- 您現在的位置：買賣IC網 > PDF目錄385480 > LM3202TLX (NATIONAL SEMICONDUCTOR CORP) 650mA Miniature, Adjustable, Step-Down DC-DC Converter for RF Power Amplifiers PDF資料下載
參數資料
| 型號： | LM3202TLX |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 650mA Miniature, Adjustable, Step-Down DC-DC Converter for RF Power Amplifiers |
| 中文描述： | 1.2 A SWITCHING REGULATOR, 2300 kHz SWITCHING FREQ-MAX, BGA8 |
| 封裝： | LEAD FREE, MICRO SMD , 8 PIN |
| 文件頁數： | 4/15頁 |
| 文件大小： | 1507K |
| 代理商： | LM3202TLX |
System Characteristics
values in the typical application circuit are used.
These parameters are not guaranteed by production testing.
Min and
Max limits apply over the full operating ambient temperature range (30C
≤
T
≤
85C) and over the V
range = 2.7V to
5.5V unless otherwise specified, Typical values are at T
= 25C, PV
= V
= EN = 3.6V unless otherwise specified, L =
3.3μH, DCR of L
≤
100m
, C
IN
= 10μF, 0603, 6.3V (4.7μF||4.7μF, 0603, 6.3V can also be used), C
OUT
= 4.7μF, 0603, 6.3V
The following spec table entries are guaranteed by design providing the component
Symbol
T
RESPONSE
Time for V
OUT
to rise from
1.3V to 3.16V
Time for V
OUT
to fall from
3.16V to 1.3V
C
CON
V
CON
input capacitance
Parameter
Conditions
Min
Typ
Max
Units
V
IN
= 4.2V, C
OUT
= 4.7μF, L = 3.3μH,
R
LOAD
= 5
V
IN
= 4.2V, C
OUT
= 4.7μF, L = 3.3μH,
R
LOAD
= 10
V
CON
= 1V,
Test frequency = 100 kHz
V
IN
= 3.6V
Monotonic in nature
20
30
μs
20
30
20
pF
Linearity
Linearity in control
range 0.556V to 1.208V
Control pin input current
Turn on time
(time for output to reach
3.16V from Enable low to
high transition)
Efficiency
(L = 3.3μH, DCR
≤
100m
)
V
OUT
_ripple Ripple voltage, PWM mode
-3
+3
%
I
CON
T
_ON
-10
10
μA
EN = Low to High, V
IN
= 4.2V, V
O
= 3.16V,
C
OUT
= 4.7μF, I
OUT
≤
1mA
210
750
μs
η
V
IN
= 3.6V, V
OUT
= 1.3V, I
OUT
= 90mA
V
IN
= 3.6V, V
OUT
= 3.16V, I
OUT
= 400mA
V
IN
= 3V to 4.5V, V
OUT
= 1.3V, I
OUT
= 10mA
to 400mA (Note 12)
V
IN
= 600mV perturbance, over Vin range 3V
to 5.5V
T
RISE
= T
FALL
= 10μs, V
OUT
= 1.3V, I
OUT
=
100mA
V
IN
= 3.1/3.6/4.5V, V
OUT
= 1.3V, transients
up to 100mA, T
RISE
= T
FALL
= 10μs
sine wave perturbation
frequency = 10kHz, amplitude = 100mVp-p
87
96
%
%
10
mVp-p
Line_tr
Line transient response
50
mVpk
Load_tr
Load transient response
50
mVpk
PSRR
V
IN
= 3.6V, V
OUT
= 1.3V,
I
OUT
= 100mA
40
dB
Note 1:
Absolute Maximum Ratings indicate limits beyond which damage to the component may occur. Operating Ratings are conditions under which operation of
the device is guaranteed. Operating Ratings do not imply guaranteed performance limits. For guaranteed performance limits and associated test conditions, see the
Electrical Characteristics tables.
