參數(shù)資料
型號: LF11201D
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 多路復用及模擬開關
英文描述: Quad SPST JFET Analog Switches
中文描述: QUAD 1-CHANNEL, SGL POLE SGL THROW SWITCH, CDIP16
封裝: SIDE BRAZED, CERAMIC, DIP-16
文件頁數(shù): 9/18頁
文件大?。?/td> 416K
代理商: LF11201D
Application Hints
(Continued)
LEAKAGE CURRENTS
The drain and source leakage currents, in both the ON and
the OFF states of each switch, are typically less than 1 nA at
25C and less than 100 nA at 125C. As shown in the typical
curves, these leakage currents are Dependent on power
supply voltages, analog voltage, analog current and the
source to drain voltage.
DELAY TIMES
The delay time OFF (t
) is essentially independent of both
the analog voltage and temperature. The delay time ON
(t
) will decrease as either (V
CC
V
A
) decreases or the tem-
perature decreases.
POWER SUPPLIES
The voltage between the positive supply (V
) and either the
negative supply (V
) or the reference supply (V
) can be as
much as 36V. To accommodate variations in input logic refer-
ence voltages, V
can range from V
to (V
4.5V). Care
should be taken to ensure that the power supply leads for the
device never become reversed in polarity or that the device
is never inadvertently installed backwards in a test socket. If
one of these conditions occurs, the supplies would zener an
internal diode to an unlimited current; and result in a de-
stroyed device.
SWITCHING TRANSIENTS
When a switch is turned OFF or ON, transients will appear at
the load due to the internal transient voltage at the gate of
the switch JFET being coupled to the drain and source by
the junction capacitances of the JFET. The magnitude of
these transients is dependent on the load. A lower value R
L
produces a lower transient voltage. A negative transient oc-
curs during the delay time ON, while a positive transient oc-
curs during the delay time OFF. These transients are rela-
tively small when compared to faster switch families.
DISABLE NODE
This node can be used, as shown in Figure 5 to turn all the
switches in the unit off independent of logic inputs. Normally,
the node floats freely at an internal diode drop (
0.7V) above
V
. When the external transistor in Figure 5 is saturated, the
node is pulled very close to V
and the unit is disabled. Typi-
cally, the current from the node will be less than 1 mA. This
feature is not available on the LF11201 or LF11202 series.
Typical Applications
DS005667-6
FIGURE 5. Disable Function
Sample and Hold with Reset
DS005667-42
www.national.com
9
相關PDF資料
PDF描述
LF13508 8-Channel Analog Multiplexer
LF13508D 8-Channel Analog Multiplexer
LF13508M 8-Channel Analog Multiplexer
LF13508N 8-Channel Analog Multiplexer
LF13741 MONOLITHIC JFET INPUT OPERATIONAL AMPLIFIER
相關代理商/技術參數(shù)
參數(shù)描述
LF11201D/883 制造商:Rochester Electronics LLC 功能描述:- Bulk
LF11201D/883B 制造商:National Semiconductor 功能描述:11201
LF11201D883B 制造商:National Semiconductor 功能描述:11201
LF11202 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Quad SPST JFET Analog Switches
LF11202D 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Quad SPST JFET Analog Switches