- 您現在的位置：買賣IC網 > PDF目錄69003 > L6585DETR (STMICROELECTRONICS) POWER FACTOR CONTROLLER, PDSO20 PDF資料下載
參數資料
| 型號： | L6585DETR |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | POWER FACTOR CONTROLLER, PDSO20 |
| 封裝： | ROHS COMPLIANT, SOP-20 |
| 文件頁數： | 14/33頁 |
| 文件大?。?/td> | 2064K |
| 代理商： | L6585DETR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
L6585DE
Ballast section
21/33
6.3
Startup sequence with old or damaged lamps
When an old lamp is connected to the ballast the strike voltage is higher than the nominal
voltage and may also be higher than the safety threshold. In this case the lamp can ignite in
a time longer than ignition time or may not ignite. In both cases, during ignition time,
because of the frequency decrease, the voltage at the output of the ballast can easily reach
dangerous values.
The same occurs if the lamp tube is broken: the lamp cannot ignite and the lamp voltage
must be limited.
During ignition time, the L6585DE senses the current flowing into the lamp through a sense
resistor connected to the HBCS pin. If the HBCS pin voltage reaches 1.6 V, a small amount
of current is sunk from the EOI pin causing a small frequency increase. This frequency
modification results, macroscopically, in a frequency regulation and therefore a current
regulation and a lamp voltage limiting.
As soon as the HBCS pin voltage reaches 1.6 V, the TCH pin starts to charge Cd: when the
TCH voltage reaches 4.63 V, the TCH pin is no longer left free (as during preheating), but it
sinks 26 uA, causing a faster discharge of Cd. When the TCH voltage reaches 1.5 V, the pin
is pulled down and HBCS voltage is checked. If it is above 1.05 V the IC is stopped.
If the lamp ignites during this reduced TCH cycle, the EOI pin stops sinking current and if it
reaches 1.9 V, the IC enters run mode and TCH pin is immediately pulled down.
Figure 11.
Startup procedures with old or damaged lamps
It can be noted that the reduced TCH cycle time depends only on the value of Cd. It is
suggested to start from the choice of Cd in order to obtain the protection time, and then can
proceed to the choice of Rd to obtain the desired TPRE.
6
d
snk
,
Tch
source
,
Tch
d
reduced
,
Tch
10
26974
.
0
C
I
5
.
1
63
.
4
I
63
.
4
C
T
+
=
相關PDF資料 |
PDF描述 |
|---|---|
| L6598 | SWITCHING CONTROLLER, 400 kHz SWITCHING FREQ-MAX, PDIP16 |
| L6598D013TR | SWITCHING CONTROLLER, 400 kHz SWITCHING FREQ-MAX, PDSO16 |
| L6710 | 2 A SWITCHING CONTROLLER, PQFP44 |
| L6710TR | 2 A SWITCHING CONTROLLER, PQFP44 |
| L6713ATR | 2 A SWITCHING CONTROLLER, 225 kHz SWITCHING FREQ-MAX, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6585DTR | 功能描述:DC/DC 開關控制器 Combo IC RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| L6590 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:FULLY INTEGRATED POWER SUPPLY FIPS |
| L6590A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:FULLY INTEGRATED POWER SUPPLY |
| L6590AN | 功能描述:開關變換器、穩壓器與控制器 700 Volt Monolithic RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| L6590D | 功能描述:開關變換器、穩壓器與控制器 700 Volt Monolithic RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。