- 您現在的位置：買賣IC網 > PDF目錄360998 > ISP1161A (NXP Semiconductors N.V.) Full-speed Universal Serial Bus single-chip host and device controller PDF資料下載
參數資料
| 型號： | ISP1161A |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Full-speed Universal Serial Bus single-chip host and device controller |
| 中文描述： | 全速通用串行總線的單芯片主機和設備控制器 |
| 文件頁數： | 12/134頁 |
| 文件大?。?/td> | 587K |
| 代理商： | ISP1161A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁
Philips Semiconductors
ISP1161A
Full-speed USB single-chip host and device controller
Product data
Rev. 03 — 23 December 2004
12 of 134
9397 750 13962
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
7.6 GoodLink
Indication of a good USB connection is provided at pin GL through GoodLink
technology. During enumeration, the LED indicator will blink on momentarily. When
the DC has been successfully enumerated (the device address is set), the LED
indicator will remain permanently on. Upon each successful packet transfer (with
ACK) to and from the ISP1161A the LED will blink off for 100 ms. During ‘suspend’
state the LED will remain off.
This feature provides a user-friendly indication of the status of the USB device, the
connected hub and the USB traffic. It is a useful field diagnostics tool for isolating
faulty equipment. It can therefore help to reduce field support and hotline overhead.
8.
Microprocessor bus interface
8.1 Programmed I/O (PIO) addressing mode
A generic PIO interface is defined for speed and ease-of-use. It also allows direct
interfacing to most microcontrollers. To a microcontroller, the ISP1161A appears as a
memory device with a 16-bit data bus and uses only two address lines: A1 and A0 to
access the internal control registers and FIFO buffer RAM. Therefore, the ISP1161A
occupies only four I/O ports or four memory locations of a microprocessor. External
microprocessors can read from or write to the ISP1161A internal control registers and
FIFO buffer RAM through the Programmed I/O (PIO) operating mode.
Figure 8
shows
the Programmed I/O interface between a microprocessor and an ISP1161A.
8.2 DMA mode
The ISP1161A also provides DMA mode for external microprocessors to access its
internal FIFO buffer RAM. Data can be transferred by DMA operation between a
microprocessor’s system memory and the ISP1161A internal FIFO buffer RAM.
Remark:
The DMA operation must be controlled by the external microprocessor
system DMA controller (Master).
Fig 8.
Programmed I/O interface between a microprocessor and an ISP1161A.
004aaa086
D[15:0]
RD
WR
CS
A2
IRQ2
MICRO-
PROCESSOR
ISP1161A
D[15:0]
μ
P bus I/F
RD
WR
CS
A1
A1
IRQ1
A0
INT1
INT2
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1161ABD | Full-speed Universal Serial Bus single-chip host and device controller |
| ISP1161ABM | Full-speed Universal Serial Bus single-chip host and device controller |
| ISP1161 | Full-speed Universal Serial Bus single-chip host and device controller |
| ISP1161A1 | Universal Serial Bus single-chip host and device controller |
| ISP1161A1BD | Universal Serial Bus single-chip host and device controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1161A1 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus single-chip host and device controller |
| ISP1161A1BD | 功能描述:IC USB HOST/DEVICE CTRLR 64-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| ISP1161A1BD,118 | 功能描述:USB 接口集成電路 USB1.1 HOST &DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1161A1BD,151 | 功能描述:USB 接口集成電路 USB1.1 HOST &DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1161A1BD,157 | 功能描述:USB 接口集成電路 DO NOT USE ORDER -S OR -T PART RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
發布緊急采購，3分鐘左右您將得到回復。