- 您現在的位置：買賣IC網 > PDF目錄361044 > LMX2531LQ1910E (NATIONAL SEMICONDUCTOR CORP) PLLatinum High Performance Frequency Synthesizer System with Integrated VCO PDF資料下載
參數資料
| 型號： | LMX2531LQ1910E |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | XO, clock |
| 英文描述： | PLLatinum High Performance Frequency Synthesizer System with Integrated VCO |
| 中文描述： | PLL FREQUENCY SYNTHESIZER, 80 MHz, QCC36 |
| 封裝： | 6 X 6 MM, 0.80 MM HEIGHT, LEAD FREE, LLP-36 |
| 文件頁數： | 3/25頁 |
| 文件大?。?/td> | 589K |
| 代理商： | LMX2531LQ1910E |
Pin Descriptions
Pin
Number
Pin Name
I/O Description
1
VccDIG
-
Power Supply for digital LDO circuitry. Input may range from 2.8 - 3.2 V. Bypass capacitors should be
placed as close as possible to this pin and ground.
Ground
3
GND
-
2,4,5,7,
12,
13,
29, 35
6
NC
-
No Connect.
VregBUF
-
Internally regulated voltage for the VCO buffer circuitry. Connect to ground with a capacitor.
MICROWIRE serial data input. High impedance CMOS input. This pin must not exceed 2.75V. Data is
clocked in MSB first. The last bits clocked in form the control or register select bits.
MICROWIRE clock input. High impedance CMOS input. This pin must not exceed 2.75V. Data is
clocked into the shift register on the rising edge.
MICROWIRE Latch Enable input. High impedance CMOS input. This pin must not exceed 2.75V.
Data stored in the shift register is loaded into the selected latch register when LE goes HIGH.
Chip Enable Input. High impedance CMOS input. This pin must not exceed 2.75V. When CE is
brought high the LMX2531 is powered up corresponding to the internal power control bits. It is
necessary to reprogram the R0 register to get the part to re-lock.
No Connect. Do NOT ground.
Power Supply for VCO regulator circuitry. Input may range from 2.8 - 3.2 V. Bypass capacitors should
be placed as close as possible to this pin and ground.
Internally regulated voltage for VCO circuitry. Not intended to drive an external load. Connect to
ground with a capacitor and some series resistance.
Internal reference voltage for VCO LDO. Not intended to drive an external load. Connect to ground
with a capacitor.
Ground for the VCO circuitry.
Ground for the RF Output Buffer circuitry.
O Buffered RF Output for the VCO.
Power Supply for the VCO Buffer circuitry. Input may range from 2.8 - 3.2 V. Bypass capacitors
should be placed as close as possible to this pin and ground.
Tuning voltage input for the VCO. For connection to the CPout Pin through an external passive loop
filter.
O Charge pump output for PLL. For connection to Vtune through an external passive loop filter.
O An open drain NMOS output which is used for FastLock or a general purpose output.
Internally regulated voltage for PLL charge pump. Not intended to drive an external load. Connect to
ground with a capacitor.
Power Supply for the PLL. Input may range from 2.8 - 3.2 V. Bypass capacitors should be placed as
close as possible to this pin and ground.
Internally regulated voltage for RF digital circuitry. Not intended to drive an external load. Connect to
ground with a capacitor.
O Multiplexed CMOS output. Typically used to monitor PLL lock condition.
I
Oscillator input. The oscillator can be placed in either single-ended or differential mode of operation.
Oscillator complimentary input. When a single ended source is used, then a bypass capacitor should
be placed as close as possible to this pin and be connected to ground.
O This pin if for test purposes and should be grounded for normal operation.
-
Ground
-
Internally regulated voltage for LDO digital circuitry.
8
DATA
I
9
CLK
I
10
LE
I
11
CE
I
14, 15
NC
-
16
VccVCO
-
17
VregVCO
-
18
VrefVCO
-
19
20
21
GND
GND
Fout
-
-
22
VccBUF
-
23
Vtune
I
24
25
CPout
FLout
26
VregPLL1
-
27
VccPLL
-
28
VregPLL2
-
30
31
Ftest/LD
OSCin
32
OSCin*
I
33
34
36
Test
GND
VregDIG
L
www.national.com
3
相關PDF資料 |
PDF描述 |
|---|---|
| LMX2531LQ1700E | PLLatinum High Performance Frequency Synthesizer System with Integrated VCO |
| LMX4268 | Radio Transceiver for DECT |
| LMX5080MX | PLLatinum⑩ 2.7 GHz Low Power Dual Modulus Prescaler for RF Personal Communications |
| LMX5080M | PLLatinum⑩ 2.7 GHz Low Power Dual Modulus Prescaler for RF Personal Communications |
| LMX5080 | PLLatinum⑩ 2.7 GHz Low Power Dual Modulus Prescaler for RF Personal Communications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMX2531LQ1910E/NOPB | 功能描述:鎖相環 - PLL RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray |
| LMX2531LQ1950/NOPB | 功能描述:IC PLL FREQ SYNTH W/VCO 36-LLP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:PowerWise® 標準包裝:39 系列:- 類型:* PLL:帶旁路 輸入:時鐘 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:10 差分 - 輸入:輸出:是/是 頻率 - 最大:170MHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LMX2531LQ2010E/NOPB | 功能描述:IC PLL FREQ SYNTH W/VCO 36-LLP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:PowerWise® 標準包裝:39 系列:- 類型:* PLL:帶旁路 輸入:時鐘 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:10 差分 - 輸入:輸出:是/是 頻率 - 最大:170MHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LMX2531LQ2080E | 制造商:Texas Instruments 功能描述:PLL Frequency Synthesizer Single 1904MHz to 2274MHz 36-Pin LLP EP T/R |
| LMX2531LQ2080E/NOPB | 功能描述:時鐘合成器/抖動清除器 HIGH PERF FREQUENCY SYNTHESIZER SYSTEM RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。