- 您現在的位置：買賣IC網 > PDF目錄361034 > LM81CIMTX-32 (National Semiconductor Corporation) Serial Interface ACPI-Compatible Microprocessor System PDF資料下載
參數資料
| 型號： | LM81CIMTX-32 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | Serial Interface ACPI-Compatible Microprocessor System |
| 中文描述： | 串行接口ACPI的兼容微處理器系統 |
| 文件頁數： | 22/32頁 |
| 文件大?。?/td> | 412K |
| 代理商： | LM81CIMTX-32 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Functional Description
(Continued)
T_CRIT_A interrupt is dedicated to temperature and is indi-
cated in Extended Mode Register 1. Extended Mode Regis-
ter 1 controls T_CRIT_A.
9.1 Interrupt Clearing
Reading a Status Register will output the contents of the
Register, and reset the Register. A subsequent read done
before the analog “round-robin” monitoring loop is complete
will indicate a cleared Register.Allow at least 820 ms to allow
all Registers to be updated between reads. In summary, the
Interrupt Status Register clears upon being read, and re-
quires at least 400 ms to be updated. When the Interrupt
Status Register clears, the hardware interrupt line will also
clear until the Registers are updated by the monitoring loop.
The hardware Interrupt line (INT) is cleared with the
INT_Clear bit, which is Bit 3 of the Configuration Register.
When this bit is high, the LM81 monitoring loop will stop. It
will resume when the bit is low.
10.0 RESET I/O
RESET is intended to provide a master reset to devices con-
nected to this line. INT Mask Register 2, Bit 7, must be set
high to enable this function. Setting Bit 4 in the Configuration
Register high outputs a least 20 ms low on this line, at the
end of which Bit 4 in the Configuration Register automatically
clears. Again, the label for this pin is only its suggested use.
In applications where the RESET capability is not needed it
can be used for any type of digital control that requires a 20
ms active low open-drain output.
RESET operates as an input when not activated by the Con-
figuration Register. Setting this line low will reset all of the
registers in the LM81 to their power on default state. All
Value RAM locations will not be affected except for the DAC
Data Register.
11.0 NAND TREE TESTS
A NAND tree is provided in the LM81 for Automated Test
Equipment (ATE) board level connectivity testing. DACOut/
NTEST_IN, T_CRIT_A, V
+
and GND pins are excluded from
NAND tree testing. Taking DACOut/NTEST_IN high before
the first write to the configuration register activates the
NAND Tree test mode. After the first write to the configura-
tion register the NAND Tree test mode cannot be reacti-
vated. To perform a NAND tree test all pins included in the
NAND tree should be driven to 1 forcing the A0/
NTEST_OUT high. Each individual pin starting with A1 and
concluding with SMBData (excluding DACOut/NTEST_IN,
T_CRIT_A, V
+
and GND) can be taken low with the resulting
toggle observed on the A0/NTEST_OUT pin. Allow for a typi-
cal propagation delay of 500 ns.
DS100072-29
www.national.com
22
相關PDF資料 |
PDF描述 |
|---|---|
| LM81 | Serial Interface ACPI-Compatible Microprocessor System |
| LM81CIMT-31 | Serial Interface ACPI-Compatible Microprocessor System |
| LM82CIMQAX | Remote Diode and Local Digital Temperature Sensor with Two-Wire Interface |
| LM82CIMQA | Remote Diode and Local Digital Temperature Sensor with Two-Wire Interface |
| LM82 | Remote Diode and Local Digital Temperature Sensor with Two-Wire Interface |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM81DH12 | 功能描述:基本/快動開關 Foot Switch RoHS:否 制造商:Omron Electronics 觸點形式:SPDT 執行器:Lever 電流額定值:5 A 電壓額定值 AC:250 V 電壓額定值 DC:30 V 功率額定值: 工作力:120 g IP 等級:IP 67 NEMA 額定值: 端接類型:Wire 安裝:Panel |
| LM8-1M.5M.1 | 制造商:Banner Engineering 功能描述:LM8-1M.5M.1 LOGIC MOD MULTIBM |
| LM81-S | 功能描述:基本/快動開關 Foot Switch RoHS:否 制造商:Omron Electronics 觸點形式:SPDT 執行器:Lever 電流額定值:5 A 電壓額定值 AC:250 V 電壓額定值 DC:30 V 功率額定值: 工作力:120 g IP 等級:IP 67 NEMA 額定值: 端接類型:Wire 安裝:Panel |
| LM81SH12 | 功能描述:基本/快動開關 Foot Switch RoHS:否 制造商:Omron Electronics 觸點形式:SPDT 執行器:Lever 電流額定值:5 A 電壓額定值 AC:250 V 電壓額定值 DC:30 V 功率額定值: 工作力:120 g IP 等級:IP 67 NEMA 額定值: 端接類型:Wire 安裝:Panel |
| LM82 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Remote Diode and Local Digital Temperature Sensor with Two-Wire Interface |
發布緊急采購，3分鐘左右您將得到回復。