Note 2:
All voltages are with respect to the potential at the GND pins. The LM3202 is designed for mobile phone applications where turn-on after power-up is
controlled by the system controller and where requirements for a small package size overrule increased die size for internal Under Voltage Lock-Out (UVLO) circuitry.
Thus, it should be kept in shutdown by holding the EN pin low until the input voltage exceeds 2.7V.
Note 3:
Internal thermal shutdown circuitry protects the device from permanent damage. Thermal shutdown engages at T
J
= 150C (typ.) and disengages at T
J
=
130C (typ.).
Note 4:
The Human body model is a 100pF capacitor discharged through a 1.5k
resistor into each pin. (MIL-STD-883 3015.7) The machine model is a 200pF
capacitor discharged directly into each pin.
Note 5:
In applications where high power dissipation and/or poor package thermal resistance is present, the maximum ambient temperature may have to be
de-rated. Maximum ambient temperature (T
A-MAX
) is dependent on the maximum operating junction temperature (T
J-MAX-OP
= 125C), the maximum power
dissipation of the device in the application (P
D-MAX
), and the junction-to ambient thermal resistance of the part/package in the application (
θ
JA
), as given by the
following equation: T
A-MAX
= T
J-MAX-OP
– (
θ
JA
x P
D-MAX
).
Note 6:
Junction-to-ambient thermal resistance (
θ
JA
) is taken from thermal measurements, performed under the conditions and guidelines set forth in the JEDEC
standard JESD51-7. A 4 layer, 4" x 4", 2/1/1/2 oz. Cu board as per JEDEC standards is used for the measurements.
Note 7:
Min and Max limits are guaranteed by design, test, or statistical analysis. Typical numbers are not guaranteed, but do represent the most likely norm. Due
to the pulsed nature of the testing T
A
= T
J
for the electrical characteristics table.
Note 8:
The parameters in the electrical characteristics table are tested under open loop conditions at PV
IN
= V
DD
= 3.6V. For performance over the input voltage
range and closed loop results refer to the datasheet curves.
Note 9:
Shutdown current includes leakage current of PFET.
Note 10:
I
Q
specified here is when the part is operating at 100% duty cycle.
Note 11:
Current limit is built-in, fixed, and not adjustable. Refer to datasheet curves for closed loop data and its variation with regards to supply voltage and
temperature. Electrical Characteristic table reflects open loop data (FB = 0V and current drawn from SW pin ramped up until cycle by cycle limit is activated). Closed
loop current limit is the peak inductor current measured in the application circuit by increasing output current until output voltage drops by 10%.
Note 12:
Ripple voltage should measured at C
OUT
electrode on good layout PC board and under condition using suggested inductors and capacitors.
Note 13:
National Semiconductor recommends that all integrated circuits be handled with appropriate precautions. Failure to observe proper ESD handling
techniques can result in damage.
L
www.national.com
4
相關PDF資料 |
PDF描述 |
|---|---|
| LM3207 | 650mA Miniature, Adjustable, Step-Down DC-DC Converter for RF Power Amplifiers with Integrated Vref LDO |
| LM3207TL | 650mA Miniature, Adjustable, Step-Down DC-DC Converter for RF Power Amplifiers with Integrated Vref LDO |
| LM3207TLX | 650mA Miniature, Adjustable, Step-Down DC-DC Converter for RF Power Amplifiers with Integrated Vref LDO |
| LM3208 | 650mA Miniature, Adjustable, Step-Down DC-DC Converter for RF Power Amplifiers |
| LM3208TL | 650mA Miniature, Adjustable, Step-Down DC-DC Converter for RF Power Amplifiers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM3202TLX/NOPB | 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| LM3203 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Step-Down DC-DC Converter with Bypass Mode for CDMA / WCDMA RF Power Amplifiers |
| LM3203TL | 制造商:Texas Instruments 功能描述:CONVERTER BUCK 0.5A ADJ POWERWISE |
| LM3203TL/NOPB | 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| LM3203TLEV | 功能描述:電源管理IC開發工具 LM3203 EVAL BOARD RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
發布緊急采購，3分鐘左右您將得到回復。