- 您現在的位置：買賣IC網 > PDF目錄377719 > LT1963A-3.3 (Linear Technology Corporation) 1.5A, Low Noise, Fast Transient Response LDO Regulators PDF資料下載
參數資料
| 型號： | LT1963A-3.3 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| 中文描述： | 1.5A的，低噪聲，快速瞬態響應LDO穩壓器 |
| 文件頁數： | 12/20頁 |
| 文件大?。?/td> | 278K |
| 代理商： | LT1963A-3.3 |
12
LT1963A Series
1963af
Figure 4. Ceramic Capacitor Temperature Characteristics
APPLICATIOU
W
U
U
TEMPERATURE (
°
C)
–50
40
20
0
–20
–40
–60
–80
–100
25
75
1963 F04
–25
0
50
100
125
Y5V
C
X5R
BOTH CAPACITORS ARE 16V,
1210 CASE SIZE, 10
μ
F
an effective value as low as 1
m
F to 2
m
F over the operating
temperature range. The X5R and X7R dielectrics result in
more stable characteristics and are more suitable for use
as the output capacitor. The X7R type has better stability
across temperature, while the X5R is less expensive and
is available in higher values.
Voltage and temperature coefficients are not the only
sources of problems. Some ceramic capacitors have a
piezoelectric response. A piezoelectric device generates
voltage across its terminals due to mechanical stress,
similar to the way a piezoelectric accelerometer or micro-
phone works. For a ceramic capacitor the stress can be
induced by vibrations in the system or thermal transients.
Overload Recovery
Like many IC power regulators, the LT1963A-X has safe
operating area protection. The safe area protection de-
creases the current limit as input-to-output voltage in-
creases and keeps the power transistor inside a safe
operating region for all values of input-to-output voltage.
The protection is designed to provide some output current
at all values of input-to-output voltage up to the device
breakdown.
When power is first turned on, as the input voltage rises,
the output follows the input, allowing the regulator to start
up into very heavy loads. During the start-up, as the input
voltage is rising, the input-to-output voltage differential is
small, allowing the regulator to supply large output
currents. With a high input voltage, a problem can occur
wherein removal of an output short will not allow the
output voltage to recover. Other regulators, such as the
LT1085, also exhibit this phenomenon, so it is not unique
to the LT1963A-X.
The problem occurs with a heavy output load when the
input voltage is high and the output voltage is low. Com-
mon situations are immediately after the removal of a
short-circuit or when the shutdown pin is pulled high after
the input voltage has already been turned on. The load line
for such a load may intersect the output current curve at
two points. If this happens, there are two stable output
operating points for the regulator. With this double inter-
section, the input power supply may need to be cycled
down to zero and brought up again to make the output
recover.
Output Voltage Noise
The LT1963A regulators have been designed to provide
low output voltage noise over the 10Hz to 100kHz band-
width while operating at full load. Output voltage noise is
typically 40nV/
÷
Hz over this frequency bandwidth for the
LT1963A (adjustable version). For higher output voltages
(generated by using a resistor divider), the output voltage
noise will be gained up accordingly. This results in RMS
noise over the 10Hz to 100kHz bandwidth of 14
m
V
RMS
for
the LT1963A increasing to 38
m
V
RMS
for the LT1963A-3.3.
Higher values of output voltage noise may be measured
when care is not exercised with regards to circuit layout
and testing. Crosstalk from nearby traces can induce
unwanted noise onto the output of the LT1963A-X. Power
supply ripple rejection must also be considered; the
LT1963A regulators do not have unlimited power supply
rejection and will pass a small portion of the input noise
through to the output.
Thermal Considerations
The power handling capability of the device is limited by the
maximum rated junction temperature (125
∞
C). The power
dissipated by the device is made up of two components:
1. Output current multiplied by the input/output voltage
differential: (I
OUT
)(V
IN
– V
OUT
), and
相關PDF資料 |
PDF描述 |
|---|---|
| LT1963AEST-1.8 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963AEST-2.5 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963A-2.5 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963A | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963A-1.5 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1963AEFE | 制造商:Linear Technology 功能描述:LDO Regulator Pos 1.21V to 20V 1.5A 16-Pin TSSOP EP |
| LT1963AEFE#PBF | 功能描述:IC REG LDO ADJ 1.5A 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:8V 輸入電壓:10.5 V ~ 23 V 電壓 - 壓降（標準）:1.7V @ 40mA 穩壓器數量:1 電流 - 輸出:100mA（最小值） 電流 - 限制（最?。?- 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:剪切帶 (CT) 產品目錄頁面:1075 (CN2011-ZH PDF) 其它名稱:296-24390-1 |
| LT1963AEFE#TR | 制造商:Linear Technology 功能描述:SP-LINREG, 1.5A, Fast Transient LDO in FE-16 |
| LT1963AEFE#TRPBF | 功能描述:IC REG LDO ADJ 1.5A 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:800 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:2.5V 輸入電壓:最高 16V 電壓 - 壓降（標準）:0.7V @ 4A 穩壓器數量:1 電流 - 輸出:4A 電流 - 限制（最?。?4.2A 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-6，D²Pak（5 引線+接片），TO-263BA 供應商設備封裝:TO-263-5 包裝:帶卷 (TR) 其它名稱:AP1184K525L-13AP1184K525LDITR |
| LT1963AEFE-1.5 | 制造商:Linear Technology 功能描述:LDO Regulator Pos 1.5V 1.5A 16-Pin TSSOP EP |
發布緊急采購，3分鐘左右您將得到回復。