參數資料
型號： LT3694IUFD#TRPBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PQCC28
封裝： 4 X 5 MM, LEAD FREE, PLASTIC, MO-220, QFN-28
文件頁數： 26/28頁
文件大?。?/td> 276K
代理商： LT3694IUFD#TRPBF
LT3694/LT3694-1
7
36941fa
PIN FUNCTIONS
VIN (Pin 1/Pins 27, 28): The VIN pin supplies power to the
internal switch of the 2.6A regulator and to the LT3694’s
internal reference and start-up circuitry. This pin must be
locally bypassed.
EN/UVLO (Pin 2/Pin 1): The EN/UVLO pin is used to shut
down the LT3694. It can be driven from a logic level or
used as an undervoltage lockout by connecting a resistor
divider from VIN.
CLKOUT (Pin 3/Pin 2): Digital Clock Output. The CLKOUT
pin allows synchronization of other switching regulators
(LT3694-1 only).
SYNC (Pin 3/Pin 2): Frequency Synchronization Input.
Connect a frequency source to this input if synchronization
is desired. Connect SYNC to ground if not used (LT3694
only).
PGOOD (Pin 4/Pin 3): Open Collector Output. PGOOD is
pulled low when any of the three regulators drops out of
regulation (VFB < 90% of nominal value).
RT (Pin 5/Pin 4): The RT pin requires a resistor to ground
to set the operating frequency of the LT3694. If synchroniz-
ing the LT3694 to an external clock, the resistor should
be set to program the frequency at least 20% below the
synchronization frequency.
TRK/SS1, TRK/SS2 , TRK/SS3 (Pins 6, 7, 14/Pins 5, 6, 17):
The TRK/SS pins allow a regulator to track the output of
another regulator. When the TRK/SS pin is below 0.75V,
the FB pin regulates to the TRK/SS voltage. This pin can
also be used as a soft-start by connecting a capacitor from
TRK/SS to ground. The TRK/SS pins should be left open
if neither feature is used.
FB1, FB2, FB3 (Pins 15, 8, 13/Pins 18, 7, 16): Negative
Inputs of the Error Amplifiers. The LT3694 regulates each
feedback pin to the lesser of 0.75V or the corresponding
TRK/SS pin voltage. Connect the feedback resistor divider
taps to these pins.
DRV2, DRV3 (Pins 9, 12/Pins 8, 15): The DRV pins
provide the base drive for the external NPN transistors
for the LDO regulators. The DRV pins can provide up to
6V of base drive.
LIM2, LIM3 (Pins 10, 11/Pins 9, 14): The LIM pins provide
current limiting on the LDO pass transistors by sensing
a voltage on an external sense resistor connected to the
BIAS pin. These pins should be connected to BIAS if this
function is not used.
GND (Pins 10, 11, 12, 13, 25, 26) UFD Package Only:
Power and Signal Ground.
VC1 (Pin 16/Pin 19): Output of the Internal Error Amp.
The voltage on this pin controls the peak switch cur-
rent. This pin is normally used to compensate the
control loop. The switching regulator can be shut
down by pulling the VC1 pin to ground with an NMOS
or NPN transistor.
BIAS (Pin 17/Pin 20): The BIAS pin supplies the current
to the LT3694’s internal regulator and boost circuits. This
must be connected to a voltage source above 3V, usually
to VOUT1. The LDO pass transistor base current will also
come from the BIAS pin if it is at least 1.8V above the
LDO output.
BST (Pin 18/Pin 21): The BST pin is used to provide a
drive voltage, higher than the input voltage, to the internal
bipolar NPN power switch.
DA (Pin 19/Pin 22): The DA pin senses the catch diode
current to prevent excessive inductor current in output
overload or short-circuit conditions.
SW (Pin 20/Pins 23, 24): Output of the Internal Power
Switch. Connect this pin to the inductor and switching
diode.
Exposed Pad (Pin 21/Pin 29): Ground. The underside
exposed pad metal of the package provides both elec-trical
contact to ground and a conductive thermal path to the
printed circuit board. The Exposed Pad must be soldered to
a grounded pad on the circuit board for proper operation.
(FE/UFD)
相關PDF資料
PDF描述
LT3694IFE#PBF 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO20
LT3694-1IUFD#PBF 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PQCC28
LT3694IUFD#PBF 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PQCC28
LT3694-1IFE#PBF 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO20
LT3694-1EFE#PBF 2.6 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO20
相關代理商/技術參數
參數描述
LT3695 制造商:LINER 制造商全稱:Linear Technology 功能描述:1A Fault Tolerant Micropower Step-Down Regulator
LT3695EMSE#PBF 功能描述:IC REG BUCK ADJ 1A 16MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
LT3695EMSE#TRPBF 功能描述:IC REG BUCK ADJ 1A 16MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LT3695EMSE-3.3#PBF 功能描述:IC REG BUCK 3.3V 1A 16MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LT3695EMSE-3.3#PBF 制造商:Linear Technology 功能描述:IC STEP-DOWN REGULATOR MSOP-16
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*