- 您現在的位置：買賣IC網 > Datasheet目錄41 > LT4250LCN8 (Linear Technology)IC CONTRLR HOT SWAP NEG 48V 8DIP Datasheet資料下載
參數資料
| 型號： | LT4250LCN8 |
| 廠商： | Linear Technology |
| 文件頁數： | 9/14頁 |
| 文件大?。?/td> | 236K |
| 描述： | IC CONTRLR HOT SWAP NEG 48V 8DIP |
| 標準包裝： | 50 |
| 類型： | 熱交換控制器 |
| 應用： | 通用 |
| 內部開關： | 無 |
| 電源電壓： | -20 V ~ -80 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 8-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 8-PDIP |
| 包裝： | 管件 |
| 產品目錄頁面： | 1341 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁
LT4250L/LT4250H
9
4250lhfa
DRAIN voltage has finished ramping, the GATE pin then
ramps to its final value.
Current Limit/Electronic Circuit Breaker
The LT4250 features a current limit function that protects
against short circuits or excessive supply currents. If the
current limit is active for more than 500約 the electronic
circuit breaker will trip. By placing a sense resistor between
the V
EE
and SENSE pin, the current limit will be activated
whenever the voltage across the sense resistor is greater
than 50mV .
Note that the current limit threshold should be set suffi-
ciently high to account for the sum of the load current
and the inrush current. The maximum value of the inrush
current is given by:
I
INRUSH
0.8"
40mV
R
SENS
E
I
LOAD,
where the 0.8 factor is used as a worst case margin com-
bined with the minimum trip voltage (40mV).
In the case of a short circuit, the current limit circuitry
activates and immediately pulls the GATE low, servos the
SENSE voltage to 50mV , and starts a 500約 timer. The
MOSFET current is limited to 50mV/R
SENSE
(see Figure 7).
If the short circuit persists for more than 500約, the circuit
breaker trips and pulls the GATE pin low, shutting off the
MOSFET . The circuit breaker is reset by pulling UV low,
or by cycling power to the part. If the short circuit clears
before the 500約 timing interval the current limit will
deactivate and release the GATE.
APPLICATIONS INFORMATION
Figure 7. Short-Circuit Protection Waveforms
DRAIN
50V/DIV
GATE
10V/DIV
I
D
(Q1)
5A/DIV
1ms/DIV
The LT4250 guards against voltage steps on the input
supply. A positive voltage step (increasing in magnitude)
on the input supply causes an inrush current that is
proportional to the voltage slew rate I = C
L
" 擵/擳 . If the
inrush exceeds 50mV/R
SENSE
, the current limit will activate
as shown in Figure 8. The GATE pin pulls low, limiting the
current to 50mV/R
SENSE
. At this level the MOSFET drain
will not follow the source as the input voltage rapidly
changes, but instead remains at the voltage stored on the
load capacitance. The load capacitance begins to charge
at a current of 50mV/R
SENSE
, but not for long. As the load
capacitance charges, C2 pushes back on the gate and limits
the MOSFET current in a manner identical to the initial start-
up condition which is less than the short circuit limiting
value of 50mV/R
SENSE
. Thus the circuit breaker does not
trip. To ensure correct operation under input voltage step
conditions, R
SENSE
must be chosen to provide a current
limit value greater than the sum of the load current and
the dynamic current in the load capacitance.
For C2 values less than 10nF a positive voltage step
increasing in magnitude on the input supply can result
in the Q1 turning off momentarily due to current limit
overshoot which can shut down the output. By adding an
additional resistor and diode, Q1 remains on during the
voltage step. This is shown as D1 and R7 in Figure 9. The
purpose of D1 is to shunt current around R7 when the
power pins first make contact and allow C1 to hold the
GATE low. The value of R7 should be sized to generate an
R7 " C1 time constant of 33約.
Under some conditions, a short circuit at the output can
cause the input supply to dip below the UV threshold. The
LT4250 turns off once and then turns on until the electronic
circuit breaker is tripped. This can be minimized by adding
a deglitching delay to the UV pin with a capacitor from UV
to V
EE
. This capacitor forms an RC time constant with the
resistors at UV , allowing the input supply to recover before
the UV pin resets the circuit breaker.
相關PDF資料 |
PDF描述 |
|---|---|
| LT4254CGN | IC CTRLR HOTSWAP POSVOLT 16SSOP |
| LT4256-1IS8#TRPBF | IC CTRLR HOTSWAP HV LATCH 8SOIC |
| LTC1392IS8#TRPBF | IC DATA ACQ SYSTEM 10BIT 8-SOIC |
| LTC1421ISW-2.5#PBF | IC CONTROLLER HOT SWAP 24-SOIC |
| LTC1422CN8 | IC CONTROLLER HOT SWAP 8-DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT4250LCN8#PBF | 功能描述:IC CONTRLR HOT SWAP NEG 48V 8DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP（3x3） 包裝:管件 |
| LT4250LCS8 | 功能描述:IC CONTRLR HOTSWAP NEG 48V 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LT4250LCS8#PBF | 功能描述:IC CONTRLR HOTSWAP NEG 48V 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LT4250LCS8#TR | 功能描述:IC CONTRLR HOTSWAP NEG 48V 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LT4250LCS8#TRPBF | 功能描述:IC CONTRLR HOTSWAP NEG 48V 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。