- 您現在的位置：買賣IC網 > PDF目錄5284 > LT1994HDD#PBF (Linear Technology)IC DIFF AMP/DRIVER LN-LD 8-DFN PDF資料下載
參數資料
| 型號： | LT1994HDD#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 20/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DIFF AMP/DRIVER LN-LD 8-DFN |
| 標準包裝： | 121 |
| 放大器類型： | 差分 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 65 V/µs |
| 增益帶寬積： | 70MHz |
| 電流 - 輸入偏壓： | 18µA |
| 電壓 - 輸入偏移： | 3000µV |
| 電流 - 電源： | 14.8mA |
| 電流 - 輸出 / 通道： | 85mA |
| 電壓 - 電源，單路/雙路(±)： | 2.375 V ~ 12.6 V，±1.188 V ~ 6.3 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 8-DFN-EP（3x3） |
| 包裝： | 管件 |
9
1994fb
LT1994
IN+, IN– (Pins 1, 8): Noninverting and Inverting Input
Pins of the Amplier, Respectively. For best performance,
it is highly recommended that stray capacitance be
kept to an absolute minimum by keeping printed circuit
connections as short as possible, and if necessary, strip-
ping back nearby surrounding ground plane away from
these pins.
VOCM (Pin 2): Output Common Mode Reference Voltage.
The VOCM pin is the midpoint of an internal resistive volt-
age divider between the supplies, developing a (default)
mid-supply voltage potential to maximize output signal
swing. VOCM has a Thevenin equivalent resistance of
approximately 40k and can be overdriven by an external
voltage reference. The voltage on VOCM sets the output
common mode voltage level (which is dened as the av-
erage of the voltages on the OUT+ and OUT– pins). VOCM
should be bypassed with a high quality ceramic bypass
capacitor of at least 0.1μF (unless connected directly to
a low impedance, low noise ground plane) to minimize
common mode noise from being converted to differen-
tial noise by impedance mismatches both externally and
internally to the IC.
V+, V– (Pins 3, 6):
Power Supply Pins. For single-supply
applications (Pin 6 grounded) it is recommended that
high quality 1μF and 0.1μF ceramic bypass capacitors be
placed from the positive supply pin (Pin 3) to the negative
supply pin (Pin 6) with minimal routing. Pin 6 should be
directly tied to a low impedance ground plane. For dual
power supplies, it is recommended that high quality, 0.1μF
ceramic capacitors are used to bypass Pin 3 to ground
and Pin 6 to ground. It is also highly recommended that
high quality 1μF and 0.1μF ceramic bypass capacitors be
placed across the power supply pins (Pins 3 and 6) with
minimal routing.
OUT+, OUT– (Pins 4, 5):
Output Pins. Each pin can drive
approximately 100
Ωtogroundwithashort-circuitcurrent
limit of up to ±85mA. Each amplier output is designed
to drive a load capacitance of 25pF. This basically means
the amplier can drive 25pF from each output to ground
or 12.5pF differentially. Larger capacitive loads should be
decoupled with at least 25
Ω resistors from each output.
SHDN (Pin 7): When Pin 7 (SHDN) is oating or when
Pin 7 is directly tied to V+, the LT1994 is in the normal
operating mode. When Pin 7 is pulled a minimum of 2.1V
below V+, the LT1994 enters into a low power shutdown
state. Refer to the SHDN pin section under Applications
Information for a description of the LT1994 output imped-
ance in the shutdown state.
PIN FUNCTIONS
相關PDF資料 |
PDF描述 |
|---|---|
| 4-1676481-9 | RES 560 OHM 1/16W 0.1% 0603 |
| EL5150ISZ | IC AMP VFA SGL 200MHZ 8-SOIC |
| 0459844452 | CONN RCPT R/A 4PWR 28SGL 2.36MM |
| 0031.8413 | FUSE 500MA 250VAC 5X20 FAST |
| NPPC151KFXC-RC | CONN FMALE 15POS .1" SMD GOLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1994IDD | 制造商:Linear Technology 功能描述:SP Amp DIFF AMP Single R-R O/P ±6.3V/12.6V 8-Pin DFN EP |
| LT1994IDD#PBF | 功能描述:IC DIFF AMP/DRIVER LN 8-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| LT1994IDD#PBF | 制造商:Linear Technology 功能描述:DIFF-AMPLIFIER 70MHZ 65V/ 制造商:Linear Technology 功能描述:DIFF-AMPLIFIER, 70MHZ, 65V/s, DFN-8 |
| LT1994IDD#TR | 制造商:Linear Technology 功能描述:DIFF-AMPLIFIER, 70MHZ, 65V/US, DFN-8, No. of Amplifiers:1, Input Offset Voltage: 制造商:Linear Technology 功能描述:DIFF-AMPLIFIER, 70MHZ, 65V/US, DFN-8, No. of Amplifiers:1, Input Offset Voltage:2mV, Bandwidth:70MHz, Amplifier Case Style:DFN, No. of Pins:8, Supply Voltage Range:2.375V to 12.6V, Slew Rate:65V/s, Supply Current:14.8mA, MSL:- , RoHS Compliant: No |
| LT1994IDD#TRPBF | 功能描述:IC DIFF AMP/DRIVER LN 8-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。