參數資料
型號： LM81
廠商： National Semiconductor Corporation
英文描述： Serial Interface ACPI-Compatible Microprocessor System
中文描述： 串行接口ACPI的兼容微處理器系統
文件頁數： 17/32頁
文件大?。?/td> 412K
代理商： LM81
Functional Description
(Continued)
7.0 DAC OUTPUT
The LM81 provides an 8-bit DAC (Digital-to-Analog Con-
verter) with an output range of 0 to 1.25 volts (4.88 mV LSB).
This DAC can be used in any way, but in most applications of
the LM81 the DAC will be used for fan control. Typically the
DAC output would be amplified to provide the up to 12 volt
drive required by the fan. At power-on the DAC provides full
output, insuring that full fan speed is the default condition.
Care should be taken such that the analog circuitry tied to
this pin does not drive this pin above 2.5V. Doing so will
place the LM81 in NAND tree test mode which will make all
pins inputs, thus disabling any response from the LM81.
Fans do not start reliably at reduced voltages, so operation
at a reduced voltage should be preceded by a brief (typically
1 second) excursion to full operating voltage, then reduce
the voltage. Most fans do not operate at all below 5 to 7
volts. At those lower voltages the fan will simply consume
current, dissipate power, and not operate and such condi-
tions should be avoided.
The output of the amplifier can be configured to provide a
high or low side pass transistor. A high side pass transistor
simplifies the coupling of tachometer outputs to the tachom-
eter inputs of the LM81 since the fan remains grounded. Low
side drive will require AC coupling along with clamping at the
LM81 input to prevent negative excursions.
A typical circuit for fan drive is shown in Figure 8 R4 is used
when a negative power supply is available to eliminate offset
in the amplifier and provide a 0 to 11.5 volt output (actually
12 volts less saturation). Omitting R4 will create a “dead
zone” between approximately 0 to 6 volts output (a poten-
tially unusable region anyway). In many applications protect-
ing the pass transistor Q2 from faults such as a shorted fan
can be accomplished by taking advantage of the current limit
already existing on the 12 volt supply. Q2 will have to be
heat-sunk accordingly. Otherwise, use the suggested current
limit circuit as shown.
DS100072-28
FIGURE 8. Amplifier circuit for connection between DAC output and fan.
www.national.com
17
相關PDF資料
PDF描述
LM81CIMT-31 Serial Interface ACPI-Compatible Microprocessor System
LM82CIMQAX Remote Diode and Local Digital Temperature Sensor with Two-Wire Interface
LM82CIMQA Remote Diode and Local Digital Temperature Sensor with Two-Wire Interface
LM82 Remote Diode and Local Digital Temperature Sensor with Two-Wire Interface
LM8300HVA9 Four Wire Resistive Touchscreen Controller with Brownout
相關代理商/技術參數
參數描述
LM8-1 制造商:Banner Engineering 功能描述:Logic Module; Delayed One-Shot; ,Ranges For Banner Multi-Beam Sensor Blocks 制造商:Banner Engineering 功能描述:3-And 4-Wire Logic Modules
LM81_02 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Serial Interface ACPI-Compatible Microprocessor System Hardware Monitor
LM810 制造商:NSC 制造商全稱:National Semiconductor 功能描述:3-Pin Microprocessor Reset Circuits
LM810A-2.63 E WAF 制造商:Texas Instruments 功能描述:
LM810A-2.93 E WAF 制造商:Texas Instruments 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*