- 您現在的位置：買賣IC網 > PDF目錄358877 > LM95010CIMM (NATIONAL SEMICONDUCTOR CORP) Digital Temperature Sensor with SensorPath⑩ Bus in MSOP8 Package PDF資料下載
參數資料
| 型號： | LM95010CIMM |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 溫度/濕度傳感器 |
| 英文描述： | Digital Temperature Sensor with SensorPath⑩ Bus in MSOP8 Package |
| 中文描述： | DIGITAL TEMP SENSOR-SERIAL, 10BIT(s), 2Cel, SQUARE, SURFACE MOUNT |
| 封裝： | MO-187, MSOP-8 |
| 文件頁數： | 15/19頁 |
| 文件大小： | 275K |
| 代理商： | LM95010CIMM |
2.0 Register Set
(Continued)
Bit
1
Type
R/W
Description
Shutdown (Shutdown Mode).
When set to "1" this bit stops the operation of all functions and places the
device in the lowest power consumption mode.
0: Device in Active Mode. (default)
1: Device in Shutdown Mode.
LowPwr (Low-Power Mode).
When set to "1" this bit slows the operation of all functions and places the
device in a low power consumption mode. In Low-Power Mode, the conversion rate of the LM95010 is
effected see Section 2.10 for further details.
0: Device in Active Mode. (default)
1: Device in Low-Power Mode.
Not supported.
Will always read "0".
EnF1 (Enable Function 1).
When bit is set to "1" this bit Function 1 is enabled for operation. A function may
require setup before this bit is set. The function registers can be accessed even when the function is
disabled.
0: Function 1 is disabled. (default)
1: Function is enabled.
Not supported.
Will always read "0".
2
R/W
3
4
RO
R/W
15-5
RO
2.9 TEMPERATURE MEASUREMENT FUNCTION (TYPE - 0001)
This section defines the register structure and operation of a Temperature Measurement function as it applies to the LM95010.
The FuncDescriptor value of this function is ‘0001’.
2.9.1 Operation
The Temperature Measurement function as implemented in the LM95010 supports one temperature zone, the LM95010’s internal
temperature (LM95010’s junction temperature). Since the LM95010 only supports one temperature measurement the Sensor
Scan function as defined in the SensorPath specification only applies to one temperature sensor. A temperature scan is enabled
by the SensorEnable bit (EN0). The minimum scan rate is recommended to be 4Hz (i.e. the measurement data is updated at least
once in 250 ms), see Section 2.10 for further details. In Low-Power Mode, the scan rate is four time lower than the scan rate in
Active Mode. The scan rate effects the bus bandwidth required to read the results. The sampling rate of the temperature
measurements can also be controlled via the Conversion Rate register, see Section 2.10 for further details.
Data Readout
When a new result is stored in the Readout register a Function Event is generated. Reading the Readout
register clears the Status Function 1 flag (SF1). The result is available in the Readout register waiting for the master to read it
during the master sensor read sequence. If a new result is ready before the previous result has been read, the new result
overwrites the previous result and the Error Function 1 flag (ERF1) is set (indicating an overrun event). Reading the Readout
register clears also the Error Function 1 flag (ERF1). The Readout register contains the temperature data, and the sensor number.
Since the LM95010 only supports one temperature zone the sensor number field will always report zero. Other fields in the
Readout register as defined by the SensorPath specification are not supported.
Readout Resolution
The resolution of the readout is defined in the Temperature Capabilities register. The resolution of the
LM95010 is fixed and cannot be modified by software.
Function Event
The Temperature Measurement function generates a Function Event whenever a temperature conversion
cycle is completed and new data is stored in the Readout Register. When the new data is stored into the Readout register the SF1
bit in the device Status register is set to "1" and remains set, until it is cleared by reading the Readout register. An Attention
Request is generated on the bus, only if it is enabled by the Attention Enable bit (ATE) in the Temperature Control register.
Setup Before Enabling
No setup is required for the Temperature Measurement function before the function is enabled.
2.9.2 Temperature Capabilities (Addr 10o)
Reg
Add
Register
Name
R/
W
P
O
R
Val
Bit
15
MSb
Bit
14
Bit
13
Bit
12
Bit
11
Bit
10
Bit
9
Bit
8
Bit
7
Bit
6
Bit
5
Bit
4
Bit
3
Bit
2
Bit
1
Bit
0
LSb
001 000
Temperature
Capabilities
R 014Ah
Reserved
Int
Sens
1
Rout
Size
0
Sign
10Bits
0.25C
Resolution
1
0
0
0
0
0
0
0
1
0
0
1
0
0
This register defines the format of the temperature data in the readout register. The LM95010 only supports one format as defined
by the values of this register.
L
www.national.com
15
相關PDF資料 |
PDF描述 |
|---|---|
| LM95071 | SPI/MICROWIRE⑩ 13-Bit Plus Sign Temperature Sensor |
| LM95071CIMFX | SPI/MICROWIRE⑩ 13-Bit Plus Sign Temperature Sensor |
| LM96000 | Hardware Monitor with Integrated Fan Control |
| LM96000CIMT | Hardware Monitor with Integrated Fan Control |
| LM96000CIMTX | Hardware Monitor with Integrated Fan Control |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM95010CIMM/NOPB | 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| LM95010CIMMX | 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| LM95010CIMMX/NOPB | 功能描述:板上安裝溫度傳感器 RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor |
| LM95010EVAL | 功能描述:溫度傳感器開發工具 LM95010 EVAL BOARD RoHS:否 制造商:Texas Instruments 產品類型:Temperature Sensors and Control ICs 工具用于評估:MSP430G2553 接口類型:USB 工作電源電壓: 工作電源電流: |
| LM95071 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:SPI/MICROWIRE⑩ 13-Bit Plus Sign Temperature Sensor |
發布緊急采購，3分鐘左右您將得到回復。