參數資料
型號: LPC3220FET296
廠商: NXP SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: ARM926EJ-S with 128 kB SRAM, USB High-speed OTG, SD-MMC, NAND flash controller
中文描述: 32-BIT, FLASH, 266 MHz, RISC MICROCONTROLLER, PBGA296
封裝: 15 X 15 MM, 0.70 MM PITCH, PLASTIC, MO-216, SOT1048-1, TFBGA-296
文件頁數: 34/79頁
文件大?。?/td> 599K
代理商: LPC3220FET296
LPC3220_30_40_50
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 2 — 20 October 2011
34 of 79
NXP Semiconductors
LPC3220/30/40/50
16/32-bit ARM microcontrollers
7.7 System functions
To enhance the performance of the LPC3220/30/40/50 incorporates the following system
functions, an Interrupt Controller (INTC), a watchdog timer, a millisecond timer, and
several power control features. These functions are described in the following sections
7.7.1
Interrupt controller
The interrupt controller is comprised of three basic interrupt controller blocks, supporting a
total of 73 interrupt sources. Each interrupt source can be individually enabled/disabled
and configured for high or low level triggering, or rising or falling edge triggering. Each
interrupt may also be steered to either the FIQ or IRQ input of the ARM9. Raw interrupt
status and masked interrupt status registers allow versatile condition evaluation. In
addition to peripheral functions, each of the six general purpose input/output pins and
12 of the 22 general purpose input pins are connected directly to the interrupt controller.
7.7.2
Watchdog timer
The watchdog timer block is clocked by the main peripheral clock, which clocks a 32-bit
counter. A match register is compared to the Timer. When configured for watchdog
functionality, a match drives the match output low. The match output is gated with an
enable signal that gives the opportunity to generate two type of reset signal: one that only
resets chip internally, and another that goes through a programmable pulse generator
before it goes to the external pin RESOUT and to the internal chip reset.
7.7.2.1
Features
Programmable 32-bit timer.
Internally resets the device if not periodically reloaded.
Flag to indicate that a watchdog reset has occurred.
Programmable watchdog pulse output on RESOUT pin.
Can be used as a standard timer if watchdog is not used.
Pause control to stop counting when core is in debug state.
7.7.3
Millisecond timer
The millisecond timer is clocked by 32 kHz RTC clock, so a prescaler is not needed to
obtain a lower count rate.
The millisecond timer includes three match registers that are compared to the
Timer/Counter value. A match can generate an interrupt and the cause the Timer/Counter
either continue to run, stop, or be reset.
7.7.3.1
Features
32-bit Timer/Counter, running from the 32 kHz RTC clock.
Counter or Timer operation.
Three 32-bit match registers that allow:
Continuous operation with optional interrupt generation on match.
Stop timer on match with optional interrupt generation.
Reset timer on match with optional interrupt generation.
Pause control to stop counting when core is in debug state.
相關PDF資料
PDF描述
LPC3230FET296 ARM926EJ-S with 256 kB SRAM, USB High-speed OTG, SD-MMC, NAND flash controller, LCD controller
LPC3240FET296 ARM926EJ-S with 256 kB SRAM, USB High-speed OTG, SD-MMC, NAND flash controller, Ethernet
LPV531 Programmable Micropower CMOS Input, Rail-to-Rail Output Operational Amplifier
LPV531MK Programmable Micropower CMOS Input, Rail-to-Rail Output Operational Amplifier
LPV531MKX Programmable Micropower CMOS Input, Rail-to-Rail Output Operational Amplifier
相關代理商/技術參數
參數描述
LPC3220FET296,551 功能描述:ARM微控制器 - MCU ARM9 128KRAM VFP USB OTG RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC3220FET296/01,5 功能描述:ARM微控制器 - MCU ARM9 VFP USB OTG Improved LCD RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC3220FET296/01,551 制造商:NXP Semiconductors 功能描述:0
LPC3230 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; hardware floating-point coprocessor, USB On-The-Go, and EMC memory interface
LPC3230FET296 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; hardware floating-point coprocessor, USB On-The-Go, and EMC memory interface