參數資料
型號: LTC1875EGN
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: 15mA Quiescent Current 1.5A Monolithic Synchronous Step-Down Regulator
中文描述: 3 A SWITCHING REGULATOR, 605 kHz SWITCHING FREQ-MAX, PDSO16
封裝: 0.150 INCH, PLASTIC, SSOP-16
文件頁數: 16/20頁
文件大小: 257K
代理商: LTC1875EGN
16
LTC1875
1875f
APPLICATIOU
4. Place the small-signal components away from high
frequency switching nodes. In the layout shown in
Figure 8, all of the small-signal components have been
placed on one side of the IC and all of the power
components have been placed on the other.
5. For optimum load regulation and true sensing, the top
of the output resistor divider should connect indepen-
dently to the top of the output capacitor (Kelvin connec-
tion), staying away from any high dV/dt traces. Place
the divider resistors near the LTC1875 in order to keep
the high impedance FB node short.
W
U
U
Design Example
As a design example, assume the LTC1875 is used in a
single lithium-ion battery-powered cellular phone applica-
tion. The V
IN
will be operating from a maximum of 4.2V
down to about 2.65V. The load current requirement is a
maximum of 1.5A but most of the time it will be on standby
mode, requiring only 2mA. Efficiency at both low and high
load currents is important. Output voltage is 2.5V. With
this information we can calculate L using equation (1),
L
f
I
V
V
V
L
OUT
OUT
IN
=
( )
(
)
1
1–
(3)
Substituting V
OUT
= 2.5V, V
IN
= 4.2V,
I
L
= 450mA and
f = 550kHz in equation (3) gives:
L
V
450
kHz
mA
V
V
H
=
=
μ
2 5
.
550
1
2 5
4 2
.
4 09
.
.
A 4.7
μ
H inductor works well for this application. For good
efficiency choose a 2A inductor with less than 0.125
series resistance.
C
IN
will require an RMS current rating of at least 0.75A at
temperature and C
OUT
will require an ESR of less than
0.125
. In most applications, the requirements for these
capacitors are fairly similar.
For the feedback resistors, choose R2 = 412k. R1 can then
be calculated from equation (2) to be:
R
V
R
k
OUT
0 8
.
1
1
2
875.k use
887
=
=
Figure 9 shows the complete circuit along with its effi-
ciency curve.
相關PDF資料
PDF描述
LTC1877 High Efficiency Monolithic Synchronous Step-Down Regulator(高效率,單片同步步降穩壓器)
LTC1878 High Efficiency Monolithic Synchronous Step-Down Regulator(高效率,單片同步步降穩壓器)
LTC1911-15 Low Noise, High Efficiency, Inductorless Step-Down DC/DC Converter
LTC1911EMS8-1.5 Low Noise, High Efficiency, Inductorless Step-Down DC/DC Converter
LTC1911EMS8-1.8 Low Noise, High Efficiency, Inductorless Step-Down DC/DC Converter
相關代理商/技術參數
參數描述
LTC1875EGN#PBF 功能描述:IC REG BUCK SYNC ADJ 1.5A 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON(1.45x1) 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
LTC1875EGN#TR 功能描述:IC REG BUCK SYNC ADJ 1.5A 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V,1.5V,1.8V,2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬)裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LTC1875EGN#TRPBF 功能描述:IC REG BUCK SYNC ADJ 1.5A 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V,1.5V,1.8V,2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬)裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LTC1876EG 功能描述:IC REG CTRLR BST PWM CM 36-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1876EG#PBF 功能描述:IC REG CTRLR BST PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:PolyPhase® 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX