參數資料
型號： LT3437
廠商： Linear Technology Corporation
英文描述： Panels; For Use With:EUROCARD Subracks RoHS Compliant: Yes
中文描述： 高電壓，200kHz降壓500mA的降壓開關穩壓器以100？的靜態電流
文件頁數： 20/24頁
文件大?。?/td> 523K
代理商： LT3437
LT3437
20
3437f
APPLICATIOU
FREQUENCY COMPENSATION
Before starting on the theoretical analysis of frequency
response, the following should be remembered—the worse
the board layout, the more difficult the circuit will be to
stabilize. This is true of almost all high frequency analog
circuits. Read the Layout Considerations section first.
Common layout errors that appear as stability problems
are distant placement of input decoupling capacitor and/or
catch diode, and connecting the V
C
compensation to a
ground track carrying significant switch current. In addi-
tion, the theoretical analysis considers only first order
non-ideal component behavior. For these reasons, it is
important that a final stability check is made with produc-
tion layout and components.
The LT3437 uses current mode control. This alleviates
many of the phase shift problems associated with the
inductor. The basic regulator loop is shown in Figure 10.
The LT3437 can be considered as two g
m
blocks, the error
amplifier and the power stage.
Figure 11 shows the overall loop response. At the V
C
pin,
the frequency compensation components used are:
R
C
= 25k, C
C
= 1500pF and C
F
= 330pF. The output
capacitor used is a 100
μ
F, 10V tantalum capacitor with
typical ESR of 100m
.
The ESR of the tantalum output capacitor provides a useful
zero in the loop frequency response for maintaining stabil-
ity. This ESR, however, contributes significantly to the
ripple voltage at the output (see Output Ripple Voltage in
the Applications Information section). It is possible to
reduce capacitor size and output ripple voltage by replac-
ing the tantalum output capacitor with a ceramic output
capacitor because of its very low ESR. The zero provided
by the tantalum output capacitor must now be reinserted
back into the loop. Alternatively, there may be cases
where, even with the tantalum output capacitor, an addi-
tional zero is required in the loop to increase phase margin
for improved transient response.
W
U
U
A zero can be added into the loop by placing a resistor (R
C
)
at the V
C
pin in series with the compensation capacitor, C
C
,
or by placing a capacitor (C
FB
) between the output and the
FB pin.
When using R
C
, the maximum value has two limitations.
First, the combination of output capacitor ESR and R
C
may
stop the loop rolling off altogether. Second, if the loop gain
is not rolled off sufficiently at the switching frequency,
output ripple will perturb the V
C
pin enough to cause
unstable duty cycle switching, similar to subharmonic
oscillations. If needed, an additional capacitor (C
F
) can be
added across the R
C
/C
C
network from the V
C
pin to ground
to further suppress V
C
ripple voltage.
With a tantalum output capacitor, the LT3437 already
includes a resistor (R
C
) and filter capacitor (C
F
) at the V
C
pin (see Figures 10 and 11) to compensate the loop over
the entire V
IN
range (to allow for stable pulse skipping for
high V
IN
-to-V
OUT
ratios
≥
10). A ceramic output capacitor
can still be used with a simple adjustment to the resistor R
C
for stable operation (see Ceramic Capacitors section for
stabilizing LT3430). If additional phase margin is required,
a capacitor (C
FB
) can be inserted between the output and
FB pin, but care must be taken for high output voltage
applications. Sudden shorts to the output can create
unacceptably large negative transients on the FB pin.
For V
IN
-to-V
OUT
ratios < 10, higher loop bandwidths are
possible by readjusting the frequency compensation com-
ponents at the V
C
pin.
When checking loop stability, the circuit should be oper-
ated over the application’s full voltage, current and tem-
perature range. Proper loop compensation may be obtained
by empirical methods, as described in Application Notes
19 and 76.
相關PDF資料
PDF描述
LT3437IFE MOSFET N-CHANNEL 100V SOT323
LT3437EFE RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS
LT3460 1.3MHz Step-Up DC/DC Converter in SC70 and ThinSOT
LT3460ESC6 1.3MHz Step-Up DC/DC Converter in SC70 and ThinSOT
LT3460ES5 1.3MHz Step-Up DC/DC Converter in SC70 and ThinSOT
相關代理商/技術參數
參數描述
LT3437_1 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Voltage 500mA, 200kHz Step-Down Switching Regulator with 100μA Quiescent Current
LT3437EDD 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3.3V to 60V 10-Pin DFN EP
LT3437EDD#PBF 功能描述:IC REG BUCK ADJ 0.5A 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LT3437EDD#TRPBF 功能描述:IC REG BUCK ADJ 0.5A 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC
LT3437EFE 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3.3V to 60V 16-Pin TSSOP EP
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*