參數資料
型號: LPC11U12FBD48
廠商: NXP Semiconductors N.V.
元件分類: 32位微控制器
英文描述: 32-bit ARM Cortex-M0 microcontroller; up to 16 kB flash; 6 kB SRAM; USB device; USART; 2 SSPs
中文描述: 32位ARM的Cortex-M0微控制器;最大16kB閃存;6kB 靜態隨機存儲器;USB驅動;通用同步/異步串行接收/發送器;2個同步串行接口控制器
封裝: LPC11U12FBD48/201<SOT313-2 (LQFP48)|<<http://www.nxp.com/packages/SOT313-2.html<1<Always Pb-free,;
文件頁數: 53/64頁
文件大?。?/td> 898K
代理商: LPC11U12FBD48
LPC11U1X
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Objective data sheet
Rev. 1 — 11 April 2011
53 of 64
NXP Semiconductors
LPC11U1x
32-bit ARM Cortex-M0 microcontroller
In slave mode the input clock signal should be coupled by means of a capacitor of 100 pF
(
Figure 28
), with an amplitude between 200 mV(RMS) and 1000 mV(RMS). This
corresponds to a square wave signal with a signal swing of between 280 mV and 1.4 V.
The XTALOUT pin in this configuration can be left unconnected.
External components and models used in oscillation mode are shown in
Figure 29
and in
Table 18
and
Table 19
. Since the feedback resistance is integrated on chip, only a crystal
and the capacitances C
X1
and C
X2
need to be connected externally in case of
fundamental mode oscillation (the fundamental frequency is represented by L, C
L
and
R
S
). Capacitance C
P
in
Figure 29
represents the parallel package capacitance and should
not be larger than 7 pF. Parameters F
OSC
, C
L
, R
S
and C
P
are supplied by the crystal
manufacturer.
Table 18.
Fig 28. Slave mode operation of the on-chip oscillator
Fig 29. Oscillator modes and models: oscillation mode of operation and external crystal
model used for C
X1
/C
X2
evaluation
Recommended values for C
X1
/C
X2
in oscillation mode (crystal and external
components parameters) low frequency mode
Fundamental oscillation
frequency F
OSC
capacitance C
L
1 MHz - 5 MHz
10 pF
20 pF
30 pF
Crystal load
Maximum crystal
series resistance R
S
< 300
Ω
< 300
Ω
< 300
Ω
External load
capacitors C
X1
, C
X2
18 pF, 18 pF
39 pF, 39 pF
57 pF, 57 pF
LPC1xxx
XTALIN
Ci
100 pF
Cg
002aae788
002aaf424
LPC1xxx
XTALIN
XTALOUT
CX2
CX1
XTAL
=
CL
CP
RS
L
相關PDF資料
PDF描述
LPCXpresso
LPD-1 Phase Detectors 1000mV DC output , + 7dBmRF
LPDA-8003 LPDA-8003 Log Periodic Dipole Antenna
lpm-abs Parameteruzed Absolute Value(參數確定的絕對值器件)
lpm-add-sub Parameteruzed Adder/Subtractor(參數確定的加法器/減法器)
相關代理商/技術參數
參數描述
LPC11U12FBD48.201 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:32-bit ARM Cortex-M0 microcontroller; up to 32 kB flash; 6 kB SRAM; USB device; USART
LPC11U12FBD48/201 制造商:NXP Semiconductors 功能描述:MCU 32BIT 16K FLASH 48LQFP
LPC11U12FBD48/201, 功能描述:ARM微控制器 - MCU 32-bit ARM Cortex-M0 MCU RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC11U12FHN201 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:32-bit ARM Cortex-M0 microcontroller; up to 32 kB flash; 6 kB SRAM; USB device; USART
LPC11U12FHN33 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-cost Cortex-M0 USB solutions with Smart Card interface