- 您現在的位置：買賣IC網 > PDF目錄377708 > LT1578IS8-2.5 (LINEAR TECHNOLOGY CORP) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | LT1578IS8-2.5 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | SWITCHING REGULATOR, 240 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | 0.150 INCH, PLASTIC, SO-8 |
| 文件頁數： | 9/28頁 |
| 文件大?。?/td> | 286K |
| 代理商： | LT1578IS8-2.5 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
9
LT1578/LT1578-2.5
APPLICATIO
S I
FOR
ATIO
U
In addition to lower switching frequency, the LT1578 also
operates at lower switch current limit when the feedback
pin voltage drops below 0.7V. Q2 in Figure 2 performs this
function by clamping the V
C
pin to a voltage less than its
normal 2.1V upper clamp level. This foldback current imit
greatly reduces power dissipation in the IC, diode and
inductor during short-circuit conditions. External synchro-
nization is also disabled to prevent interference with
foldback operation. Again, it is nearly transparent to the
user under normal load conditions. The only loads that may
be affected are current sources, such as lamps and mo-
tors, that maintain high load current with output voltage
less than 50% of final value. In these rare situations the
feedback pin can be clamped above 0.7V to defeat foldback
current limit. Caution:clamping the feedback pin means
that frequency shifting will also be defeated, so a combina-
tion of high input voltage and dead shorted output may
cause the LT1578 to lose control of current limit.
The internal circuitry which forces reduced switching
frequency also causes current to flow out of the feedback
pin when output voltage is low. The equivalent circuitry is
shown in Figure 2. Q1 is completely off during normal
operation. If the FB pin falls below 0.7V, Q1 begins to
conduct current and reduces frequency at the rate of
approximately 1kHz/
μ
A. To ensure adequate frequency
foldback (under worst-case short-circuit conditions), the
external divider Thevinin resistance must be low enough
to pull 35
μ
A out of the FB pin with 0.5V on the pin (R
DIV
≤
14.3k). The net result is that reductions in frequency and
current limit are affected by output voltage divider imped-
ance. Although divider impedance is not critical, caution
should be used if resistors are increased beyond the
suggested values and short-circuit conditions will occur
with high input voltage High frequency pickup will
increase and the protection accorded by frequency and
current foldback will decrease.
W
U
U
MAXIMUM OUTPUT LOAD CURRENT
Maximum load current for a buck converter is limited by
the maximum switch current rating (I
P
) of the LT1578.
This current rating is 1.5A up to 50% duty cycle (DC),
decreasing to 1.3A at 80% duty cycle. This is shown
graphically in Typical Performance Characteristics and as
shown in the formula below:
I
P
= 1.5A for DC
≤
50%
I
P
= 1.67 – 0.18 (DC) – 0.32(DC)
2
for 50% < DC < 90%
DC = Duty cycle = V
OUT
/V
IN
Example: with V
OUT
= 5V, V
IN
= 8V; DC = 5/8 = 0.625, and;
I
SW(MAX)
= 1.67 – 0.18 (0.625) – 0.32(0.625)
2
= 1.43A
Current rating decreases with duty cycle because the
LT1578 has internal slope compensation to prevent cur-
rent mode subharmonic switching. For more details, read
Application Note 19. The LT1578 is a little unusual in this
regard because it has nonlinear slope compensation which
gives better compensation with less reduction in current
limit.
Maximum load current would be equal to maximum
switch current for an infinitely large inductor but with
finite inductor size, maximum load current is reduced by
one-half peak-to-peak inductor current. The following
formula assumes continuous mode operation, implying
that the term on the right is less than one-half of I
P
.
I
OUT(MAX)
=
Continuous Mode
For the conditions above and L = 15
μ
H,
I
A
OUT MAX
)
=
( )
(
)
( )
=
1 43
2 15 10
200 10
8
1 43 0 31 1 12
6
3
At V
IN
= 15V, duty cycle is 33%, so I
P
is just equal to a fixed
1.5A, and I
OUT(MAX)
is equal to:
( )
=
=
A
1 5
5 15 5
(
2 15 10
200 10
15
1 5 0 56
0 94
6
3
)
( )
I
P
(
)
L f V
(
)
( )( )( )
V
V
V
OUT
2
IN
OUT
IN
相關PDF資料 |
PDF描述 |
|---|---|
| LT1578C | CAP 22UF 50V ELECT TG SMD |
| LT1578CS8 | CAP 47UF 50V ELECT TG SMD |
| LT1578CS8-2.5 | CAP 10UF 63V ELECT TG SMD |
| LT1578I | CAP 22UF 63V ELECT TG SMD |
| LT1578 | 1.5A, 200kHz Step-Down Switching Regulator(1.5A, 200kHz，步降開關穩壓器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1579 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:300mA Dual Input Smart Battery Backup Regulator |
| LT1579-3 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:300mA Dual Input Smart Battery Backup Regulator |
| LT1579CGN | 功能描述:IC LDO REG SMART DUAL ADJ 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:2,000 系列:Impedance Track™ 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.4 V ~ 2.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:20-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:20-TSSOP 包裝:帶卷 (TR) 產品目錄頁面:1020 (CN2011-ZH PDF) 配用:BQ27350EVM-ND - BQ27350EVM 其它名稱:296-21665-2 |
| LT1579CGN#PBF | 功能描述:IC LDO REG SMART DUAL ADJ 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:2,000 系列:Impedance Track™ 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.4 V ~ 2.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:20-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:20-TSSOP 包裝:帶卷 (TR) 產品目錄頁面:1020 (CN2011-ZH PDF) 配用:BQ27350EVM-ND - BQ27350EVM 其它名稱:296-21665-2 |
| LT1579CGN#TR | 功能描述:IC REG LDO SMART DUAL ADJ 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。