參數資料
型號： LT4254CGN
廠商： Linear Technology
文件頁數： 12/16頁
文件大?。?/td> 232K
描述： IC CTRLR HOTSWAP POSVOLT 16SSOP
標準包裝： 100
類型： 熱交換控制器
應用： 通用
內部開關： 無
電源電壓： 10.8 V ~ 36 V
工作溫度： 0°C ~ 70°C
安裝類型： 表面貼裝
封裝/外殼： 16-SSOP（0.154"，3.90mm 寬）
供應商設備封裝： 16-SSOP
包裝： 管件
產品目錄頁面： 1341 (CN2011-ZH PDF)
LT4254
12
4254fb
commanded to start back up. This can be commanded by
cycling the UV pin to ground and then back high (this
command can only be accepted after the TIMER pin
discharges below the 0.65V typ threshold, so as to prevent
overheating transistor Q1).
Therefore, using the RETRY pin only, the LT4254 will
either latch off after an overcurrent fault condition or it will
go into a hiccup mode.
Undervoltage and Overvoltage Detection
The LT4254 uses the UV and OV pins to monitor the V
CC
voltage and allow the user the greatest flexibility for setting
the operational thresholds. The UV and OV pins are
internally connected to an analog window comparator.
Any time that the UV pin goes below 3.6V or the OV pin
goes above 4V, the gate will be pulled low until the UV/OV
pin voltages return to the normal operation voltage win-
dow (4V and 3.65V, respectively).
Power Good Detection
The LT4254 includes a comparator for monitoring the
output voltage. The output voltage is sensed through the
FB pin via an external resistor string. The comparators
output (PWRGD pin) is an open collector capable of
operating from a pull-up as high as 36V.
The PWRGD pin can be used to directly enable/disable a
power module with an active high enable input. Figure 11
shows how to use the PWRGD pin to control an active low
enable input power module. Signal inversion is accom-
plished by transistor Q2 and R10.
Open FET Detection
The LT4254 can be used to detect the presence of an open
FET. When the voltage across the sense resistor is less
than 3.5mV, the open collector pull-down device is shut
off allowing the OPEN pin to be externally pulled high.
An open FET condition is signalled when the OPEN pin is
high and the PWRGD pin is low (after the part has
completed its start-up cycle). This open FET condition can
be falsely signalled during start-up if the load is not
activated until after PWRGD goes high. To avoid this false
indication, the OPEN and PWRGD pins should not be
polled for a period of time, t
STARTUP
, given by:
3
1
35
"
"
V
C
A
t
CC
STARTUP
?/DIV>
=
This can be accomplished either by a microcontroller (if
available) or by placing an RC filter as shown in Figure 12.
Once the OPEN voltage exceeds the monitoring logic thresh-
old, V
THRESH
, and PWRGD is low, an open FET condition
is signalled. In order to prevent a false indication, the RC
product should be set with the following equation:
RC
V
C
A
V
V
V
CC
LOGIC
LOGIC    THRESH
>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
?/DIV>
3
1
35
"
"
ln

Another condition that can cause a false indication is if the
LT4254 goes into current limit during start-up. This will
cause t
STARTUP
 to be longer than calculated. Also, if the
APPLICATIO  S I FOR  ATIO
U
U
U
Figure 9. Latch Off Waveforms
Figure 10. RETRY Waveforms
I
OUT
500mA/DIV
2.5ms/DIV
4254 F09
V
OUT
20V/DIV
TIMER
5V/DIV
GATE
20V/DIV
Latch Off Operation
I
OUT
500mA/DIV
2.5ms/DIV
4254 F10
V
OUT
20V/DIV
TIMER
5V/DIV
GATE
1V/DIV
Automatic Restart Operation (Short-Ciruit Output)
相關PDF資料
PDF描述
LT4256-1IS8#TRPBF IC CTRLR HOTSWAP HV LATCH 8SOIC
LTC1392IS8#TRPBF IC DATA ACQ SYSTEM 10BIT 8-SOIC
LTC1421ISW-2.5#PBF IC CONTROLLER HOT SWAP 24-SOIC
LTC1422CN8 IC CONTROLLER HOT SWAP 8-DIP
LTC1642CGN#TRPBF IC CONTROLLER HOTSWAP ADJ 16SSOP
相關代理商/技術參數
參數描述
LT4254CGN#PBF 功能描述:IC CTRLR HOTSWAP POSVOLT 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件
LT4254CGN#TR 功能描述:IC CTLR HOTSWAP POS 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件
LT4254CGN#TRPBF 功能描述:IC CTRLR HOTSWAP POSVOLT 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件
LT4254IGN 功能描述:IC CTLR HOTSWAP POS 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件
LT4254IGN#PBF 功能描述:IC CTLR HOTSWAP POS 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*