- 您現在的位置：買賣IC網 > PDF目錄377719 > LT1962EMS8-5 (LINEAR TECHNOLOGY CORP) 300mA, Low Noise, Micropower LDO Regulators PDF資料下載
參數資料
| 型號： | LT1962EMS8-5 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 300mA, Low Noise, Micropower LDO Regulators |
| 中文描述： | 5 V FIXED POSITIVE LDO REGULATOR, 0.43 V DROPOUT, PDSO8 |
| 封裝： | PLASTIC, MSOP-8 |
| 文件頁數： | 5/8頁 |
| 文件大?。?/td> | 138K |
| 代理商： | LT1962EMS8-5 |
5
LT1962 Series
The LT1962 series are 300mA low dropout regulators with
micropower quiescent current and shutdown. The devices
are capable of supplying 300mA at a dropout voltage of
300mV. Output voltage noise can be lowered to 20
μ
V
RMS
over a 10Hz to 100kHz bandwidth with the addition of a
0.01
μ
F reference bypass capacitor. Additionally, the refer-
ence bypass capacitor will improve transient response of
the regulator, lowering the settling time for transient load
conditions. The low operating quiescent current (30
μ
A)
drops to less than 1
μ
A in shutdown. In addition to the low
quiescent current, the LT1962 regulators incorporate sev-
eral protection features which make them ideal for use in
battery-powered systems. The devices are protected
against both reverse input and reverse output voltages. In
battery backup applications where the output can be held
up by a backup battery when the input is pulled to ground,
the LT1962-X acts like it has a diode in series with its
output and prevents reverse current flow. Additionally, in
dual supply applications where the regulator load is re-
turned to a negative supply, the output can be pulled below
ground by as much as 20V and still allow the device to start
and operate.
Adjustable Operation
The adjustable version of the LT1962 has an output
voltage range of 1.22V to 20V. The output voltage is set by
the ratio of two external resistors as shown in Figure 2. The
device servos the output to maintain the ADJ pin voltage
at 1.22V referenced to ground. The current in R1 is then
equal to 1.22V/R1 and the current in R2 is the current in R1
plus the ADJ pin bias current. The ADJ pin bias current,
30nA at 25
°
C, flows through R2 into the ADJ pin. The
Figure 2. Adjustable Operation
output voltage can be calculated using the formula in
Figure 2. The value of R1 should be no greater than 250k
to minimize errors in the output voltage caused by the ADJ
pin bias current. Note that in shutdown the output is turned
off and the divider current will be zero.
The adjustable device is tested and specified with the ADJ
pin tied to the OUT pin for an output voltage of 1.22V.
Specifications for output voltages greater than 1.22V will
be proportional to the ratio of the desired output voltage to
1.22V: V
OUT
/1.22V. For example, load regulation for an
output current change of 1mA to 300mA is –2mV typical
at V
OUT
= 1.22V. At V
OUT
= 12V, load regulation is:
(12V/1.22V)(–2mV) = –19.7mV
Bypass Capacitance and Low Noise Performance
The LT1962 regulators may be used with the addition of a
bypass capacitor from V
OUT
to the BYP pin to lower output
voltage noise. A good quality low leakage capacitor is
recommended. This capacitor will bypass the reference of
the regulator, providing a low frequency noise pole. The
noise pole provided by this bypass capacitor will lower the
output voltage noise to as low as 20
μ
V
RMS
with the
addition of a 0.01
μ
F bypass capacitor. Using a bypass
capacitor has the added benefit of improving transient
response. With no bypass capacitor and a 10
μ
F output
capacitor, a 10mA to 300mA load step will settle to within
1% of its final value in less than 100
μ
s. With the addition
of a 0.01
μ
F bypass capacitor, the output will settle to
within 1% for a 10mA to 300mA load step in less than
10
μ
s, with total output voltage deviation of less than 2.5%.
However, regulator start-up time is inversely proportional
to the size of the bypass capacitor, slowing to 15ms with
a 0.01
μ
F bypass capacitor and 10
μ
F output capacitor.
Output Capacitance and Transient Response
The LT1962 regulators are designed to be stable with a
wide range of output capacitors. The ESR of the output
capacitor affects stability, most notably with small capaci-
tors. A minimum output capacitor of 3.3
μ
F with an ESR of
3
or less is recommended to prevent oscillations. The
LT1962-X is a micropower device and output transient
response will be a function of output capacitance. Larger
values of output capacitance decrease the peak deviations
IN
1962 F02
R2
OUT
V
IN
V
OUT
ADJ
GND
LT1962
R1
+
V
V
R
R
I
R
V
I
ADJ
OUTPUT RANGE = 1.22V TO 20V
V
AT 25 C
nA
OUT
ADJ
ADJ
=
+
(
1
)( )
=
=
°
1 22
.
1
2
2
1 22
30
.
APPLICATIOU
W
U
U
相關PDF資料 |
PDF描述 |
|---|---|
| LT1962EMS8-3.3 | 300mA, Low Noise, Micropower LDO Regulators |
| LT1963AEST-1.5 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963AES8-1.5 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963AEST-3.3 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
| LT1963A-3.3 | 1.5A, Low Noise, Fast Transient Response LDO Regulators |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1962EMS8-5#PBF | 功能描述:IC REG LDO 5V .3A 8-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:MIC5365/66 Ultra-small LDO Regulators 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3V 輸入電壓:最高 5.5V 電壓 - 壓降（標準）:0.155V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最?。?200mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:4-UDFN 裸露焊盤，4-TMLF? 供應商設備封裝:4-TMLF?（1x1） 包裝:Digi-Reel® 其它名稱:576-3192-6 |
| LT1962EMS8-5#TR | 功能描述:IC REG LDO 5V .3A 8-MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:50 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3.3V 輸入電壓:最高 15V 電壓 - 壓降（標準）:1.1V @ 800mA 穩壓器數量:1 電流 - 輸出:800mA 電流 - 限制（最?。?800mA 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-4，D²Pak（3 引線+接片），TO-263AA 供應商設備封裝:D2PAK-3 包裝:管件 |
| LT1962EMS8-5#TRPBF | 功能描述:IC REG LDO 5V .3A 8-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:50 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3.3V 輸入電壓:最高 15V 電壓 - 壓降（標準）:1.1V @ 800mA 穩壓器數量:1 電流 - 輸出:800mA 電流 - 限制（最?。?800mA 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-4，D²Pak（3 引線+接片），TO-263AA 供應商設備封裝:D2PAK-3 包裝:管件 |
| LT1962EMS8-5PBF | 制造商:Linear Technology 功能描述:LDO Regulator 5V 300mA Low Noise MSOP8 |
| LT1962EMS8PBF | 制造商:Linear Technology 功能描述: 制造商:Linear Technology 功能描述:LDO Regulator Adj. 300mA Low Noise MSOP8 |
發布緊急采購，3分鐘左右您將得到回復。