- 您現在的位置：買賣IC網 > PDF目錄377598 > L642DU12RE (Advanced Micro Devices, Inc.) 128 Megabit (8 M x 16-Bit) CMOS 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O⑩ Control PDF資料下載
參數資料
| 型號： | L642DU12RE |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | 128 Megabit (8 M x 16-Bit) CMOS 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O⑩ Control |
| 中文描述： | 128兆位（8米× 16位）的CMOS 3.0伏特，只有統一閃存部門與VersatileI /輸出⑩控制 |
| 文件頁數： | 25/54頁 |
| 文件大小： | 520K |
| 代理商： | L642DU12RE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁
May 5, 2006 25022A2
Am29LV642D
23
D A T A S H E E T
Hardware Data Protection
The command sequence requirement of unlock cycles
for programming or erasing provides data protection
against inadvertent writes (refer to Table 10 for com-
mand definitions). In addition, the following hardware
data protection measures prevent accidental erasure
or programming, which might otherwise be caused by
spurious system level signals during V
CC
power-up
and power-down transitions, or from system noise.
Low V
CC
Write Inhibit
When V
CC
is less than V
LKO
, the device does not ac-
cept any write cycles. This protects data during V
CC
power-up and power-down. The command register
and all internal program/erase circuits are disabled,
and the device resets to the read mode. Subsequent
writes are ignored until V
CC
is greater than V
LKO
. The
system must provide the proper signals to the control
pins to prevent unintentional writes when V
CC
is
greater than V
LKO
.
Write Pulse “Glitch” Protection
Noise pulses of less than 5 ns (typical) on OE#, CE#,
CE2#, or WE# do not initiate a write cycle.
Logical Inhibit
Write cycles are inhibited by holding any one of OE# =
V
IL
, CE# = V
IH
, CE2# = V
IH
or WE# = V
IH
. To initiate a
write cycle, CE# (or CE2#), and WE# must be a logical
zero while OE# is a logical one.
Power-Up Write Inhibit
If WE# = CE# = CE2# = V
IL
and OE# = V
IH
during
power up, the device does not accept commands on
the rising edge of WE#. The internal state machine is
automatically reset to the read mode on power-up.
COMMON FLASH MEMORY INTERFACE (CFI)
The Common Flash Interface (CFI) specification out-
lines device and host system software interrogation
handshake, which allows specific vendor-specified
software algorithms to be used for entire families of
devices. Software support can then be device-inde-
pendent, JEDEC ID-independent, and forward- and
backward-compatible for the specified flash device
families. Flash vendors can standardize their existing
interfaces for long-term compatibility.
The Am29LV642 is a two die solution which appears
as two 64 Mbit Am29LV640 devices in the system.
This allows the same CFI information to be used be-
cause the system “sees” two 64 Mbit devices, not a
single 128 Mbit device.
This device enters the CFI Query mode when the sys-
tem writes the CFI Query command, 98h, to address
55h anytime the device is ready to read array data.
The system can read CFI information at the addresses
given in Tables 6–9. To terminate reading CFI data,
the system must write the reset command.
The system can also write the CFI query command
when the device is in the autoselect mode. The device
enters the CFI query mode, and the system can read
CFI data at the addresses given in Tables 6–9. The
system must write the reset command to return the
device to the autoselect mode.
For further information, please refer to the CFI Specifi-
cation and CFI Publication 100, available via the World
Wide Web at http://www.amd.com/products/nvd/over-
view/cfi.html. Alternatively, contact an AMD represen-
tative for copies of these documents.
Table 6. CFI Query Identification String
Addresses (x16)
Data
Description
10h
11h
12h
0051h
0052h
0059h
Query Unique ASCII string “QRY”
13h
14h
0002h
0000h
Primary OEM Command Set
15h
16h
0040h
0000h
Address for Primary Extended Table
17h
18h
0000h
0000h
Alternate OEM Command Set (00h = none exists)
19h
1Ah
0000h
0000h
Address for Alternate OEM Extended Table (00h = none exists)
相關PDF資料 |
PDF描述 |
|---|---|
| L642DU90RI | 128 Megabit (8 M x 16-Bit) CMOS 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O⑩ Control |
| L642DU12RI | 128 Megabit (8 M x 16-Bit) CMOS 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O⑩ Control |
| L64360 | Highly Integrated ATM Segmentation and Reassembly (SAR) Engine optimized for internetworking applications(用于優化網絡的高度集成的異步傳輸模式-分段和重組處理芯片) |
| L64364 | Highly Integrated ATM Segmentation and Reassembly (SAR) Engine optimized for internetworking applications(用于優化網絡的高度集成的異步傳輸模式-分段和重組處理芯片) |
| L64381 | 4-Port Ethernet Controller(四端口以太網控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L642DU12RI | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:128 Megabit (8 M x 16-Bit) CMOS 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O⑩ Control |
| L642DU90RI | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:128 Megabit (8 M x 16-Bit) CMOS 3.0 Volt-only Uniform Sector Flash Memory with VersatileI/O⑩ Control |
| L642F | 制造商:CRYDOM 制造商全稱:Crydom Inc., 功能描述:Power Modules |
| L643 | 制造商:CRYDOM 制造商全稱:Crydom Inc., 功能描述:Power Modules |
| L64324 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:L64324 Intelligent Ethernet Switch |
發布緊急采購，3分鐘左右您將得到回復。