- 您現在的位置：買賣IC網 > PDF目錄377719 > LT1963A-3.3 (Linear Technology Corporation) 1.5A, Low Noise, Fast Transient Response LDO Regulators PDF資料下載
參數資料
| 型號： | LT1963A-3.3 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| 中文描述： | 1.5A的，低噪聲，快速瞬態響應LDO穩壓器 |
| 文件頁數： | 10/20頁 |
| 文件大?。?/td> | 278K |
| 代理商： | LT1963A-3.3 |
10
LT1963A Series
1963af
Figure 1. Kelvin Sense Connection
IN
SHDN
1963 F01
R
P
OUT
V
IN
SENSE
GND
LT1963A
R
P
+
+
LOAD
PU
OUT:
Output. The output supplies power to the load. A
minimum output capacitor of 10
m
F is required to prevent
oscillations. Larger output capacitors will be
required for applications with large transient loads to limit
peak voltage transients. See the Applications Information
section for more information on output capacitance and
reverse output characteristics.
SENSE:
Sense. For fixed voltage versions of the LT1963A
(LT1963A-1.5/LT1963A-1.8/LT1963A-2.5/LT1963A-3.3),
the SENSE pin is the input to the error amplifier. Optimum
regulation will be obtained at the point where the SENSE
pin is connected to the OUT pin of the regulator. In critical
applications, small voltage drops are caused by the resis-
tance (R
P
) of PC traces between the regulator and the load.
These may be eliminated by connecting the SENSE pin to
the output at the load as shown in Figure 1 (Kelvin Sense
Connection). Note that the voltage drop across the exter-
nal PC traces will add to the dropout voltage of the regu-
lator. The SENSE pin bias current is 600
m
A at the nominal
rated output voltage. The SENSE pin can be pulled below
ground (as in a dual supply system where the regulator
load is returned to a negative supply) and still allow the
device to start and operate.
ADJ:
Adjust. For the adjustable LT1963A, this is the input
to the error amplifier. This pin is internally clamped to
±
7V.
It has a bias current of 3
m
A which flows into the pin. The
ADJ pin voltage is 1.21V referenced to ground and the
output voltage range is 1.21V to 20V.
SHDN:
Shutdown. The SHDN pin is used to put the
LT1963A regulators into a low power shutdown state. The
output will be off when the SHDN pin is pulled low. The
SHDN pin can be driven either by 5V logic or open-
collector logic with a pull-up resistor. The pull-up resistor
is required to supply the pull-up current of the open-
collector gate, normally several microamperes, and the
SHDN pin current, typically 3
m
A. If unused, the SHDN pin
must be connected to V
IN
. The device will be in the low
power shutdown state if the SHDN pin is not connected.
IN:
Input. Power is supplied to the device through the IN
pin. A bypass capacitor is required on this pin if the device
is more than six inches away from the main input filter
capacitor. In general, the output impedance of a battery
rises with frequency, so it is advisable to include a bypass
capacitor in battery-powered circuits. A bypass capacitor
in the range of 1
m
F to 10
m
F is sufficient. The LT1963A
regulators are designed to withstand reverse voltages on
the IN pin with respect to ground and the OUT pin. In the
case of a reverse input, which can happen if a battery is
plugged in backwards, the device will act as if there is a
diode in series with its input. There will be no reverse
current flow into the regulator and no reverse voltage will
appear at the load. The device will protect both itself and
the load.
相關PDF資料 |
PDF描述 |
|---|---|
| LT1963AEST-1.8 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963AEST-2.5 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963A-2.5 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963A | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963A-1.5 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1963AEFE | 制造商:Linear Technology 功能描述:LDO Regulator Pos 1.21V to 20V 1.5A 16-Pin TSSOP EP |
| LT1963AEFE#PBF | 功能描述:IC REG LDO ADJ 1.5A 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:8V 輸入電壓:10.5 V ~ 23 V 電壓 - 壓降（標準）:1.7V @ 40mA 穩壓器數量:1 電流 - 輸出:100mA（最小值） 電流 - 限制（最?。?- 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:剪切帶 (CT) 產品目錄頁面:1075 (CN2011-ZH PDF) 其它名稱:296-24390-1 |
| LT1963AEFE#TR | 制造商:Linear Technology 功能描述:SP-LINREG, 1.5A, Fast Transient LDO in FE-16 |
| LT1963AEFE#TRPBF | 功能描述:IC REG LDO ADJ 1.5A 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:800 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:2.5V 輸入電壓:最高 16V 電壓 - 壓降（標準）:0.7V @ 4A 穩壓器數量:1 電流 - 輸出:4A 電流 - 限制（最?。?4.2A 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-6，D²Pak（5 引線+接片），TO-263BA 供應商設備封裝:TO-263-5 包裝:帶卷 (TR) 其它名稱:AP1184K525L-13AP1184K525LDITR |
| LT1963AEFE-1.5 | 制造商:Linear Technology 功能描述:LDO Regulator Pos 1.5V 1.5A 16-Pin TSSOP EP |
發布緊急采購，3分鐘左右您將得到回復。