- 您現在的位置：買賣IC網 > PDF目錄377763 > LTC1736IG (LINEAR TECHNOLOGY CORP) Isolated Flyback Switching Regulator with 9V Output PDF資料下載
參數資料
| 型號： | LTC1736IG |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Isolated Flyback Switching Regulator with 9V Output |
| 中文描述： | 3 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24 |
| 封裝： | PLASTIC, SSOP-24 |
| 文件頁數： | 18/28頁 |
| 文件大小： | 322K |
| 代理商： | LTC1736IG |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
18
LTC1736
APPLICATIU
Why should you defeat overcurrent latchoff During the
prototyping stage of a design, there may be a problem with
noise pickup or poor layout causing the protection circuit
to latch off. Defeating this feature will easily allow trouble-
shooting of the circuit and PC layout. The internal short-
circuit and foldback current limiting still remains active,
thereby protecting the power supply system from failure.
After the design is complete, a decision can be made
whether to enable the latchoff feature.
The value of the soft-start capacitor C
SS
will need to be
scaled with output voltage, output capacitance and load
current characteristics. The minimum soft-start capaci-
tance is given by:
C
SS
> (C
OUT
)(V
OUT
)(10
–4
)(R
SENSE
)
The minimum recommended soft-start capacitor of C
SS
=
0.1
μ
F will be sufficient for most applications.
W
U
U
Fault Conditions: Current Limit and Current Foldback
The LTC1736 current comparator has a maximum sense
voltage of 75mV resulting in a maximum MOSFET current
of 75mV/R
SENSE
.
The LTC1736 includes current foldback to help further
limit load current when the output is shorted to ground.
The foldback circuit is active even when the overload
shutdown latch described above is defeated. If the output
falls by more than half, then the maximum sense voltage
is progressively lowered from 75mV to 30mV. Under
short-circuit conditions with very low duty cycle, the
LTC1736 will begin cycle skipping in order to limit the
short-circuit current. In this situation the bottom MOSFET
will be conducting the peak current. The short-circuit
ripple current is determined by the minimum on-time
t
ON(MIN)
of the LTC1736 (less than 200ns), the input
voltage, and inductor value:
I
L(SC)
= t
ON(MIN)
V
IN
/L.
The resulting short circuit current is:
I
mV
R
I
SC
SENSE
L SC
(
=
+
30
1
2
)
The current foldback function is always active and is not
effected by the current latchoff function.
Fault Conditions: Output Overvoltage Protection
(Crowbar)
The output overvoltage crowbar is designed to blow a
system fuse in the input lead when the output of the
regulator rises much higher than nominal levels. This
condition causes huge currents to flow, much greater than
in normal operation. This feature is designed to protect
against a shorted top MOSFET; it does not protect against
a failure of the controller itself.
The comparator (OV in the Functional Diagram) detects
overvoltage faults greater than 7.5% above the nominal
output voltage. When this condition is sensed, the top
MOSFET is turned off and the bottom MOSFET is forced
on. The bottom MOSFET remains on continuously for as
long as the OV condition persists; if V
OUT
returns to a safe
level, normal operation automatically resumes. Note that
VID controlled output voltage decreases may cause the
overvoltage protection to be momentarily activated. This
will not cause permanent latchoff nor will it disrupt the
desired voltage change.
With soft-latch overvoltage protection, dynamic VID code
changes are allowed and the overvoltage protection tracks
the new VID code, always protecting the load (CPU). If
dynamic VID code changes are anticipated and the mini-
mum load current is light, it may be necessary to either
force continuous operation by pulling FCB low during the
transition to maximize current sinking capability or con-
nect PGOOD to FCB to automatically force continuous
operation during VID transitions.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1748IFW | 14-Bit, 80Msps Low Noise ADC |
| LTC1748 | 14-Bit, 80Msps Low Noise ADC |
| LTC1748CFW | 14-Bit, 80Msps Low Noise ADC |
| LTC1754ES6-3.3 | Micropower, Regulated 3.3V/5V Charge Pump with Shutdown in SOT-23 |
| LTC1754-5 | Micropower, Regulated 3.3V/5V Charge Pump with Shutdown in SOT-23 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1736IG#PBF | 功能描述:IC SW REG STEP-DONW SYNC 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1736IG#TR | 功能描述:IC REG SW SYNC STEPDWN HE 24SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1736IG#TRPBF | 功能描述:IC SW REG STEP-DONW SYNC 24-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:43 系列:- 應用:控制器，Intel VR11 輸入電壓:5 V ~ 12 V 輸出數:1 輸出電壓:0.5 V ~ 1.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-VFQFN 裸露焊盤 供應商設備封裝:48-QFN（7x7） 包裝:管件 |
| LTC1740CG | 功能描述:IC ADC 14BIT 6MSPS 36SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC1740CG#PBF | 功能描述:IC ADC 14BIT 6MSPS 36SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。