參數資料
型號： LTC1539
廠商： Linear Technology Corporation
元件分類： 基準電壓源/電流源
英文描述： Dual High Efficiency, Low Noise, Synchronous Step-Down Switching Regulators
中文描述： 雙通道高效率，低噪聲，同步降壓型開關穩壓器
文件頁數： 10/32頁
文件大?。?/td> 451K
代理商： LTC1539
10
LTC 1538-AUX/LTC 1539
OPERATIO
Main Control Loop
U
The LTC1538-AUX/LTC1539 use a constant frequency,
current mode step-down architecture. During normal op-
eration, the top MOSFET is turned on each cycle when the
oscillator sets the RS latch and turned off when the main
current comparator I1 resets the RS latch. The peak
inductor current at which I1 resets the RS latch is con-
trolled by the voltage on the I
TH1
(I
TH2
) pin, which is the
output of each error amplifier (EA). The V
PROG1
pin,
described in the Pin Functions, allows the EA to receive a
selectively attenuated output feedback voltage V
FB1
from
the SENSE
–
1 pin while V
PROG2
and V
OSENSE2
allow EA to
receive an output feedback voltage V
FB2
from either inter-
nal or external resistive dividers on the second controller.
When the load current increases, it causes a slight de-
crease in V
FB
relative to the 1.19V reference, which in turn
causes the I
TH1
(I
TH2
) voltage to increase until the average
inductor current matches the new load current. After the
large top MOSFET has turned off, the bottom MOSFET is
turned on until either the inductor current starts to reverse,
as indicated by current comparator I2, or the beginning of
the next cycle.
The top MOSFET drivers are biased from floating boot
strap capacitor C
B
, which normally is recharged during
each Off cycle. When V
IN
decreases to a voltage close to
V
OUT
, however, the loop may enter dropout and attempt to
turn on the top MOSFET continuously. The dropout detec-
tor counts the number of oscillator cycles that the top
MOSFET remains on and periodically forces a brief off
period to allow C
B
to recharge.
The main control loop is shut down by pulling the RUN/
SS1 (RUN/SS2) pin low. Releasing RUN/SS1 (RUN/SS2)
allows an internal 3
μ
A current source to charge soft start
capacitor C
SS
. When C
SS
reaches 1.3V, the main control
loop is enabled with the I
TH1
(I
TH2
) voltage clamped at
approximately 30% of its maximum value. As C
SS
contin-
ues to charge, I
TH1
(I
TH2
) is gradually released allowing
normal operation to resume. When both RUN/SS1 and
RUN/SS2 are low, all LTC1538-AUX/LTC1539 functions
are shut down except for the 5V standby regulator, internal
reference and a comparator. Refer to the LTC1438/LTC1439
for applications which do not require a 5V standby regulator.
Comparator OV guards against transient overshoots
> 7.5% by turning off the top MOSFET and keeping it off
until the fault is removed.
Low Current Operation
Adaptive Power Mode allows the LTC1539 to automati-
cally change between two output stages sized for different
load currents. The TGL1 (TGL2) and BG1 (BG2) pins drive
large synchronous N-channel MOSFETs for operation at
high currents, while the TGS1 (TGS2) pin drives a much
smaller N-channel MOSFET used in conjunction with a
Schottky diode for operation at low currents. This allows
the loop to continue to operate at normal operating fre-
quency as the load current decreases without incurring the
large MOSFET gate charge losses. If the TGS1 (TGS2) pin
is left open, the loop defaults to Burst Mode operation in
which the large MOSFETs operate intermittently based on
load demand. Adaptive Power mode provides constant
frequency operation down to approximately 1% of rated
load current. This results in an order of magnitude reduc-
tion of load current before Burst Mode operation com-
mences. Without the small MOSFET (ie: no Adaptive
Power mode) the transition to Burst Mode operation is
approximately 10% of rated load current. The transition to
low current operation begins when comparator I2 detects
current reversal and turns off the bottom MOSFET. If the
voltage across R
SENSE
does not exceed the hysteresis of
I2 (approximately 20mV) for one full cycle, then on follow-
ing cycles the top drive is routed to the small MOSFET at
the TGS1 (TGS2) pin and the BG1 (BG2) pin is disabled.
This continues until an inductor current peak exceeds
20mV/R
SENSE
or the I
TH1
(I
TH2
) voltage exceeds 0.6V,
either of which causes drive to be returned to the TGL1
(TGL2) pin on the next cycle.
Two conditions can force continuous synchronous opera-
tion, even when the load current would otherwise dictate
low current operation. One is when the common mode
voltage of the SENSE
+
1 (SENSE
+
2) and SENSE
–
1
(SENSE
–
2) pins are below 1.4V, and the other is when the
SFB1 pin is below 1.19V. The latter condition is used to
assist in secondary winding regulation, as described in the
Applications Information section.
(Refer to Functional Diagram)
相關PDF資料
PDF描述
LTC1538-AUXIG ER 1C 1#4 SKT PLUG
LTC1538IG-AUX DIODE ZENER SINGLE 1000mW 15Vz 50mA-Izt 0.05 1uA-Ir 11 PowerDI-123 3K/REEL
LTC1538CG-AUX Dual High Efficiency, Low Noise, Synchronous Step-Down Switching Regulators
LTC1539CGW Dual High Efficiency, Low Noise, Synchronous Step-Down Switching Regulators
LTC1541IS8 Micropower Op Amp, Comparator and Reference
相關代理商/技術參數
參數描述
LTC1539CGW 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1539CGW#PBF 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1539CGW#TR 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1539CGW#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1539IGW 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*