APPLICATIONS INFOR
參數資料
型號: LTC1406CGN#PBF
廠商: Linear Technology
文件頁數: 3/16頁
文件大小: 0K
描述: IC A/D CONV 8BIT SAMPLING 24SSOP
標準包裝: 55
位數: 8
采樣率(每秒): 20M
數據接口: 并聯
轉換器數目: 1
功率耗散(最大): 225mW
電壓電源: 模擬和數字,雙 ±
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 24-SSOP(0.154",3.90mm 寬)
供應商設備封裝: 24-SSOP
包裝: 管件
輸入數目和類型: 2 個單端,雙極;1 個差分,雙極
11
LTC1406
APPLICATIONS INFORMATION
WU
U
LT1229/LT1230: Dual and Quad 100MHz Current Feed-
back Amplifiers.
±2V to ±15V supplies. Low noise. 6mA
supply current each amplifier.
LT1259/LT1260: Dual and Triple 130MHz Current Feed-
back Amplifiers.
±2V to ±14V supplies. 5mA supply cur-
rent. Low distortion. Low noise.
LT1363: 70MHz Voltage Feedback Amplifier.
±2.5V to
±15V supplies. 7.5mA supply current. Low distortion.
LT1364/LT1365: Dual and Quad 70MHz Voltage Feedback
Amplifiers.
±2.5V to ±15V supplies. 7.5mA supply current
per amplifier. Low distortion.
Input Filtering
The noise and the distortion of the input amplifier and
other circuitry must be considered since they will add to
the LTC1406 noise and distortion. The small-signal band-
width of the sample-and-hold circuit is 250MHz. Any noise
or distortion products that are present at the analog inputs
will be summed over this entire bandwidth. Noisy input
circuitry should be filtered prior to the analog inputs to
minimize noise. A simple 1-pole RC filter is sufficient for
many applications. For example, Figure 9 shows a 220pF
capacitor from AIN
+ to AIN– and a 75 source resistor to
limit the input bandwidth to 9.6MHz. The 220pF capacitor
also acts as a charge reservoir for the input sample-and-
hold and isolates the ADC input from sampling glitch sen-
sitive circuitry. Larger value capacitors may be substituted
to further limit the input bandwidth. High quality capaci-
tors and resistors should be used since these components
can add distortion. NPO and silver mica type dielectric
capacitors have excellent linearity. Carbon surface mount
resistors can also generate distortion from self-heating
and from damage that may occur during soldering. Metal
film surface mount resistors are much less susceptible to
both problems.
Input/Output Characteristics
Figure 10 shows the ideal input/output characteristics for
the LTC1406. The code transitions occur midway between
successive integer LSB values (i.e., – FS + 0.5LSB, – FS +
1.5LSB, – FS + 2.5LSB...FS – 1.5LSB, FS – 0.5LSB). The
output is straight binary with 1LSB = FS – (– FS)/256 = 2V/
256 = 7.8125mV. The OF/UF bit indicates that the input has
exceeded full scale and can be used to detect an overrange
or underrange condition. A logic high output on the OF/UF
pin with an output code of 0000 0000 indicates the input
is less than the negative full scale. A logic high output on
the OF/UF pin with an output code of 1111 1111 indicates
that the input is greater than the positive full scale. A logic
low output on the OF/UF pin indicates the input is within
the full-scale range of the converter.
In applications where absolute accuracy is important, off-
set and full-scale errors can be adjusted to zero. Offset
error must be adjusted before full-scale error. Zero offset
is achieved by adjusting the offset applied to the AIN– input.
For zero offset error, apply a voltage equal to the input
Figure 10. Transfer Characteristics
Figure 9. RC Input Filter
AIN
+
ANALOG INPUT
1.5V TO 3.5V
2.5V
220pF
75
1406 F09
AIN
LTC1406
VREF
INPUT VOLTAGE (V)
0
OUTPUT
CODE
–1
LSB
1406 F10
1111 1111
OF/UF BIT
1111 1110
1111 1101
1000 0001
1000 0000
0111 1111
0111 1110
0000 0000
0000 0001
0000 0010
1
LSB
FS – 1LSB
–FS
相關PDF資料
PDF描述
LTC1096LIS8 IC A/D CONV 8BIT SRL IN/OUT8SOIC
D38999/20JF32PNLC CONN HSG RCPT 32POS WALL MT PINS
LTC1096IS8#PBF IC A/D CONV 8BIT SRL IN/OUT8SOIC
MS27468E13F98P CONN RCPT 10POS JAM NUT W/PINS
MAX9736AETJ/V+T IC AMP MONO/STER CLASS D 32TQFN
相關代理商/技術參數
參數描述
LTC1406IGN 功能描述:IC A/D CONV 8BIT SAMPLING 24SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率(每秒):20M 數據接口:并聯 轉換器數目:2 功率耗散(最大):155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP(7x7) 包裝:Digi-Reel® 輸入數目和類型:4 個單端,單極;2 個差分,單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
LTC1406IGN#PBF 功能描述:IC A/D CONV 8BIT SAMPLING 24SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC1406IGN#TR 功能描述:IC ADC 8BIT 20MSPS SAMPLE 24SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC1406IGN#TRPBF 功能描述:IC A/D CONV 8BIT SAMPLING 24SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC1407ACMSE 功能描述:IC ADC 14BIT 3MSPS SAMPLE 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極