- 您現在的位置：買賣IC網 > PDF目錄296253 > ISL6412IR (INTERSIL CORP) Hex Inverters 14-SOIC -40 to 85 PDF資料下載
參數資料
| 型號： | ISL6412IR |
| 廠商： | INTERSIL CORP |
| 元件分類： | 固定正電壓多路輸出LDO穩壓器 |
| 英文描述： | Hex Inverters 14-SOIC -40 to 85 |
| 中文描述： | TRIPLE OUTPUT, FIXED POSITIVE LDO REGULATOR, PQCC16 |
| 封裝： | 4 X 4 MM, PLASTIC, MO-220VGGC, QFN-16 |
| 文件頁數： | 9/10頁 |
| 文件大小： | 199K |
| 代理商： | ISL6412IR |
8
FN9067.1
March 20, 2007
pin also goes LOW during thermal shutdown or an
overcurrent event on LDO1. Connect this pin to GND, if
unused.
RESET - This pin is the active-LOW output of the push-pull
output stage of the integrated reset supervisory circuit. The
reset circuit monitors VIN and asserts a RESET output at this
pin, if VIN falls below the RESET threshold. The RESET
output remains LOW, while the VIN pin voltage is below the
reset threshold, and for at least 25ms, after VIN rises above
the RESET threshold.
Functional Description
The ISL6412 is a 3-in-1 multi-output, low dropout, regulator
designed for wireless chipset power applications. It supplies
three fixed output voltages 1.8V, 2.8V and 2.8V. Each LDO
consists of a 1.2V reference, error amplifier, MOSFET driver,
P-Channel pass transistor, dual-mode comparator and
internal feedback voltage divider.
The 1.2V band gap reference is connected to the error
amplifier’s inverting input. The error amplifier compares this
reference to the selected feedback voltage and amplifies the
difference. The MOSFET driver reads the error signal and
applies the appropriate drive to the P-Channel pass transistor.
If the feedback voltage is lower then the reference voltage, the
pass transistor gate is pulled lower, allowing more current to
pass and increasing the output voltage. If the feedback
voltage is higher then the reference voltage, the pass
transistor gate is driven higher, allowing less current to pass to
the output. The output voltage is fed back through an internal
resistor divider connected to OUT1/OUT2/OUT3 pins.
Additional blocks include an output overcurrent protection,
thermal sensor, fault detector, RESET function and
shutdown logic.
Internal P-Channel Pass Transistors
The ISL6412 features a typical 0.5
Ω r
DS(ON) P-channel
MOSFET pass transistors. This provides several advantages
over similar designs using PNP bipolar pass transistors. The
P-Channel MOSFET requires no base drive, which reduces
quiescent current considerably. PNP based regulators waste
considerable current in dropout when the pass transistor
saturates. They also use high base drive currents under
large loads. The ISL6412 does not suffer from these
problems.
Integrated Reset for MAC/Baseband Processors
The ISL6412 includes a microprocessor supervisory block.
This block eliminates the extra reset IC and external
components needed in wireless chipset applications. This
block performs a single function; it asserts a RESET signal
whenever the VIN supply voltage decreases below a preset
threshold, keeping it asserted for a programmable time (set
by external capacitor CT) after the VIN pin voltage has risen
above the reset threshold. The reset threshold for the
ISL6412 is 2.63V typical.
The voltage at the CT pin is compared to the 1.2V bandgap
voltage. The charging of the CT capacitor behaves like an
RC network and the RESET delay can be approximated by:
Td = -R*C*ln(1-1.2V/VIN)
Where C is the capacitor at CT, and R is 11.1M
Ω for
VIN = 3.3V. With no capacitor on the CT pin the RESET
delay will be close to zero. Figure 12 shows the RESET
delay vs CT capacitance.
Output Voltages
The ISL6412 provides fixed output voltages for use in
Wireless Chipset applications. Internal trimmed resistor
networks set the typical output voltages as shown here:
VOUT1 = 1.8V; VOUT2 = 2.8V; VOUT3 = 2.8V.
Shutdown
Pulling the SHDN pin LOW puts the complete chip into
shutdown mode, and supply current drops to 5
μA typical.
This input has an internal pull-up resistor, so that in normal
operation the outputs are always enabled; external pull-up
resistors are not required.
Current Limit
The ISL6412 monitors and controls the pass transistor’s
gate voltage to limit the output current. The current limit for
LDO1 is 500mA, LDO2 is 330mA and LDO3 is 300mA. The
output can be shorted to ground without damaging the part
due to the current limit and thermal protection features.
FIGURE 12. RESET DELAY vs CT CAPACITANCE
0
100
200
300
400
500
0
0.01
0.02
0.03
0.04
0.05
0.06
0.07
0
CT (F)
DELA
Y
(
m
s)
ISL6412
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6412 | Hex Inverters 14-SSOP -40 to 85 |
| ISL6430 | Single Sync Buck PWM Controller for Broadband Gateway Applications |
| ISO120SG | Precision Low Cost ISOLATION AMPLIFIER |
| ISO120SGQ | Precision Low Cost ISOLATION AMPLIFIER |
| ISTPCH4MBLY | INTERCONNECTION DEVICE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6412IR-T5K | 功能描述:IC REG LDO 1.8V/2.8V/2.8V 16-QFN RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:3,000 系列:- 穩壓器拓?fù)浣Y(jié)構:正，可調式 輸出電壓:1.2 V ~ 5.5 V 輸入電壓:1.7 V ~ 5.5 V 電壓 - 壓降（標準）:0.075V @ 400mA 穩壓器數量:1 電流 - 輸出:400mA（最小值） 電流 - 限制（最?。?400mA 工作溫度:-55°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:帶卷 (TR) 其它名稱:296-20789-2V62/06626-01XE |
| ISL6412IR-TK | 功能描述:IC REG LDO 1.8V/2.8V/2.8V 16-QFN RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:3,000 系列:- 穩壓器拓?fù)浣Y(jié)構:正，可調式 輸出電壓:1.2 V ~ 5.5 V 輸入電壓:1.7 V ~ 5.5 V 電壓 - 壓降（標準）:0.075V @ 400mA 穩壓器數量:1 電流 - 輸出:400mA（最小值） 電流 - 限制（最?。?400mA 工作溫度:-55°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:帶卷 (TR) 其它名稱:296-20789-2V62/06626-01XE |
| ISL6412IRZ | 功能描述:低壓差穩壓器 - LDO VER OF ISL6412IR RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| ISL6412IRZ-TK | 功能描述:低壓差穩壓器 - LDO VER OF ISL6412IR-T 1 000 PC RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| ISL6413EVAL1 | 功能描述:EVALUATION BOARD ISL6413 RoHS:否 類別:編程器，開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像，彩色（RGB） 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
發布緊急采購，3分鐘左右您將得到回復。