- 您現在的位置：買賣IC網 > PDF目錄11573 > KSZ8841-16MBLI (Micrel Inc)IC MAC CTRLR 8/16BIT 100-LBGA PDF資料下載
參數資料
| 型號： | KSZ8841-16MBLI |
| 廠商： | Micrel Inc |
| 文件頁數： | 7/105頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MAC CTRLR 8/16BIT 100-LBGA |
| 標準包裝： | 260 |
| 控制器類型： | 以太網控制器，MAC |
| 接口： | 總線 |
| 電源電壓： | 3.1 V ~ 3.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-LBGA |
| 供應商設備封裝： | 100-LFBGA |
| 包裝： | 散裝 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁
Micrel, Inc.
KSZ8841-16/32 MQL/MVL/MBL
October 2007
104
M9999-102207-1.6
Acronyms and Glossary
BIU
Bus Interface Unit
The host interface function that performs code conversion, buffering,
and the like required for communications to and from a network.
BPDU
Bridge Protocol Data Unit
A packet containing ports, addresses, etc. to make sure data being
passed through a bridged network arrives at its proper destination.
CMOS
Complementary Metal Oxide Semiconductor
A common semiconductor manufacturing technique in which positive
and negative types of transistors are combined to form a current gate
that in turn forms an effective means of controlling electrical current
through a chip.
CRC
Cyclic Redundancy Check
A common technique for detecting data transmission errors. CRC for
Ethernet is 32 bits long.
Cut-through switch
A switch typically processes received packets by reading in the full
packet (storing), then processing the packet to determine where it
needs to go, then forwarding it. A cut-through switch simply reads in
the first bit of an incoming packet and forwards the packet. Cut-
through switches do not store the packet.
DA
Destination Address
The address to send packets.
DMA
Direct Memory Access
A design in which memory on a chip is controlled independently of
the CPU.
EEPROM
Electronically Erasable Programmable Read-only Memory
A design in which memory on a chip can be erased by exposing it to
an electrical charge.
EISA
Extended Industry Standard Architecture
A bus architecture designed for PCs using 80x86 processors, or an
Intel 80386, 80486 or Pentium microprocessor. EISA buses are 32
bits wide and support multiprocessing.
EMI
Electro-Magnetic Interference
A naturally occurring phenomena when the electromagnetic field of
one device disrupts, impedes or degrades the electromagnetic field of
another device by coming into proximity with it. In computer
technology, computer devices are susceptible to EMI because
electromagnetic fields are a byproduct of passing electricity through a
wire. Data lines that have not been properly shielded are susceptible
to data corruption by EMI.
FCS
Frame Check Sequence
See CRC.
FID
Frame or Filter ID
Specifies the frame identifier. Alternately is the filter identifier.
IGMP
Internet Group Management Protocol
The protocol defined by RFC 1112 for IP multicast transmissions.
IPG
Inter-Packet Gap
A time delay between successive data packets mandated by the
network standard for protocol reasons. In Ethernet, the medium has
to be "silent" (i.e., no data transfer) for a short period of time before a
node can consider the network idle and start to transmit. IPG is used
to correct timing differences between a transmitter and receiver.
During the IPG, no data is transferred, and information in the gap can
be discarded or additions inserted without impact on data integrity.
ISI
Inter-Symbol Interference
The disruption of transmitted code caused by adjacent pulses
affecting or interfering with each other.
ISA
Industry Standard Architecture
A bus architecture used in the IBM PC/XT and PC/AT.
Jumbo Packet
A packet larger than the standard Ethernet packet (1500 bytes).
Large packet sizes allow for more efficient use of bandwidth, lower
overhead, less processing, etc.
MDI
Medium Dependent Interface
An Ethernet port connection that allows network hubs or switches to
connect to other hubs or switches without a null-modem, or
crossover, cable. MDI provides the standard interface to a particular
media (copper or fiber) and is therefore 'media dependent.'
相關PDF資料 |
PDF描述 |
|---|---|
| KSZ8842-16MVL | IC ETHERNET SW 2PORT BUS 128LQFP |
| V300A12C400BL3 | CONVERTER MOD DC/DC 12V 400W |
| PIC16F687-E/P | IC PIC MCU FLASH 2KX14 20DIP |
| V300A12C400B3 | CONVERTER MOD DC/DC 12V 400W |
| V300A12C400B2 | CONVERTER MOD DC/DC 12V 400W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8841-16MQL | 功能描述:以太網 IC Single Ethernet Port + Generic (8, 16-bit) bus interface( Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8841-16MQL A6 | 功能描述:IC MAC CTRLR 8/16BIT 128-PQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| KSZ8841-16MQL-EVAL | 功能描述:以太網開發工具 KSZ8841-16MQL Evaluation Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
| KSZ8841-16MVL | 功能描述:以太網 IC Single Ethernet Port + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8841-16MVL TR | 功能描述:以太網 IC Single Ethernet Port + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。