- 您現在的位置：買賣IC網 > PDF目錄385498 > LPC3220FET296 (NXP SEMICONDUCTORS) ARM926EJ-S with 128 kB SRAM, USB High-speed OTG, SD-MMC, NAND flash controller PDF資料下載
參數資料
| 型號： | LPC3220FET296 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | ARM926EJ-S with 128 kB SRAM, USB High-speed OTG, SD-MMC, NAND flash controller |
| 中文描述： | 32-BIT, FLASH, 266 MHz, RISC MICROCONTROLLER, PBGA296 |
| 封裝： | 15 X 15 MM, 0.70 MM PITCH, PLASTIC, MO-216, SOT1048-1, TFBGA-296 |
| 文件頁數： | 30/79頁 |
| 文件大小： | 599K |
| 代理商： | LPC3220FET296 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁
LPC3220_30_40_50
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 2 — 20 October 2011
30 of 79
NXP Semiconductors
LPC3220/30/40/50
16/32-bit ARM microcontrollers
–
extended wait
Power-saving modes dynamically control EMC_CKE[1:0] and EMC_CLK.
Dynamic memory self-refresh mode supported by software.
Controller supports 2 k, 4 k, and 8 k row address synchronous memory parts. That is,
typical 512 MB, 256 MB, 128 MB, and 16 MB parts, with 8, 16, or 32 data bits per
device.
Two reset domains enable dynamic memory contents to be preserved over a soft
reset.
This controller does not support synchronous static memory devices (burst mode
devices).
7.6 AHB master peripherals
The LPC3220/30/40/50 implements four AHB master peripherals, which include a
General Purpose Direct Memory Access (GPDMA) controller, a 10/100 Ethernet Media
Access Controller (MAC), a Universal Serial Bus (USB) controller, and an LCD controller.
Each of these four peripherals contain an integral DMA controller optimized to support the
performance demands of the peripheral.
7.6.1
General Purpose DMA (GPDMA) controller
The GPDMA controller allows peripheral-to memory, memory-to-peripheral,
peripheral-to-peripheral, and memory-to-memory transactions. Each DMA stream
provides unidirectional serial DMA transfers for a single source and destination. For
example, a bidirectional port requires one stream for transmit and one for receive. The
source and destination areas can each be either a memory region or a peripheral, and
can be accessed through the same AHB master, or one area by each master. The DMA
controller supports the following peripheral device transfers.
Secure Digital (SD) Memory interface
High-speed UARTs
I
2
S0 and I
2
S1 ports
SPI1 and SPI2 interfaces
SSP0 and SSP1 interfaces
Memory
The DMA controls eight DMA channels with hardware prioritization. The DMA controller
interfaces to the system via two AHB bus masters, each with a full 32-bit data bus width.
DMA operations may be set up for 8-bit, 16-bit, and 32-bit data widths, and can be either
big-endian or little-endian. Incrementing or non-incrementing addressing for source and
destination are supported, as well as programmable DMA burst size. Scatter or gather
DMA is supported through the use of linked lists. This means that the source and
destination areas do not have to occupy contiguous areas of memory.
7.6.2
Ethernet MAC
The Ethernet block contains a full featured 10 Mbit/s or 100 Mbit/s Ethernet MAC
designed to provide optimized performance through the use of DMA hardware
acceleration. Features include a generous suite of control registers, half or full duplex
operation, flow control, control frames, hardware acceleration for transmit retry, receive
相關PDF資料 |
PDF描述 |
|---|---|
| LPC3230FET296 | ARM926EJ-S with 256 kB SRAM, USB High-speed OTG, SD-MMC, NAND flash controller, LCD controller |
| LPC3240FET296 | ARM926EJ-S with 256 kB SRAM, USB High-speed OTG, SD-MMC, NAND flash controller, Ethernet |
| LPV531 | Programmable Micropower CMOS Input, Rail-to-Rail Output Operational Amplifier |
| LPV531MK | Programmable Micropower CMOS Input, Rail-to-Rail Output Operational Amplifier |
| LPV531MKX | Programmable Micropower CMOS Input, Rail-to-Rail Output Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC3220FET296,551 | 功能描述:ARM微控制器 - MCU ARM9 128KRAM VFP USB OTG RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC3220FET296/01,5 | 功能描述:ARM微控制器 - MCU ARM9 VFP USB OTG Improved LCD RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC3220FET296/01,551 | 制造商:NXP Semiconductors 功能描述:0 |
| LPC3230 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; hardware floating-point coprocessor, USB On-The-Go, and EMC memory interface |
| LPC3230FET296 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; hardware floating-point coprocessor, USB On-The-Go, and EMC memory interface |
發布緊急采購，3分鐘左右您將得到回復。