- 您現在的位置：買賣IC網 > PDF目錄1932 > LPC2106FBD48,151 (NXP Semiconductors)IC ARM7 MCU FLASH 128K 48-LQFP PDF資料下載
參數資料
| 型號： | LPC2106FBD48,151 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 14/41頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ARM7 MCU FLASH 128K 48-LQFP |
| 標準包裝： | 250 |
| 系列： | LPC2100 |
| 核心處理器： | ARM7 |
| 芯體尺寸： | 16/32-位 |
| 速度： | 60MHz |
| 連通性： | I²C，Microwire，SPI，SSI，SSP，UART/USART |
| 外圍設備： | POR，PWM，WDT |
| 輸入/輸出數： | 32 |
| 程序存儲器容量： | 128KB（128K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 64K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 1.65 V ~ 3.6 V |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 48-LQFP |
| 包裝： | 托盤 |
| 配用： | 622-1019-ND - BOARD FOR LPC2106 48-LQFP 622-1008-ND - BOARD FOR LPC9103 10-HVSON 568-1756-ND - BOARD EVAL FOR LPC210X ARM MCU |
| 其它名稱： | 568-1890 935275298151 LPC2106FBD48-S |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
LPC2104_2105_2106_7
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 07 — 20 June 2008
21 of 41
NXP Semiconductors
LPC2104/2105/2106
Single-chip 32-bit microcontrollers
With double edge controlled PWM outputs, specic match registers control the rising and
falling edge of the output. This allows both positive going PWM pulses (when the rising
edge occurs prior to the falling edge), and negative going PWM pulses (when the falling
edge occurs prior to the rising edge).
6.17.1 Features
Seven match registers allow up to six single edge controlled or three double edge
controlled PWM outputs, or a mix of both types.
The match registers also allow:
– Continuous operation with optional interrupt generation on match.
– Stop timer on match with optional interrupt generation.
– Reset timer on match with optional interrupt generation.
Supports single edge controlled and/or double edge controlled PWM outputs. Single
edge controlled PWM outputs all go HIGH at the beginning of each cycle unless the
output is a constant LOW. Double edge controlled PWM outputs can have either edge
occur at any position within a cycle. This allows for both positive going and negative
going pulses.
Pulse period and width can be any number of timer counts. This allows complete
exibility in the trade-off between resolution and repetition rate. All PWM outputs will
occur at the same repetition rate.
Double edge controlled PWM outputs can be programmed to be either positive going
or negative going pulses.
Match register updates are synchronized with pulse outputs to prevent generation of
erroneous pulses. Software must “release” new match values before they can become
effective.
May be used as a standard timer if the PWM mode is not enabled.
A 32-bit Timer/Counter with a programmable 32-bit Prescaler.
6.18 System control
6.18.1 Crystal oscillator
The oscillator supports crystals in the range of 1 MHz to 25 MHz. The oscillator output
frequency is called FOSC and the ARM processor clock frequency is referred to as CCLK
for purposes of rate equations, etc. FOSC and CCLK are the same value unless the PLL
is running and connected. Refer to Section 6.18.2 “PLL” for additional information.
6.18.2 PLL
The PLL accepts an input clock frequency in the range of 10 MHz to 25 MHz. The input
frequency is multiplied up into the range of 10 MHz to 60 MHz with a Current Controlled
Oscillator (CCO). The multiplier can be an integer value from 1 to 32 (in practice, the
multiplier value cannot be higher than 6 on this family of microcontrollers due to the upper
frequency limit of the CPU). The CCO operates in the range of 156 MHz to 320 MHz, so
there is an additional divider in the loop to keep the CCO within its frequency range while
the PLL is providing the desired output frequency. The output divider may be set to divide
相關PDF資料 |
PDF描述 |
|---|---|
| LPC2292FBD144,551 | IC ARM7 MCU FLASH 256K 144-LQFP |
| LPC3240FET296,551 | IC ARM9 MCU 256K 296-TFBGA |
| LT1025ACN8 | IC THERMO COMPNSATR MICRPWR 8DIP |
| LT1030CS#PBF | IC LINE DRVR LOWPWR QUAD 14-SOIC |
| LT1032IN#PBF | IC LINE DRIVER LOWPWR QUAD 14DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC2106FHN48 | 制造商:NXP Semiconductors 功能描述:IC MCU ARM7 FLASH SMD HVQFN-48 制造商:NXP Semiconductors 功能描述:IC, MCU ARM7 FLASH, SMD, HVQFN-48 制造商:NXP Semiconductors 功能描述:MCU 16-Bit/32-Bit LPC2000 ARM7TDMI-S RISC 128KB Flash 1.8V/3.3V 48-Pin HVQFN EP Tray |
| LPC2106FHN48,551 | 功能描述:ARM微控制器 - MCU ARM7 128KF/64KR/I2C RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2106FHN48/00 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single-chip 32-bit microcontrollers; 128 kB ISP/IAP flash with 16/32/64 kB RAM |
| LPC2106FHN48/01 | 制造商:NXP Semiconductors 功能描述:MCU, 16BIT/32BIT, 60MHZ, HVQFN-48 制造商:NXP Semiconductors 功能描述:MCU, 16BIT/32BIT, 60MHZ, HVQFN-48, Controller Family/Series:LPC2100, Core Size:1 制造商:NXP Semiconductors 功能描述:MCU, 16BIT/32BIT, 60MHZ, HVQFN-48, Controller Family/Series:LPC2100, Core Size:16bit / 32bit, No. of I/O's:32, Supply Voltage Min:1.65V, Supply Voltage Max:1.95V, Digital IC Case Style:HVQFN, No. of Pins:48, Program Memory |
| LPC2106FHN48/01,55 | 功能描述:ARM微控制器 - MCU 128K FL/64K RAM/2 UART/I2C/SPI RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。