參數資料
型號： LT1737IS
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： High Power Isolated Flyback Controller
中文描述： SWITCHING CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO16
封裝： 0.150 INCH, PLASTIC, SO-16
文件頁數： 19/28頁
文件大小： 320K
代理商： LT1737IS
19
LT1737
1737f
MAXIMUM LOAD/SHORT-CIRCUIT CONSIDERATIONS
The LT1737 is a current mode controller. It uses the V
C
node voltage as an input to a current comparator that turns
off the output switch on a cycle-by-cycle basis as this peak
current is reached. The internal clamp on the V
C
node,
nominally 2.5V, then acts as an output switch peak current
limit.
This 2.5V at the V
C
pin corresponds to a value of 250mV
at the I
SENSE
pin, when the (ON) switch duty cycle is less
than 40%. For a duty cycle above 40%, the internal slope
compensation mechanism lowers the effective I
SENSE
voltage limit. For example, at a duty cycle of 80%, the
nominal I
SENSE
voltage limit is 220mV. This action be-
comes the switch current limit specification. Maximum
available output power is then determined by the switch
current limit, which is somewhat duty cycle dependent
due to internal slope compensation action.
Overcurrent conditions are handled by the same mecha-
nism. The output switch turns on, the peak current is
quickly reached and the switch is turned off. Because the
output switch is only on for a small fraction of the available
period, power dissipation is controlled.
Loss of current limit is possible under certain conditions.
Remember that the LT1737 normally exhibits a minimum
switch on time, irrespective of current trip point. If the duty
cycle exhibited by this minimum on time is greater than the
ratio of secondary winding voltage (referred-to-primary)
divided by input voltage, then peak current will not be
controlled at the nominal value, and will cycle-by-cycle
ratchet up to some higher level. Expressed mathemati-
cally, the requirement to maintain short-circuit control is:
V
I
R
V
N
IN
SP
t
ON
= output switch minimum on time
f = switching frequency
I
SC
= short-circuit output current
V
F
= output diode forward voltage at I
SC
R
SEC
= resistance of transformer secondary
V
IN
= input voltage
N
SP
= secondary-to-primary turns ratio (N
SEC
/N
PRI
)
t
f
ON
F
SC
SEC
<
+
(
)
where
Trouble is typically only encountered in applications with
a relatively high product of input voltage times secondary-
to-primary turns ratio and/or a relatively long minimum
switch on time. (Additionally, several real world effects such
as transformer leakage inductance, AC winding losses, and
output switch voltage drop combine to make this simple
theoretical calculation a conservative estimate.)
THERMAL CONSIDERATIONS
Care should be taken to ensure that the worst-case input
voltage condition does not cause excessive die tempera-
tures. The 16-lead SO package is rated at 100
°
C/W, and
the 16-lead GN at 110
°
C/W.
Average supply current is simply the sum of quiescent
current given in the specifications section plus gate drive
current. Gate drive current can be computed as:
I
G
= f Q
G
where
Q
G
= total gate charge
f = switching frequency
(Note: Total gate charge is more complicated than C
GS
V
G
as it is frequently dominated by Miller effect of the C
GD
.
Furthermore, both capacitances are nonlinear in practice.
Fortunately, most MOSFET data sheets provide figures
and graphs which yield the total gate charge directly per
operating conditions.) Nearly all gate drive power is dissi-
pated in the IC, except for a small amount in the external
gate series resistor, so total IC dissipation may be com-
puted as:
P
D(TOTAL)
= V
CC
(I
Q
+ f Q
G
), where
I
Q
= quiescent current (from specifications)
Q
G
= total gate charge
f = switching frequency
V
CC
= LT1737 supply voltage
SWITCH NODE CONSIDERATIONS
For maximum efficiency, gate drive rise and fall times are
made as short as practical. To prevent radiation and high
frequency resonance problems, proper layout of the
components connected to the IC is essential, especially
APPLICATIOU
W
U
U
相關PDF資料
PDF描述
LT1737CGN High Power Isolated Flyback Controller
LT1737IGN High Power Isolated Flyback Controller
LT1737 High Power Switching Regulator for Isolated Flyback Controller(大功率，用于隔離回掃控制器的開關穩壓器)
LT1738 Slew Rate Controlled Ultralow Noise DC/DC Controller
LT1738EG Slew Rate Controlled Ultralow Noise DC/DC Controller
相關代理商/技術參數
參數描述
LT1737IS#PBF 功能描述:IC REG CTRLR FLYBK ISO CM 16SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LT1737IS#PBF 制造商:Linear Technology 功能描述:ICSMPS CONTROLLERCURRENT-MOD 制造商:Linear Technology 功能描述:IC,SMPS CONTROLLER,CURRENT-MODE,SOP,16PI
LT1737IS#TR 功能描述:IC REG CTRLR FLYBK ISO CM 16SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LT1737IS#TRPBF 功能描述:IC REG CTRLR FLYBK ISO CM 16SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR)
LT1738 制造商:LINER 制造商全稱:Linear Technology 功能描述:Slew Rate Controlled Ultralow Noise DC/DC Controller
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*