- 您現在的位置：買賣IC網 > PDF目錄383234 > L4992 (意法半導體) TRIPLE OUTPUT POWER SUPPLY CONTROLLER PDF資料下載
參數資料
| 型號： | L4992 |
| 廠商： | 意法半導體 |
| 英文描述： | TRIPLE OUTPUT POWER SUPPLY CONTROLLER |
| 中文描述： | 三路輸出電源控制器 |
| 文件頁數： | 11/26頁 |
| 文件大?。?/td> | 296K |
| 代理商： | L4992 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
+5 V LINEAR REGULATOR & +3.3 V REFERENCE VOLTAGE GENERATOR
This low drop-out regulator powers almost all the internal circuitry, that is the +3.3V reference voltage
generator, amplifiers, comparators, digital logic, and MOSFET drivers. Its output is externally available
through pin REG5.
The typical external use of this generator is to charge the bootstrap capacitors used to produce the gate-
drive voltage for the high-side MOSFET’s of both PWM converters.
At start-up and when the 5V section is not operating, this regulator is powered by the chip input voltage.
To reduce power consumption, the linear regulator is turned off and the REG5 pin is internally connected
to the 5V PWM regulator output via V5SW pin, when the 5V PWM regulator is active and its output volt-
age is above the switchover threshold, 4.5V.
The 5V regulator is always active, even if both PWM regulators are disabled, as long as power is applied
to the chip.
The 3.3V reference voltage generator, which is active only when either PWM converter is enabled, pro-
vides comparison levels for threshold detection and device operation. It is allowed to source up to 5mA
to an external load from its buffered output, externally available through pin VREF.
If either REG5 or VREF does not deliver the correct voltage, the device is shut down.
POWER MANAGEMENT
The L4992 is provided with some control pins suitable to perform some functions which are commonly
used or sometimes required in battery-operated equipment. Besides, it features controlled timing se-
quences in case of turn-on/off and device shutdown for a safe and reliable behaviour under all condi-
tions.
As above mentioned, RUN3 and RUN5 pins allow to disable separately both PWM converters by means
of logic signals (likely coming from a
μ
P) as mentioned earlier.
NOSKIP can disable the pulse-skipping feature: when it is held high neither of the PWM regulators is al-
lowed to enter this kind of operation.
The PWROK output signal drives low immediately when either PWM regulator output falls below its own
undervoltage threshold or when either of them is disabled. It is high when both regulator run properly.
A capacitor connected between CRST and ground fixes a time, in the order of 2ms/nF, which delays the
transition low-high of PWROK. This happens at start-up or after recovering an undervoltage condition,
provided both RUN3 and RUN5 are high. The delay starts from the moment in which the output voltage
has reached its correct value for both sections.
The same delay intervenes also in another circumstance: when a section is disabled (because its RUN is
driven low or owing to a thermal shutdown), the relevant synchronous rectifier is turned on after the
above delay in order to make sure that the load is no longer supplied.
This delay, however, does not intervene in case of overvoltage: the synchronous rectifier is immediately
turned on after the shutdown, thus acting as a built-in "crowbar".
All these timing sequences are illustrated in Fig 7.
DETAILED FUNCTIONAL DESCRIPTION
(continued)
L4992
11/26
相關PDF資料 |
PDF描述 |
|---|---|
| L5170 | CAP CER 47000PF 50V X7R 0805 |
| L5170A | OCTAL LINE DRIVER |
| L5170D | OCTAL LINE DRIVER |
| L5510 | HIGHLY INTEGRATED, AUTOMATED SINGLE-CHIP DRIVE MANAGER AND DISK DRIVE CONTROLLER |
| L584 | MULTIFUNCTION INJECTION INTERFACE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L4993 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low drop voltage regulator |
| L4993D | 功能描述:低壓差穩壓器 - LDO Low drop voltage regulator RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| L4993DTR | 功能描述:低壓差穩壓器 - LDO Low drop voltage regulator RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| L4993MD | 功能描述:低壓差穩壓器 - LDO Low drop voltage regulator RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| L4993MDTR | 功能描述:低壓差穩壓器 - LDO 5V 150mA LW DROP VLT REGULATOR RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。