- 您現在的位置：買賣IC網 > PDF目錄30767 > LT3694IUFD#TRPBF (LINEAR TECHNOLOGY CORP) 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PQCC28 PDF資料下載
參數資料
| 型號： | LT3694IUFD#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PQCC28 |
| 封裝： | 4 X 5 MM, LEAD FREE, PLASTIC, MO-220, QFN-28 |
| 文件頁數： | 6/28頁 |
| 文件大?。?/td> | 276K |
| 代理商： | LT3694IUFD#TRPBF |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LT3694/LT3694-1
14
36941fa
Diode Selection
The catch diode (D1 from Figure 1) conducts current only
during switch off time. Average forward current in normal
operation can be calculated from:
I
D(AVG) = IOUT
V
IN VOUT
V
IN
Consider a diode with a larger current rating than ID(AVG)
when the part must survive a shorted output. The DA pin
monitors the current in the diode and prevents the switch
from turning on at the beginning of a charge cycle if the
diode current is above the DA limit. Therefore, under
overload conditions, the average diode current will in-
crease to the average of the switch current limit and the
DA current limit.
Peak reverse voltage is equal to the regulator input voltage,
so use a diode with a reverse voltage rating greater than
the maximum input voltage. The internal OVLO can protect
the diode from excessive reverse voltage by shutting down
the regulator if the input voltage exceeds 38V. Table 4 lists
several Schottky diodes and their manufacturers.
Table 4. Schottky Diodes (40V, 3A)
PART NUMBER
Vf at 3A (V)
OUTLINE
MANUFACTURER
MBRS340
MBRD340
0.5
0.6
SMC
D-PAK
ON Semiconductor
www.onsemi.com
B340
SMB340
0.5
SMC
Powermite 3
Diodes, Inc.
www.diodes.com
CMSH3-40
CSHD3-40
0.5
0.65
SMC
D-PAK
Central Semiconductor
www.centralsemi.com
Frequency Compensation
The LT3694 uses current mode control to regulate the
output. This simplifies loop compensation. In particular, the
LT3694 does not require the ESR of the output capacitor for
stability, so the user is free to employ ceramic capacitors to
achieve low output ripple and small circuit size. Frequency
compensation is provided by the components tied to the
VC pin, as shown in Figure 2. Generally a capacitor (CC)
and a resistor (RC) in series to ground are used. In addi-
tion, there may be lower value capacitor in parallel. This
capacitor (CF) is not part of the loop compensation but
is used to filter noise at the switching frequency, and is
required only if a phase-lead capacitor (CPL) is used or if
the output capacitor (C1) has high ESR.
APPLICATIONS INFORMATION
–
+
0.75V
SW
VC
gm =
350μS
GND
3M
LT3694
36941 F02
R1
OUTPUT
ESR
CF
CC
RC
ERROR
AMPLIFIER
FB
R2
C1
CURRENT MODE
POWER STAGE
gm = 7.5S
+
POLYMER
OR
TANTALUM
CERAMIC
CPL
Figure 2. Model for Loop Response
Loop compensation determines the stability and transient
performance. The best values for the compensation net-
work depend on the application and in particular the type
of output capacitor. A practical approach is to start with
one of the circuits in this data sheet that is similar to your
application and tune the compensation network to optimize
the performance. Stability should then be checked across all
operating conditions, including load current, input voltage
and temperature. The LT1375 data sheet contains a more
thorough discussion of loop compensation and describes
how to test the stability using a transient load. Figure 2
shows an equivalent circuit for the LT3694 control loop.
The error amplifier is a transconductance amplifier with
finite output impedance.
相關PDF資料 |
PDF描述 |
|---|---|
| LT3694IFE#PBF | 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO20 |
| LT3694-1IUFD#PBF | 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PQCC28 |
| LT3694IUFD#PBF | 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PQCC28 |
| LT3694-1IFE#PBF | 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO20 |
| LT3694-1EFE#PBF | 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3695 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1A Fault Tolerant Micropower Step-Down Regulator |
| LT3695EMSE#PBF | 功能描述:IC REG BUCK ADJ 1A 16MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LT3695EMSE#TRPBF | 功能描述:IC REG BUCK ADJ 1A 16MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LT3695EMSE-3.3#PBF | 功能描述:IC REG BUCK 3.3V 1A 16MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LT3695EMSE-3.3#PBF | 制造商:Linear Technology 功能描述:IC STEP-DOWN REGULATOR MSOP-16 |
發布緊急采購，3分鐘左右您將得到回復。