參數資料
型號： LTC1923EUH
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： High Efficiency Thermoelectric Cooler Controller
中文描述： SWITCHING CONTROLLER, 270 kHz SWITCHING FREQ-MAX, PQCC32
封裝： 5 X 5 MM, PLASTIC, QFN-32
文件頁數： 12/28頁
文件大?。?/td> 452K
代理商： LTC1923EUH
12
LTC1923
1923f
PROTECTION FEATURES
Many protection features have been integrated into the
LTC1923 to ensure that the TEC is not overstressed or the
system does not thermally run away. These features
include pulse-by-pulse current limiting, TEC voltage clamp-
ing and open/shorted thermistor detection.
Current Limit
The peak current in the full bridge during each switching
cycle can be limited by placing a sense resistor, R
S
, from
the common NMOS source connections of MNA and MNB
to ground. The CS
+
and CS
–
connections should be made
as shown in Figure 1. Current limit is comprised of a fixed
gain of ten differential amplifier, an attenuator (resistor
divider) and a current limit comparator. A detailed diagram
of the circuitry is shown in Figure 3. The differential
amplifier output, I
TEC
, is provided to allow the user the
ability to monitor the instantaneous current flowing in the
bridge. If an average current is desired, an external RC
filter can be used to filter the I
TEC
output. Approximately
50ns of leading edge blanking is also internally integrated
to prevent nuisance tripping of the current sense circuitry.
It relieves the filtering requirements for the CS input pins.
During a switching cycle, current limit occurs when the
voltage on I
TEC
exceeds the lowest of the following three
conditions: 1) 1.5 times the voltage on the SS pin, 2) 1.5
times the voltage on the I
LIM
pin or 3) 1.5V. When a
current limit condition is sensed, all four external FETs are
immediately shut off. These devices are turned back on
only after C
T
reaches the same state (either charging or
OPERATIOU
discharging) as when the current limit condition oc-
curred. For instance, if C
T
is charging when current limit
occurs, the outputs are forced off for the remainder of this
charging time, the entire C
T
discharge time, and are only
re-enabled when C
T
reaches its valley voltage and begins
charging again. An analogous sequence of events occurs
if current limit is tripped while C
T
is being discharged.
The full-bridge current can be soft-started (gradually
increased) by placing a capacitor from the SS pin to
ground. A 1.5
μ
A current is sourced from the chip and will
charge the capacitor. This limits the inrush current at start-
up and allows the current delivered to the TEC to be linearly
increased from zero.
The LTC1923 features a dedicated pin, I
LIM
, to adjust
current limit. If the voltage placed on I
LIM
is greater than
1V, the default current limit, I
LIMIT
, is:
I
LIMIT
= 150mV/R
S
where R
S
= the current sense resistor.
Utilizing the I
LIM
pin allows the current limit threshold to
be easily set and adjusted (the current limit threshold can
also be adjusted by changing R
S
). More importantly, it
facilitates independent setting of the heating and cooling
current limits with the addition of one transistor. Figure 4
shows how to implement this using three resistors and an
external NMOS, M1. In many applications, a higher cool-
ing capability is desired. When TEC
+
is greater than
TEC
–
, the H/C output is in a low state signifying that the
system is being cooled (this is typical for most lasers).
–
+
A = 10
R
2R
1V
NDRVB
CURRENT SENSE
AMPLIFIER
PULSE-BY-PULSE
CURRENT LIMIT
TEC
–
CS
+
CS
–
NDRVA
TEC
+
NDRVB
OSCILLATOR
PEAK/VALLEY
NDRVA
I
TEC
I
LIM
SS
1.5
μ
A
INPUT SELECT
LEB
S
1923 F03
SHUT
OUTPUTS
OFF
R
Q
–
–
+
Figure 3. Current Sense Circuitry
相關PDF資料
PDF描述
LTC1929IG Isolated Flyback Switching Regulator with 9V Output
LTC1929C Isolated Flyback Switching Regulator with 9V Output
LTC1929CG Isolated Flyback Switching Regulator with 9V Output
LTC1929I Isolated Flyback Switching Regulator with 9V Output
LTC1929 500kHz and 1MHz High Efficiency 1.5A Switching Regulators; Package: SO; No of Pins: 8; Temperature Range: -40?°C to 85?°C
相關代理商/技術參數
參數描述
LTC1923EUH#PBF 功能描述:IC THERMOELEC COOLER CNTRLR32QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:熱電冷卻器 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.173"，4.40mm 寬）裸露焊盤 供應商設備封裝:28-TSSOP 裸露焊盤 包裝:管件 產品目錄頁面:1410 (CN2011-ZH PDF)
LTC1923EUH#TR 功能描述:IC THERMOELEC COLLER CNTRLR32QFN RoHS:否 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR
LTC1923EUH#TRPBF 功能描述:IC THERMOELEC COOLER CNTRLR32QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 標準包裝:1 系列:- 應用:手持/移動設備 電流 - 電源:- 電源電壓:3 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-LLP-EP（4x4） 包裝:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名稱:LP3905SD-30DKR
LTC1928ES6-5#PBF 制造商:Linear Technology 功能描述:Charge Pump STPUP 5V 30mA 6-Pin TSOT-23
LTC1928ES6-5#TR 功能描述:IC REG SWITCHED CAP DBL SOT23-6 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:500 系列:- 類型:切換式電容器（充電泵），反相 輸出類型:固定 輸出數:1 輸出電壓:-3V 輸入電壓:2.3 V ~ 5.5 V PWM 型:Burst Mode? 頻率 - 開關:900kHz 電流 - 輸出:100mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型，TSOT-23-6 包裝:帶卷 (TR) 供應商設備封裝:TSOT-23-6 其它名稱:LTC1983ES6-3#TRMTR
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*