- 您現在的位置：買賣IC網 > PDF目錄30767 > LT3511MPMS#PBF (LINEAR TECHNOLOGY CORP) 0.43 A SWITCHING REGULATOR, 650 kHz SWITCHING FREQ-MAX, PDSO12 PDF資料下載
參數資料
| 型號： | LT3511MPMS#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.43 A SWITCHING REGULATOR, 650 kHz SWITCHING FREQ-MAX, PDSO12 |
| 封裝： | LEAD FREE, PLASTIC, MSOP-12/16 |
| 文件頁數： | 5/26頁 |
| 文件大?。?/td> | 298K |
| 代理商： | LT3511MPMS#PBF |
LT3511
13
3511fb
at maximum load and minimum input voltage. The switch
current is highest at this point along with the energy stored
in the leakage inductance. A 0.5W Zener will satisfy most
applications when the highest VZENERischosen.Choosing
a low value for VZENER will cause excessive power loss as
shown in the following equations:
DZ Power Loss = 1
2
L IPK(VIN(MIN))2 fSW
1+
NPS VOUT + VF
(
)
VZENER – NPS VOUT + VF
(
)
L = Leakage Inductance
IPK(VIN(MIN)) =
VOUT IOUT 2
η VIN(MIN) DVIN(MIN)
fSW =
1
tON + tOFF
=
1
LPRI IPK(VIN(MIN))
VIN(MIN)
+
LPRI IPK(VIN(MIN))
NPS VOUT + VF
(
)
Tables 2 and 3 show some recommended diodes and
Zener diodes.
Table 2. Recommended Zener Diodes
PART
VZENER
(V)
POWER
(W)
CASE
VENDOR
MMSZ5266BT1G
68
0.5
SOD-123 On Semi
MMSZ5270BT1G
91
0.5
SOD-123
CMHZ5266B
68
0.5
SOD-123 Central
Semiconductor
CMHZ5267B
75
0.5
SOD-123
BZX84J-68
68
0.5
SOD323F NXP
BZX100A
100
0.5
SOD323F
Table 3. Recommended Diodes
PART
I (A)
VREVERSE
(V)
CASE
VENDOR
BAV21W
0.625
200
SOD-123 Diodes Inc.
BAV20W
0.625
150
SOD-123
Leakage Inductance Blanking
When the power switch turns off, the flyback pulse
appears. However, a finite time passes before the trans-
former primary-side voltage waveform approximately
represents the output voltage. Rise time on the SW
node and transformer leakage inductance cause the
delay. The leakage inductance also causes a very fast
voltage spike on the primary side of the transformer.
The amplitude of the leakage spike is largest when
power switch current is highest. Introduction of an
internal fixed delay between switch turn-off and the
start of sampling provides immunity to the phenomena
discussed above. The LT3511 sets internal blanking to
150ns. In certain cases leakage inductance spikes last
longer than the internal blanking, but will not signifi-
cantly affect output regulation.
Secondary Leakage Inductance
In addition to primary leakage inductance, secondary
leakage inductance exhibits an important effect on ap-
plication design. Secondary leakage inductance forms
an inductive divider on the transformer secondary. The
inductive divider effectively reduces the size of the
primary-referred flyback pulse. The smaller flyback
pulse results in a higher regulated output voltage. The
inductive divider effect of secondary leakage inductance
is load independent. RFB/RREF ratio adjustments can ac-
commodate this effect to the extent secondary leakage
inductance is a constant percentage of mutual inductance
(over manufacturing variations).
Winding Resistance Effects
Resistance in either the primary or secondary will re-
duce overall efficiency (POUT/PIN). Good output voltage
regulation will be maintained independent of winding
resistance due to the boundary mode operation of the
LT3511.
Bifilar Winding
A bifilar, or similar winding technique, is a good way to
minimize troublesome leakage inductances. However, re-
member that this will also increase primary-to-secondary
capacitanceandlimittheprimary-to-secondarybreakdown
voltage, so bifilar winding is not always practical. The
Linear Technology applications group is available and
extremely qualified to assist in the selection and/or design
of the transformer.
applicaTions inForMaTion
相關PDF資料 |
PDF描述 |
|---|---|
| LT3511HMS#PBF | 0.43 A SWITCHING REGULATOR, 650 kHz SWITCHING FREQ-MAX, PDSO12 |
| LT3512EMS#PBF | 0.8 A SWITCHING REGULATOR, 650 kHz SWITCHING FREQ-MAX, PDSO12 |
| LT3512HMS#TRPBF | 0.8 A SWITCHING REGULATOR, 650 kHz SWITCHING FREQ-MAX, PDSO12 |
| LT3512MPMS#PBF | 0.8 A SWITCHING REGULATOR, 650 kHz SWITCHING FREQ-MAX, PDSO12 |
| LT3512EMS#TRPBF | 0.8 A SWITCHING REGULATOR, 650 kHz SWITCHING FREQ-MAX, PDSO12 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3512 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Monolithic High Voltage Isolated Flyback Converter |
| LT3512_11 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Monolithic High Voltage Isolated Flyback Converter |
| LT3512EMS#PBF | 功能描述:IC REG FLYBK ISO ADJ .42A 16MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LT3512EMS#TRPBF | 功能描述:IC REG FLYBK ISO ADJ .42A 16MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LT3512EMSPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Monolithic High Voltage Isolated Flyback Converter |
發布緊急采購，3分鐘左右您將得到回復。