- 您現在的位置：買賣IC網 > PDF目錄67757 > LNBH221PD-TR (STMICROELECTRONICS) 0.75 A DUAL SWITCHING CONTROLLER, PDSO36 PDF資料下載
參數資料
| 型號： | LNBH221PD-TR |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.75 A DUAL SWITCHING CONTROLLER, PDSO36 |
| 封裝： | POWER, SO-36 |
| 文件頁數： | 6/29頁 |
| 文件大?。?/td> | 800K |
| 代理商： | LNBH221PD-TR |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
LNBH221 software description (same for both section)
LNBH221
14/27
6.3
Transmitted data (I2C BUS write mode)
When the R/W bit in the chip address is set to 0, the main P can write on the System
Register (SR) of the LNBH221 via I2C bus. Only 6 bits out of the 8 available can be written
by the P, since the remaining 2 are left to the diagnostic flags, and are read-only.
X= don't care.
Values are typical unless otherwise specified.
6.4
Received data (I2C bus READ MODE)
The LNBH221 can provide to the Master a copy of the SYSTEM REGISTER information via
I2C bus in read mode. The read mode is Master activated by sending the chip address with
R/W bit set to 1.
At the following master generated clocks bits, the LNBH221 issues a byte on the SDA data
bus line (MSB transmitted first).
At the ninth clock bit the MCU master can:
- acknowledge the reception, starting in this way the transmission of another byte from the
LNBH221;
- no acknowledge, stopping the read mode communication.
While the whole register is read back by the P, only the two read-only bits OLF and OTF
convey diagnostic informations about the LNBH221.
Values are typical unless otherwise specified.
PCL
TTX
TEN
LLC VSEL
EN
OTF
OLF
Function
001
X
VOUT=13.25V, VUP=15.25V
011
X
VOUT=18V, VUP=20V
101
X
VOUT=14.25V, VUP=16.25V
111
X
VOUT=19.5V, VUP=21.5V
0
1
X
22KHz tone is controlled by DSQIN pin
1
X
22KHz tone is ON, DSQIN pin disabled
01
X
VORX output is ON, output voltage controlled by VSEL
and LLC
1X
X
VOTX output is ON, 22KHz controlled by DSQIN or TEN,
output voltage level controlled by VSEL and LLC
0
1
X
Pulsed (dynamic) current limiting is selected
1
X
Static current limiting is selected
XXXX
X
0
XX
Power blocks disabled
PCL
ISEL
TEN
LLC VSEL
EN
OTF
OLF
Function
These bits are read exactly the same as
they were left after last write operation
0TJ<140°C, normal operation
1TJ>150°C, power block disabled
0IOUT<IOMAX, normal operation
1IOUT>IOMAX, overload protection triggered
相關PDF資料 |
PDF描述 |
|---|---|
| LNK574DG | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| LPY403ALTR | SPECIALTY ANALOG CIRCUIT, PBGA28 |
| LPY403AL | SPECIALTY ANALOG CIRCUIT, PBGA28 |
| LPY450ALTR | SPECIALTY ANALOG CIRCUIT, PBCC28 |
| LPY450AL | SPECIALTY ANALOG CIRCUIT, PBCC28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LNBH23 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:LNBs supply and control IC with step-up and IC interface |
| LNBH23LQTR | 功能描述:直流/直流開關轉換器 LNB SUPP/CNTRL IC WITH STEP UP RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| LNBH23PPR | 功能描述:其他電源管理 LNB supply and control IC RoHS:否 制造商:Texas Instruments 輸出電壓范圍: 輸出電流:4 mA 輸入電壓范圍:3 V to 3.6 V 輸入電流: 功率耗散: 工作溫度范圍:- 40 C to + 110 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-48 封裝:Reel |
| LNBH23PPR-CUT TAPE | 制造商:ST 功能描述:LNBH23 Series 15 V 1 A LNB Supply Step-Up I? Interface Controller - PowerSSO-24 |
| LNBH23QTR | 功能描述:IC LNB SUPPLY/CTRL DUAL 32QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:2,000 系列:- 應用:控制器，DSP 輸入電壓:4.5 V ~ 25 V 輸出數:2 輸出電壓:最低可調至 1.2V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:30-TFSOP（0.173"，4.40mm 寬） 供應商設備封裝:30-TSSOP 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。