14. The Sampling
Frequency for the Slower Speed Grades Cannot Exceed 40MHz (LTC2171-14) or 25MHz (LTC2170-14).
SERIALIZATION MODE
MAXIMUM SAMPLING
FREQUENCY, fS (MHz)
DCO FREQUENCY
FR FREQUENCY
SERIAL DATA RATE
2-Lane
16-Bit Serialization
65
4 fS
fS
8 fS
2-Lane
14-Bit Serialization
65
3.5 fS
0.5 fS
7 fS
2-Lane
12-Bit Serialization
65
3 fS
fS
6 fS
1-Lane
16-Bit Serialization
62.5
8 fS
fS
16 fS
1-Lane
14-Bit Serialization
65
7 fS
fS
14 fS
1-Lane
12-Bit Serialization
65
6 fS
fS
12 fS
DATA FORMAT
Table 2 shows the relationship between the analog input
voltage and the digital data output bits. By default the
output data format is offset binary. The 2’s complement
format can be selected by serially programming mode
control register A1.
Table 2. Output Codes vs Input Voltage
AIN+ – AIN–
(2V RANGE)
D13-D0
(OFFSET BINARY)
D13-D0
(2’s COMPLEMENT)
>1.000000V
+0.999878V
+0.999756V
11 1111 1111 1111
11 1111 1111 1110
01 1111 1111 1111
01 1111 1111 1110
+0.000122V
+0.000000V
–0.000122V
–0.000244V
10 0000 0000 0001
10 0000 0000 0000
01 1111 1111 1111
01 1111 1111 1110
00 0000 0000 0001
00 0000 0000 0000
11 1111 1111 1111
11 1111 1111 1110
–0.999878V
–1.000000V
≤–1.000000V
00 0000 0000 0001
00 0000 0000 0000
10 0000 0000 0001
10 0000 0000 0000
Digital Output Randomizer
Interference from the A/D digital outputs is sometimes
unavoidable.Digitalinterferencemaybefromcapacitiveor
inductive coupling or coupling through the ground plane.
Even a tiny coupling factor can cause unwanted tones in
the ADC output spectrum. These unwanted tones can be
randomized by randomizing the digital output before it is
transmitted off chip, which reduces the unwanted tone
amplitude.
The digital output is randomized by applying an exclu-
sive-OR logic operation between the LSB and all other
data output bits. To decode, the reverse operation is
相關PDF資料
PDF描述
VE-BNV-IV-F4 CONVERTER MOD DC/DC 5.8V 150W
IDT72V215L10TF IC FIFO SYNC 512X18 10NS 64STQFP
MS27474T12F8S CONN RCPT 8POS JAM NUT W/SCKT
VE-BNV-IV-F3 CONVERTER MOD DC/DC 5.8V 150W
MS27508E10F35S CONN RCPT 13POS BOX MNT W/SCKT
相關代理商/技術參數
參數描述
LTC2171-12 制造商:LINER 制造商全稱:Linear Technology 功能描述:12-Bit, 65Msps/40Msps/25Msps Low Power Quad ADCs
LTC2171-14 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad 14-Bit, 125Msps ADC with Integrated Drivers
LTC2171CUKG-12#PBF 功能描述:IC ADC 12BIT SER/PAR 40M 52-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
LTC2171CUKG-12#TRPBF 功能描述:IC ADC 12BIT SER/PAR 40M 52-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極
LTC2171CUKG-12PBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:12-Bit, 65Msps/40Msps/25Msps Low Power Quad ADCs
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*