- 您現在的位置：買賣IC網 > PDF目錄385488 > LM5041 (National Semiconductor Corporation) Cascaded PWM Controller PDF資料下載
參數資料
| 型號： | LM5041 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | Cascaded PWM Controller |
| 中文描述： | 級聯PWM控制器 |
| 文件頁數： | 12/16頁 |
| 文件大?。?/td> | 343K |
| 代理商： | LM5041 |
Oscillator and Sync Capability
(Continued)
The buck stage will switch at the oscillator frequency and
each push-pull output will switch at half the oscillator fre-
quency in a push-pull configuration. The LM5041 can also
be synchronized to an external clock. The external clock
must have a higher frequency than the free running fre-
quency set by the RT resistor. The clock signal should be
capacitively coupled into the RT pin with a 100pF capacitor.
A peak voltage level greater than 3V is required for detection
of the sync pulse. The sync pulse width should be set in the
15 to 150ns range by the external components. The RT
resistor is always required, whether the oscillator is free
running or externally synchronized. The voltage at the RT pin
is internally regulated to 2V. The RT resistor should be
located very close to the device and connected directly to the
pins of the IC (RT and GND).
Slope Compensation
The PWM comparator compares the current sense signal to
the voltage at the COMP pin. The output stage of the internal
error amplifier generally drives the COMP pin. At duty cycles
greater than 50 percent, current mode control circuits are
subject to sub-harmonic oscillation. By adding an additional
fixed ramp signal (slope compensation) to the current sense
ramp, oscillations can be avoided. The LM5041 integrates
this slope compensation by buffering the internal oscillator
ramp and summing a current ramp generated by the oscil-
lator internally with the current sense signal. Additional slope
compensation may be provided by increasing the source
impedance of the current sense signal.
Soft-start and Shutdown
The soft-start feature allows the power converter to gradually
reach the initial steady state operating point, thereby reduc-
ing start-up stresses and surges. At power on, a 10uA cur-
rent is sourced out of the soft-start pin (SS) to charge an
external capacitor. The capacitor voltage will ramp up slowly
and will limit the maximum duty cycle of the buck stage. In
the event of a fault as indicated by V
CC
Under-voltage, line
Under-voltage or second level current limit, the output driv-
ers are disabled and the soft-start capacitor is discharged to
ground. When the fault condition is no longer present, a
soft-start sequence will begin again and buck stage duty
cycle will gradually increase as the soft-start capacitor is
charged. The SS pin also serves as an enable input. The
controller will enter a low power state if the SS pin is forced
below the 0.45V threshold.
Thermal Protection
Internal Thermal Shutdown circuitry is provided to protect the
integrated circuit in the event that the maximum junction
temperature is exceeded. When activated, typically at 165
degrees Celsius, the controller is forced into a low-power
standby state, disabling the output drivers and the bias
regulator. This feature is provided to prevent catastrophic
failures from accidental device overheating.
L
www.national.com
12
相關PDF資料 |
PDF描述 |
|---|---|
| LM5041MTC | Cascaded PWM Controller |
| LM5041MTCX | Cascaded PWM Controller |
| LM5041SD | Cascaded PWM Controller |
| LM5041SDX | Cascaded PWM Controller |
| LM5104 | High Voltage Half-Bridge Gate Driver with Adaptive Delay |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM5041A | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Cascaded PWM Controller |
| LM5041AMTC | 功能描述:電流型 PWM 控制器 RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| LM5041AMTC/NOPB | 功能描述:電流型 PWM 控制器 RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| LM5041AMTC-NOPB | 制造商:TI 制造商全稱:Texas Instruments 功能描述:LM5041A Cascaded PWM Controller |
| LM5041AMTCX | 功能描述:電流型 PWM 控制器 RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
發布緊急采購，3分鐘左右您將得到回復。