- 您現在的位置：買賣IC網 > PDF目錄296315 > LM4546BVH/NOPB (NATIONAL SEMICONDUCTOR CORP) LM4550 AC '97 Rev 2.1 Multi-Channel Audio Codec with Stereo Headphone Amplifier, Sample Rate Conversion and National 3D Sound; Package: LQFP; No of Pins: 48; Qty per Container: 250/Tray PDF資料下載
參數資料
| 型號： | LM4546BVH/NOPB |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 消費家電 |
| 英文描述： | LM4550 AC '97 Rev 2.1 Multi-Channel Audio Codec with Stereo Headphone Amplifier, Sample Rate Conversion and National 3D Sound; Package: LQFP; No of Pins: 48; Qty per Container: 250/Tray |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP48 |
| 封裝： | 7 X 7 MM, 1.40 MM HEIGHT, LQFP-48 |
| 文件頁數： | 17/27頁 |
| 文件大小： | 903K |
| 代理商： | LM4546BVH/NOPB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
Low Power Modes (Continued)
Improving System Performance
The audio codec is capable of dynamic range performance
in excess of 90 db., but the user must pay careful attention to
several factors to achieve this. A primary consideration is
keeping analog and digital grounds separate, and connect-
ing them together in only one place. Some designers show
the connection as a zero ohm resistor, which allows naming
the nets separately. Although it is possible to use a two layer
board, it is recommended that a minimum of four layers be
used, with the two inside layers being analog ground and
digital ground. If EMI is a system consideration, then as
many as eight layers have been successfully used. The 12
and 25 MHz. clocks can have significant harmonic content
depending on the rise and fall times. With the exception of
the digital VDD pins, (covered later) bypass capacitors
should be very close to the package. The analog VDD pins
should be supplied from a separate regulator to reduce
noise. By operating the digital portion on 3.3V instead of 5V,
an additional 0.5-0.7 db improvement can be obtained.
The bandgap reference and the anti-pop slow turn-on circuit
were improved in the LM4546B. A pullup resistor is not
required on V
REF, pin 27. For an existing design, the 10 k
resistor can be left on the pc board, but the temperature
coefficient will improve with no resistor on this pin. In addi-
tion, the THD will improve by 0.2–0.5 dB. The external
capacitor is charged by an internal current source, ramping
the voltage slowly. This results in slow turn-on of the audio
stages, eliminating “pops and clicks”. Thus, turn-on perfor-
mance is also improved. The pullup resistor, in conjunction
with the internal impedance and the external capacitor, form
a frequency dependent divider from the analog supply. Noise
on the analog supply will be coupled into the audio path, with
approximately 30 dB.of attenuation. Although this is not a
large amount if the noise on the supply is tens of millivolts, it
will prevent SNR from exceeding 80 dB.
In Figure 1 and Figure 2, the input coupling capacitors are
shown as 1 F. capacitors. This is only necessary for extend-
ing the response down to 20 Hz. for music applications. For
telematics or voice applications, the lower 3 dB. can be
much higher. Using a guaranteed input resistance of 10 k
,
(40 k
typical), a 0.1 F capacitor may be used. The lower 3
dB point will still be below 300 Hz. By using a smaller
capacitor, the package size may be reduced, leading to a
lower system cost.
Backwards Compatibility
The LM4546B is improved compared to the LM4546A. If it is
required to build a board that will use either part, a 10 k
resistor must be added from the V
REF pin (pin 27) to AVDD for
the LM4546A. It is not required for the LM4546B. Addition of
this resistor will slightly increase the temperature coefficient
of the internal bandgap reference and slightly decrease the
THD performance, but overall performance will still be better
than the LM4546A.
The LM4546A requires that pins 1 and 9 (DV
DD) connect
directly to a 27 nH. inductor before going to the 3.3 Volt
digital supply and bypass capacitors. The inductor is not
required for the LM4546B and should not be used.
Multiple Codecs
EXTENDED AC LINK
Up to four codecs can be supported on the extended AC
Link. These multiple codec implementations should run off a
common BIT_CLK generated by the Primary Codec. All
codecs share the AC ’97 Digital Controller output signals,
SYNC, SDATA_OUT, and RESET#. Each codec, however,
supplies its own SDATA_IN signal back to the controller, with
the result that the controller requires one dedicated input pin
per codec (Figure 9).
By definition there can be one Primary Codec and up to
three Secondary Codecs on an extended AC Link. The
Primary Codec has a Codec Identity = (ID1, ID0) = ID = 00
while Secondary Codecs take identities equal to 01, 10 or
11. The Codec Identity is used as a chip select function. This
allows the Command and Status registers in any of the
codecs to be individually addressed although the access
mechanism for Secondary Codecs differs slightly from that
for a Primary.
20123309
FIGURE 8. AC Link Powerdown Timing
LM4546B
www.national.com
24
相關PDF資料 |
PDF描述 |
|---|---|
| LM4549BVH/NOPB | LM4549B AC '97 Rev 2.1 Multi-Channel Audio Codec with Sample Rate Conversion and National 3D Sound; Package: LQFP; No of Pins: 48; Qty per Container: 250/Tray |
| LM4549BVHX/NOPB | LM4549B AC '97 Rev 2.1 Multi-Channel Audio Codec with Sample Rate Conversion and National 3D Sound; Package: LQFP; No of Pins: 48; Qty per Container: 1000/Reel |
| LM4550BVH/NOPB | LM4550B AC '97 Rev 2.1 Multi-Channel Audio Codec with Stereo Headphone Amplifier, Sample Rate Conversion and National 3D Sound; Package: LQFP; No of Pins: 48; Qty per Container: 250/Tray |
| LM4550BVHX/NOPB | LM4550B AC '97 Rev 2.1 Multi-Channel Audio Codec with Stereo Headphone Amplifier, Sample Rate Conversion and National 3D Sound; Package: LQFP; No of Pins: 48; Qty per Container: 1000/Reel |
| LM4562NA/NOPB | LM4562 Dual High Performance, High Fidelity Audio Operational Amplifier; Package: MDIP; No of Pins: 8; Qty per Container: 40/Rail |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM4546BVHX | 功能描述:接口—CODEC RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| LM4546BVHX/NOPB | 功能描述:接口—CODEC RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| LM4546VH | 制造商:Texas Instruments 功能描述:SPECIALTY CONSUMER CIRCUIT, PQFP48 |
| LM4547VH | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Soundcard Circuits |
| LM4548 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:AC ’97 Rev 2 Codec with Sample Rate Conversion and National 3D Sound |
發布緊急采購，3分鐘左右您將得到回復。