參數資料
型號： LT1715CMS#TRPBF
廠商： Linear Technology
文件頁數： 15/20頁
文件大?。?/td> 0K
描述： IC COMPARATOR 150MHZ DUAL 10MSOP
標準包裝： 2,500
系列： UltraFast™
類型： 通用
元件數： 2
輸出類型： CMOS，滿擺幅，TTL
電壓 - 電源，單路/雙路(±)： 2.7 V ~ 12 V
電壓 - 輸入偏移（最小值）： 2.5mV @ ±5V
電流 - 輸入偏壓（最小值）： 6µA @ ±5V
電流 - 輸出（標準）： 20mA
電流 - 靜態（最大值）： 2mA
CMRR, PSRR（標準）： 70dB CMRR，80dB PSRR
傳輸延遲（最大）： 9ns
磁滯： 6mV
工作溫度： 0°C ~ 70°C
封裝/外殼： 10-TFSOP，10-MSOP（0.118"，3.00mm 寬）
安裝類型： 表面貼裝
包裝： 帶卷 (TR)
LT1715
4
1715fa
ELECTRICAL CHARACTERISTICS
Input Offset and Trip Voltages
vs Supply Voltage
Input Offset and Trip Voltages
vs Temperature
Input Common Mode Limits
vs Temperature
SUPPLY VOLTAGE, VCC = +VS (V)
2.5
V
OS
AND
TRIP
POINT
VOLTAGE
(mV)
3
2
1
0
–1
–2
–3
4.0
5.0
1715 G01
3.0
3.5
4.5
5.5
6.0
VTRIP
+
VOS
VTRIP
–
TA = 25°C
VCM = 1V
VEE = GND
TEMPERATURE (°C)
–3
V
OS
AND
TRIP
POINT
VOLTAGE
(mV)
–1
1
3
–2
0
2
–20
20
60
100
1715 G02
140
–40
–60
0
40
80
120
VTRIP
+
VOS
VTRIP
–
+VS = VCC = 5V
VCM = 1V
VEE = –5V
TEMPERATURE (°C)
–50
3.6
3.8
4.2
25
75
1715 G03
–4.8
–5.0
–25
0
50
100
125
–5.2
–5.4
4.0
COMMON
MODE
INPUT
VOLTAGE
(V)
+VS = VCC = 5V
VEE = –5V
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: The LT1715C is guaranteed functional over the operating range of
–40°C to 85°C.
Note 3: The LT1715C is guaranteed to meet specied performance from
0°C to 70°C. The LT1715°C is designed, characterized and expected to
meet specied performance from –40°C to 85°C but is not tested or
QA sampled at these temperatures. The LT1715I is guaranteed to meet
specied performance from –40°C to 85°C. The LT1715H is guaranteed to
meet specied performance from –40°C to 125°C.
Note 4: Thermal resistances vary depending upon the amount of PC board
metal attached to Pin 5 of the device. θJA is specied for a 2500mm2 3/32"
FR-4 board covered with 2oz copper on both sides and with 100mm2 of
copper attached to Pin 5. Thermal performance can be improved beyond
the given specication by using a 4-layer board or by attaching more metal
area to Pin 5.
Note 5: If one input is within these common mode limits, the other input
can go outside the common mode limits and the output will be valid.
Note 6: The LT1715 comparator includes internal hysteresis. The trip
points are the input voltage needed to change the output state in each
direction. The offset voltage is dened as the average of VTRIP+ and VTRIP–,
while the hysteresis voltage is the difference of these two.
Note 7: The common mode rejection ratio is measured with VCC = 5V,
VEE = –5V and is dened as the change in offset voltage measured from
VCM = –5.1V to VCM = 3.8V, divided by 8.9V.
Note 8: The power supply rejection ratio is measured with VCM = 1V and is
dened as the worst of: the change in offset voltage from VCC = +VS = 2.7V
to VCC = +VS = 6V (with VEE = 0V) divided by 3.3V or the change in offset
voltage from VEE = 0V to VEE = –6V (with VCC = +VS = 6V) divided by 6V.
