參數資料
型號: LC72134M
廠商: Sanyo Electric Co.,Ltd.
英文描述: Dual PLL Frequency Synthesizer for FM Tuner Systems(用于FM調諧器的雙鎖相環頻率合成器)
中文描述: 雙鎖相環頻率合成調頻調諧器系統(用于調頻調諧器的雙鎖相環頻率合成器)
文件頁數: 24/27頁
文件大?。?/td> 463K
代理商: LC72134M
No. 5814-24/27
LC72134M
Dead Zone
As shown in figure 1, the phase comparator compares a reference frequency (fr) with fp. As shown in figure 2, the phase
comparator’s characteristics consist of an output voltage (V) that is proportional to the phase difference . However, due
to internal circuit delay and other factors, an actual circuit has a region (the dead zone, B) where the circuit cannot
actually compare the phases. To implement a receiver with a high S/N ratio, it is desirable that this region be as small as
possible. However, it is often desirable to have the dead zone be slightly wider in popularly-priced models. This is
because in certain cases, such as when there is a strong RF input, popularly-priced models can suffer from mixer to VCO
RF leakage that modulates the VCO. When the dead zone is small, the circuit outputs signals to correct this modulation
and this output further modulates the VCO. This further modulation may then generate beats with the RF signal.
Notes on the FMIN, AMIN, and IFIN pins
Coupling capacitors should be placed as close to their pin as possible. A capacitance of about 100 pF is desirable for
these capacitors. In particular, if the IFIN pin coupling capacitor is not held to under 100 pF, the time to reach the bias
level may become too long and incorrect counts may result due to the relationship with the wait time.
Notes on IF counting
Use the SD signal in conjunction with IF counting
When counting the IF frequency, the microcontroller must determine the presence or absence of the IF IC SD (station
detect) signal and turn on the IF counter buffer output and execute the IF count only if there is an SD signal. Auto-
search techniques that only use the IF counter are subject to incorrect stopping at points where there is no station due to
IF buffer leakage.
DO pin usage
The DO pin can be used for IF counter count completion checking and as an unlock detection output in addition to its
use in data output mode. It is also possible to have the DO pin reflect the state of an input pin to input that state to the
microcontroller.
Power supply pins
A capacitor of at least 2000 pF must be inserted between the power supply V
DD
and V
SS
pins for noise exclusion. This
capacitor must be placed as close as possible to the V
DD
and V
SS
pins.
Figure 1
Figure 2
相關PDF資料
PDF描述
LC72135M PLL Frequency Synthesizer for Electronic Tuning(用于電子調諧的鎖相環頻率合成器)
LC72136N PLL Frequency Synthesizer for Electronic Tuning(用于電子調諧的鎖相環頻率合成器)
LC72136 PLL Frequency Synthesizer for Electronic Tuning(用于電子調諧的鎖相環頻率合成器)
LC72137 PLL Frequency Synthesizer for Electronic Tuning(用于電子調諧的鎖相環頻率合成器)
LC72140 PLL Frequency Synthesizer(鎖相環頻率合成器)
相關代理商/技術參數
參數描述
LC72135M 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:PLL Frequency Synthesizer for Electronic Tuning
LC72135MA-AE 功能描述:時鐘合成器/抖動清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
LC72135MA-Q-AE 制造商:ON Semiconductor 功能描述:PLL FREQUENCY SYNTHESIZER - Tape and Reel 制造商:ON Semiconductor 功能描述:REEL / PLL FREQUENCY SYNTHESIZER
LC72135M-Q-TLM-E 制造商:SANYO Semiconductor Co Ltd 功能描述:
LC72136 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:PLL Frequency Synthesizer for Electronic Tuning