- 您現在的位置：買賣IC網 > PDF目錄10148 > LTC1740IG (Linear Technology)IC ADC SMPL 14BIT 6MSPS 36-SSOP PDF資料下載
參數資料
| 型號： | LTC1740IG |
| 廠商： | Linear Technology |
| 文件頁數： | 4/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC SMPL 14BIT 6MSPS 36-SSOP |
| 標準包裝： | 37 |
| 位數： | 14 |
| 采樣率（每秒）： | 6M |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 300mW |
| 電壓電源： | 雙 ± |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 36-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 36-SSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 2 個單端，雙極；1 個差分，雙極 |
12
LTC1740
1740f
APPLICATIO S I FOR ATIO
WU
UU
Choosing an Input Amplifier
Choosing an input amplifier is easy if a few requirements
are taken into consideration. First, to limit the magnitude
of the voltage spike seen by the amplifier from charging
the sampling capacitor, choose an amplifier that has a low
output impedance (<100
) at the closed-loop bandwidth
frequency. For example, if an amplifier is used in a gain
of 1 and has a unity-gain bandwidth of 50MHz, then the
output impedance at 50MHz must be less than 100
. The
second requirement is that the closed-loop bandwidth
must be greater than 50MHz to ensure adequate small-
signal settling for full throughput rate. If slower op amps
are used, more settling time can be provided by increasing
the time between conversions.
The best choice for an op amp to drive the LTC1740 will
depend on the application. Generally applications fall into
two categories: AC applications where dynamic specifica-
tions are most critical and time domain applications where
DC accuracy and settling time are most critical.
Input Filtering
The noise and the distortion of the input amplifier and
other circuitry must be considered since they will add to
the LTC1740 noise and distortion. The small-signal band-
width of the sample-and-hold circuit is 80MHz. Any noise
or distortion products that are present at the analog inputs
will be summed over this entire bandwidth. Noisy input
circuitry should be filtered prior to the analog inputs to
minimize noise. A simple 1-pole RC filter is sufficient for
many applications.
For example, Figure 9 shows a 1000pF capacitor from
+AIN to –AIN and a 30 source resistor to limit the input
bandwidth to 5.3MHz. The 1000pF capacitor also acts as
a charge reservoir for the input sample-and-hold and iso-
lates the amplifier driving VIN from the ADC’s small current
glitch. In undersampling applications, an input capacitor
this large may prohibitively limit the input bandwidth.
If this is the case, use as large an input capacitance as
possible. High quality capacitors and resistors should be
+AIN
VIN
LTC1740
1740 F09
–AIN
1000pF
30
Figure 9. RC Input Filter
INPUT VOLTAGE (V)
–(FS – 1LSB)
FS – 1LSB
OUTPUT
CODE
1740 F10
011…111
011…110
011…101
100…010
100…001
100…000
OVERFLOW
BIT
1
0
Figure 10. LTC1740 Transfer Characteristics
used since these components can add distortion. NPO and
silver mica type dielectric capacitors have excellent linear-
ity. Carbon surface mount resistors can generate distor-
tion from self-heating and from damage that may occur
during soldering. Metal film surface mount resistors are
much less susceptible to both problems.
Digital Outputs and Overflow Bit (OF)
Figure 10 shows the ideal input/output characteristics for
the LTC1740. The output data is two’s complement binary
for all input ranges and for both single and dual supply
operation. One LSB = VREF/(0.9 16384). To create a
straight binary output, invert the MSB (D13). The overflow
bit (OF) indicates when the analog input is outside the
input range of the converter. OF is high when the output
code is 10 0000 0000 0000 or 01 1111 1111 1111.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-J5Z-EY-S | CONVERTER MOD DC/DC 2V 20W |
| MS3101F28-11P | CONN RCPT 22POS FREE HNG W/PINS |
| VE-B3T-IV-F4 | CONVERTER MOD DC/DC 6.5V 150W |
| VE-2NR-MX-F1 | CONVERTER MOD DC/DC 7.5V 75W |
| MS3102E24-22PY | CONN RCPT 4POS BOX MNT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1740IG#PBF | 功能描述:IC ADC 14BIT 6MSPS 36SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC1740IG#TR | 功能描述:IC ADC SMPL 14BIT 6MSPS 36-SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC1740IG#TRPBF | 功能描述:IC ADC 14BIT 6MSPS 36SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| LTC1741CFW | 功能描述:IC ADC 12BIT 65MSPS 48-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| LTC1741CFW#PBF | 功能描述:IC ADC 12BIT 65MSPS 48-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
發布緊急采購，3分鐘左右您將得到回復。