- 您現在的位置：買賣IC網 > PDF目錄358759 > LC72349 (Sanyo Electric Co.,Ltd.) Low-Voltage ETR Controller with On-Chip LCD Driver PDF資料下載
參數資料
| 型號： | LC72349 |
| 廠商： | Sanyo Electric Co.,Ltd. |
| 英文描述： | Low-Voltage ETR Controller with On-Chip LCD Driver |
| 中文描述： | 低電壓東突控制器的片上LCD驅動器 |
| 文件頁數： | 9/14頁 |
| 文件大?。?/td> | 119K |
| 代理商： | LC72349 |
No. 6472-9/14
LC72348G/W, 72349G/W
Continued from preceding page.
Pin No.
Pin
I/O
Function
I/O circuit
System reset input.
In CPU operating mode or halt mode, applications must apply a low level for at least
one full machine cycle to reset the system and restart execution with the PC set to
location 0. This pin is connected in parallel with the internal power on reset circuit.
53
RES
I
Tuning voltage generation circuit outputs.
These pins include an n-channel transistor, and a tuning voltage can be generated by
connecting external coil, diode, and capacitor components.
FM DC-DC clock switching is a mask option.
54
TU
O
N-channel open-drain
FM VCO (local oscillator) input.
This pin is selected with the PLL instruction CW1.
The input must be capacitor coupled.
Input is disabled in backup mode, in halt mode, after a reset, and in PLL stop mode.
56
FMIN
I
CMOS amplifier input
AM VCO (local oscillator) input.
This pin and the bandwidth are selected with the PLL instruction CW1.
The input must be capacitor coupled.
Input is disabled in backup mode, in halt mode, after a reset, and in PLL stop mode.
57
AMIN
I
CMOS amplifier input
Main charge pump output. When the local oscillator frequency divided by N is higher
than the reference frequency a high level is output, when lower, a low level is output.
The pin is set to the high-impedance state when the frequencies match.
Output goes to the high-impedance state in backup mode, in halt mode, after a reset,
and in PLL stop mode.
59
EO
O
Transistor used for the low-pass filter amplifier.
Connect AGND to ground.
60
61
62
AIN
AOUT
AGND
O
Power supply pin.
This pin must be connected to ground.
This pin must be connected to ground.
This pin must be connected to V
DD
.
—
24
58
55
V
SS
V
SS
V
DD
—
CMOS push-pull
DC-DC clock
AM
AM local 1/2
FM
FM local 1/256 or 75 kHz
CW1 b1, b0
Bandwidth
1
1
0.5 to 10 MHz (MW, LW)
Note 2:
When a pin in an I/O switching port is used as an output, applications must first set up the data with an OUT, SPB, or RPB instruction and then set
up output mode with an IOS instruction.
相關PDF資料 |
PDF描述 |
|---|---|
| LC72349W | Low-Voltage ETR Controller with On-Chip LCD Driver |
| LC72349G | Low-Voltage ETR Controller with On-Chip LCD Driver |
| LC7234 | RESISTOR, 100 1% 1/8 |
| LC7234-8460 | Single-Chip PLL and Microcontroller with LCD Driver |
| LC72358N | Single-Chip PLL Microcontrollers(單片鎖相環微控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LC72349G | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Low-Voltage ETR Controller with On-Chip LCD Driver |
| LC72349W | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Low-Voltage ETR Controller with On-Chip LCD Driver |
| LC72358N | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Single-Chip PLL Microcontrollers |
| LC72362N | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Single-Chip PLL Microcontrollers |
| LC72362Y-9920N-E | 制造商:ON Semiconductor 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。