Note 9: Because of internal hysteresis, there is no small-signal region in
which to measure gain. Proper operation of internal circuity is ensured by
measuring VOH and VOL with only 20mV of overdrive.
Note 10: Maximum toggle rate is dened as the highest frequency at
which a 100mV sinusoidal input results in an error free output toggling to
greater than 4V when high and to less than 1V when low on a 5V output
supply.
Note 11: Propagation delay measurements made with 100mV steps.
Overdrive is measured relative to VTRIP±.
Note 12: tPD cannot be measured in automatic handling equipment with
low values of overdrive. The LT1715 is 100% tested with a 100mV step
and 20mV overdrive. Correlation tests have shown that tPD limits can be
guaranteed with this test.
Note 13: Propagation Delay Skew is dened as:
tSKEW = |tPDLH – tPDHL|
Note 14: Differential propagation delay is dened as the larger of the two:
ΔtPDLH = |tPDLHA – tPDLHB|
ΔtPDHL = |tPDHLA – tPDHLB|
Note 15: Package inductances combined with asynchronous activity on
the other channel can increase the output jitter. See Channel Interactions
in Applications Information. Specication above is with one channel active
only.
TYPICAL PERFORMANCE CHARACTERISTICS
相關PDF資料
PDF描述
VE-2VL-IX-B1 CONVERTER MOD DC/DC 28V 75W
LTC1403CMSE#PBF IC ADC 12BIT 2.8MSPS 10-MSOP
LT1715CMS#TR IC COMPARATOR 150MHZ DUAL 10MSOP
AD7797BRUZ IC ADC 24BIT SIG-DEL 1CH 16TSSOP
VE-2VK-IX-B1 CONVERTER MOD DC/DC 40V 75W
相關代理商/技術參數
參數描述
LT1715HMS#PBF 功能描述:IC COMP DUAL 150MHZ 4NS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:UltraFast™ 標準包裝:1 系列:- 類型:通用 元件數:1 輸出類型:CMOS，開路集電極，TTL 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V 電壓 - 輸入偏移（最小值）:7mV @ 5V 電流 - 輸入偏壓（最小值）:0.25µA @ 5V 電流 - 輸出（標準）:84mA @ 5V 電流 - 靜態（最大值）:120µA CMRR, PSRR（標準）:- 傳輸延遲（最大）:600ns 磁滯:- 工作溫度:-40°C ~ 85°C 封裝/外殼:SC-74A，SOT-753 安裝類型:表面貼裝 包裝:剪切帶 (CT) 產品目錄頁面:1268 (CN2011-ZH PDF) 其它名稱:*LMV331M5*LMV331M5/NOPBLMV331M5CT
LT1715HMS#PBF 制造商:Linear Technology 功能描述:IC, HIGH SPEED COMP, DUAL, 4NS, MSOP-10
LT1715HMS#TRPBF 功能描述:IC COMPARATOR 4NS DUAL 10-MSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:UltraFast™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:通用 元件數:1 輸出類型:CMOS，推挽式，滿擺幅，TTL 電壓 - 電源，單路/雙路(±):2.5 V ~ 5.5 V，±1.25 V ~ 2.75 V 電壓 - 輸入偏移（最小值）:5mV @ 5.5V 電流 - 輸入偏壓（最小值）:1pA @ 5.5V 電流 - 輸出（標準）:- 電流 - 靜態（最大值）:24µA CMRR, PSRR（標準）:80dB CMRR，80dB PSRR 傳輸延遲（最大）:450ns 磁滯:±3mV 工作溫度:-40°C ~ 85°C 封裝/外殼:6-WFBGA，CSPBGA 安裝類型:表面貼裝 包裝:管件 其它名稱:Q3554586
LT1715HMSPBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:4ns, 150MHz Dual Comparator with Independent Input/Output Supplies
LT1715HMSTRPBF 制造商:LINER 制造商全稱:Linear Technology 功能描述:4ns, 150MHz Dual Comparator with Independent Input/Output Supplies
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*